Digital Dream epsilon 2.1 Bedienungsanleitung
1
Users Manual
2
Flash
Viewfinder
Macro switch
Display On/Off
Mode
Set/Flash
Select/Zoom/
Self timer/
Speaker
Microphone
Mode Selection switch
Shutter
Power On/Off
USB
TV out
Camera
Overview
Manual picture mode
Automatic picture mode
Playback mode
Video Mode
Audio mode
Webcam mode
Front View Rear View
Top View
Side View
Mode selection
3
Slide open the battery compartment and insert the batteries as
illustrated.
Push down on the battery door with both thumbs (1)
and slide the door inward while pushing down (2)
1
2
Caution: Only use size AAA alkaline batteries. Batteries may leak or explode if handled improperly. Remove batteries (and memory card) from the camera if you are
going to store the camera for extended periods of time. Ensure the camera is turned off before inserting or removing batteries. Do not disassemble batteries. Do not
expose batteries to flames or excessive heat. Do not immerse batteries in or expose to water. Discontinue use immediately if you notice any changes in the battery
such as discoloration, deformation or leakage.
Your camera comes with 4 x AAA high performance alkaline batteries. It is recommended that you use high
performance alkaline batteries in your epsilon 2.1 digital camera. It is possible to use
rechargeable batteries but these may have a shorter life especially if you use Ni-CD rather than Ni-Mh.
Inserting the
Batteries
— + — +
4
You can use SD to increase the amount of storage capacity of your epsilon 2.1 camera.
The card can vary in capacity from16MB upwards, a 16MB card can hold up to 102 images.
To insert the SD (Secure Digital) card into the camera open the battery door on the bottom of the
camera. Slide the SD into the slot as illustrated.
To insert the SD card into the camera press
down on to the card until it clicks. Close the
battery door as illustrated on the previous page.
Note: When not being used please store the SD card in the protective sleeve provided. Do not touch the gold contacts on the card or im-
merse in liquid. If the card becomes dirty, rub gently with a clean soft cloth and do not use solvents or abrasive materials as this will damage
the card.
Inserting
SD Memory
To eject the SD card press down to
release it and then pull it out.
5
1. Switch the epsilon 2.1 on by holding down the Power On/Off switch for a second.
2. Turn the mode selection switch so that the is lined up with red spot next to the power On/Off button.
3. Press the (Mode) button on the camera and then the 4 way controller right until the “setting” mode is
displayed.
4. Use the 4 way controller up and down to cycle through the options.
5. Press the (Set) button to enter that option.
6. Use the 4 way controller to change the option.
7. Press the (set) button to save the option that you have changed.
8. To exit the mode settings simply press the (mode) button at any time.
4 way controller Exposure White balance Settings Format
Exposure
Use this option to set the camera’s exposure for Manual picture taking only.
White Balance
Use this option to adjust the light balance of the camera in Manual mode only. Select the appropriate light source from
the list. The options are:
Auto
Daylight
Shade
Tungsten
Flourescent.
Format
To clear the entire contents of the SD card or internal memory select “yes” and click on the set button to confirm.
Setting up the
Camera
6
Settings
Date and time: Set the date and time by moving the 4 way controller left/right
for the day/month/year/hour/minute, Move up/down to change and press Set to
confirm.
Date style: Choose the type of date/time style you prefer moving up and down
with the 4 way controller and then press Set to confirm.
Beep: You may select to have the camera sounds On or Off, press the Set but-
ton to confirm.
Video System: This is to set the type of output from the camera on your TV. For
Europe set “PAL” otherwise the images will appear black and white on your TV.
Image size: Select the size of image you wish to take pictures at. The larger the
picture the less images can be stored on the camera.
Press Set to confirm your selection.
Quality: There are 2 choices of quality, “normal” or “fine”. Press Set to confirm
your selection.
Self Timer: select the amount of time delay you require for shooting a self
timed image. Use the up and down on the 4 way controller to move between
the choices.
Language: Select the appropriate language and press Set to select. Please note
that English is the default factory setting.
Power saving: To reduce battery drain you can use the power saving functions
of the camera. You can select for the camera to switch off automatically after 1
minute, 2 minute or not at all. Press Set to confirm your choice.
7
LCD Display
White balance
Exposure
Image size: Large/Medium/Small
Image Quality: Normal/Fine
Burst shoot mode
Flash: On/Off/Auto
Number of pictures remaining.
Zoom
Battery status
Burst shoot mode: To enable/disable this simply press the 4 way controller right to switch On/Off in picture taking mode. Once the shutter is
pressed the display will go black and an image will be shot every second for 5 seconds.
Flash: Press the button on the rear of the camera to change between flash On/Off/Auto mode. Please note the flash cannot be used
in burst shooting, video or audio mode.
Zoom: To zoom in or out press the 4 way controller up to zoom in or down to zoom out.
Self Timer: To enable/disable self timer press right on the 4 way controller, once the shutter button is pressed a 10 second count down will
begin and one image will be shot.
Self Timer
8
Switch on your epsilon camera by holding down the power button for a second.
Turn the Mode selection switch to the Automatic or Manual setting for picture taking.
You can either use the viewfinder or display screen to focus on the picture you want to take.
When you are ready press down the shutter button hard and release.
The image will now be processed, when the display appears again you can take the next shot.
Note: If you have used the flash the camera will take a short while longer to recharge the flash.
Taking pictures
Macro Mode
If you want to take photo’s of close up ob-
jects slide the Macro switch upwards.
This will focus in on close objects, if this is
not enabled anything closer than one meter
will appear blurred.
Slide up
Macro switch
Power Switch
Shutter button
Mode selection set to “Auto”
9
Recording video
& Audio clips
To record video clips with your epsilon 2.1 digital camera turn the mode selection button to the video
position.
To start recording video with sound press the shutter button. To stop the recording simply press the shutter
button again.
The maximum amount of time you are able to record is dependant on the amount of memory you have in the
camera. This can be increased with SD (Secure Digital) a 16MB card will record approximately
2minutes of video.
Audio
To record Audio clips turn the mode selection button to the Audio position.
To start recording Audio press the shutter button. To stop the recording simply press the shutter button
again.
The maximum amount of time you are able to record is dependant on the amount of memory you have
in the camera.
Recording time in secondsVideo
Audio Recording time in seconds
10
Viewing images,
Video & Audio
To view your images, Video or Audio on the camera display screen turn the mode selection
switch to the Play mode.
To move between the images press the 4 way controller right to move forward through the
images or left to move backward through the images.
You can zoom into your still images by pressing the 4 way controller upwards or zoom out
by moving the controller downwards.
Playback options
If you press the (mode) button while in playback mode a menu will be displayed on the
right hand side. Use the 4 way controller to move up and down through the menu and press
the set button to confirm your choice.
Delete all: select this to delete every unprotected file on the camera.
Delete one: select this to delete the particular image on screen.
Lock: select this to protect that selected image to prevent it from being deleted. However
if you use the format option as described on the setting up your camera section the
locked images will be removed.
DPOF (Digital print order format): If this option is selected then that particular image is
marked in such a way that it can be printed automatically. A special printer is required for
this function.
Inhaltsverzeichnis
Andere Digital Dream Digitalkamera Handbücher
Digital Dream
Digital Dream L'espion Xtra Bedienungsanleitung
Digital Dream
Digital Dream L'espion mini Bedienungsanleitung
Digital Dream
Digital Dream quantum 3.2 Bedienungsanleitung
Digital Dream
Digital Dream MINIATURE HIGH PERFORMANCE DIGITAL CAMERA Bedienungsanleitung
Digital Dream
Digital Dream L'espion Bedienungsanleitung
Digital Dream
Digital Dream sportsman Bedienungsanleitung
