Digital Acoustics IP7-SE8 Bedienungsanleitung

SE8 GETTING STARTED

IP Intercom/Paging

IP7-SE8

Getting Started Guide

Introduction

The IP7-SE8 IP Intercom/Paging endpoint provides high

quality 2-way audio from TalkMaster™ software over an IP

network. The internal audio amplifier can drive a maximum of

8 watts to one or more speakers. It supports a Talk switch

and includes a Relay, a Door Sensor and an integrated

2-port switch. Powers options include Power Over Ethernet

(PoE - 802.3af compatible) and external 12-15VDC

This Getting Started booklet covers basic hardware

installation and software configuration of the IP7-SE8.

Table of Contents

IP7-SE8 Installation..................................................2

TalkMaster-LE Software...........................................7

IP7-SE8

Installation

Important Installation Guidelines

• Choose 18-22 AWG wire for speaker connections. Select

wire gauge suited to minimize power loss for specific

distribution method and wire run distances

• Do not install near power distribution equipment or noise

generating equipment such as stepper motors

• Conform to industry standard practices for grounding

• Use shielded, twisted pair wire for microphone signals.

Avoid sharing AC power and audio signals in conduit runs

Please refer to the IP7-SE8 Reference Manual

available on the TALKMASTER SOFTWARE CD

for additional information on installation and setup

IP7-SE8 Installation (2-way Intercom/Paging mode)

Relay Output(Optional)

Cat-5Cableto

PoEHub/Switch

Optional

12VDC -15VDC

2 Conductor Wire

6 Conductor Wire

18-22 AWG

Twisted Shielded

Sensor Input (Optional)

2 Conductor Wire

(NoConnection)

• Connect SPKR 8Ω+(J2-6) and SPKR 8Ω-(J2-7) to the

terminals of an 8 ohm speaker (polarity independent)

• Connect MIC + (J2-1) and MIC - (J2-2) to an Electret

Microphone, or Connect MIC + (J2-1) and MIC - (J2-2)

and GND (J2-4) to a Dynamic Microphone

• Connect TALK (J2-5) and GND (J2-4) to a switch

pushbutton

• Connect GND (J2-4) to the shield of the shielded wire

(leave open at door station)

Cat-5 Cable to

PoE Hub/Switch

IP7-SE8 Wiring (2-way Intercom/Paging mode)

Talk Button

Speaker

Connection

J2 J3

Microphone

IP7-SE8 Installation (Paging Mode Only, 8 Ohm Speaker)

Cat-5Cable to PoE

Hub/Switch

Optional

12VDC -15VDC*

2 Conductor Wire 18-22 AWG

• Connect SPKR 8Ω+ and SPKR 8Ω- (J2-6 and J2-7) to the

terminals of an 8 ohm speaker (polarity independent)

Cat-5 Cable to

PoE Hub/Switch

Relay Options

• An integrated Relay uses J3-2, with J3-1 (Normally Open)

or J3-3 (Normally Closed). Use TalkMaster™ to configure

the options

Sensor Options

• The integrated Sensor can be used to monitor the status

of a door by connecting J3-5 and J3-6 to a contact closure

sense switch. Use TalkMaster™ to configure the options

Power Options

Use one of the following methods for powering the IP7

device:

• Power over Ethernet (PoE - 802.3af compliant) - requires

15.4 Watts from Power Source Equipment (PSE)

• 12VDC - 15VDC at 15 watts via J1-1 and J1-2 connectors

(polarity independent)

• 12VDC -15VDC at 15 watts via the Aux Power 2.1mm

barrel connector

An external power supply, if detected, overrides PoE power

Network Installation

• Connect an RJ-45 cable between the Ethernet 10/100

connector and a network switch or directly to a PC for

configuration

• After the Ethernet 10/100 is connected, another IP device

can be connected to Port 2 10/100

Mounting Instructions

The IP7 series is design to be mounted on standard 35mm

DIN rail or surface mounted using the optional surface

mounting plate.

• DIN Rail Clip – Tilt top of unit (J1, J2 connectors facing up

with Volume buttons facing forward) back towards the DIN

Rail until the IP7-SE8 DIN clip catches the top of the rail.

Press in at the bottom of the IP7-SE8 to snap into place.

• Surface Mount Plate – Snap the optional surface mount

plate in half and secure it to the back of the frame using

the provided screws so that the mounting holes extend

past the edges of the case

TalkMaster™ LE Software is a Windows® application used

to configure and manage Digital Acoustics IP7™ and ii3™

Intercoms and Paging endpoints. Primary functions include

user controls for inbound/outbound calls and paging. An

integrated configuration utility is also included to set Options

and IP Addresses for individual endpoints.

TalkMaste

™LE

Prepare for Intercom Configuration

• Refer to the previous section to power up and connect the

IP7 series device to the network.

• Record the unique ID# from the bottom of the Intercom (or

Paging) endpoint(s) and note the location where it will be

installed

• Install the TalkMaster Software using the Digital Acoustics’

Software CD, or online at www.digitalacoustics.com

Please refer to the TalkMaster Reference Manual

on the TALKMASTER SOFTWARE CD for

additional information on installation and software

Andere Handbücher für IP7-SE8

Inhaltsverzeichnis

Andere Digital Acoustics Gegensprechanlage Handbücher

Digital Acoustics

Digital Acoustics TalkMaster FOCUS Bedienungsanleitung

Digital Acoustics

Digital Acoustics IP7 Desktop Bedienungsanleitung

Digital Acoustics

Digital Acoustics IP7-MSR-BRD Bedienungsanleitung

Digital Acoustics

Digital Acoustics PNL-CIS4-DA Bedienungsanleitung

Digital Acoustics

Digital Acoustics INT-IP-2GANG Bedienungsanleitung

Digital Acoustics

Digital Acoustics IP7-FD Bedienungsanleitung

Digital Acoustics

Digital Acoustics EDB-110 Bedienungsanleitung

Digital Acoustics

Digital Acoustics IP7-FX Bedienungsanleitung

Digital Acoustics

Digital Acoustics INT-IP-2GANG Bedienungsanleitung

Beliebte Gegensprechanlage Handbücher anderer Marken

Bticino

Bticino LINEA 3000 Bedienungsanleitung

MSI

MSI MSI-140 Bedienungsanleitung

golmar

golmar Stadio Plus Bedienungsanleitung

CyberData

CyberData 011211 series Handbuch

Vidos

Vidos duo M1021 Bedienungsanleitung

Vimar

Vimar ELVOX 7539/E Bedienungsanleitung

SSS Siedle

SSS Siedle BTSV 850-03 Bedienungsanleitung

Dahua

Dahua VTO Series Bedienungsanleitung

Elvox

Elvox 5651 Bedienungsanleitung

Videx

Videx VIDEOKIT Series Bedienungsanleitung

Safeguard Supply

Safeguard Supply LRA-EX1000 Bedienungsanleitung

SSS Siedle

SSS Siedle BFCV 850 Series Bedienungsanleitung

GRD

GRD MAX V2 Bedienungsanleitung

Alecto

Alecto ADI-250 Bedienungsanleitung

Aiphone

Aiphone IE-8MD Bedienungsanleitung

Perel

Perel EDB4 Bedienungsanleitung

Bticino

Bticino Classe 300 Bedienungsanleitung

LG L5142 Bedienungsanleitung