Programming - using the
programming button
PROGRAMMING
There are 2 ways to program the detector’s detection
range, pulse count and LED setting.
1. Using the programming button on the detector
itself and programming chart below.
2. Using the detector’s web-based interface.
USING PROGRAMMING BUTTON
Programming Chart
SETTING
1 2 3 4 5
O
P
T
I
O
N
S
1 RANGE (m) 8 15 20 25 30
2 Pulse Count 1 2 3
3 LED Off On
To change any of the SiteWatch™ detectors settings:
1. Press the program button (as shown in the
image below) for the number of the Option to be
changed. For example, press once for range, twice
for pulse count, three times for LED settings.
RJ45 Program
Reset
2. Wait until the blue LED indicator turns off (four
seconds).
3. The indicator will then ash out the existing
settings.
4. To change the settings for the set option, press
the program button the number of times for the
required new setting.
5. The indicator will blink twice and the changes will
be saved in the SiteWatch™ detectors’ non-volatile
memory.
Example: to change the LED setting from OFF to ON:
1. Press the program button three times to enter the
LED settings options.
2. Wait until the blue LED indicator turns off
(four seconds).
3. The indicator will then ash once, indicating the
current LED setting is OFF.
4. Press the program button twice to change the
setting to ON.
5. The indicator will blink twice and the changes are
saved in the SiteWatch™ detectors’ non-volatile
memory.
PROGRAMMING OPTIONS DEFINITIONS
Pulse Count
The number of times the detector must detect
motion on both of its sensors before signaling an
output.
LED
LED Off – LED signals are detection is disabled.
LED On – LED signals a detection is enabled.
Relay outputs
Output 1 and output 2
These are magnetically immune volt-free relay
contacts, used to trigger alarm inputs on connected
equipment. The contacts are rated at a maximum of
24V AC/DC @ 50mA.
The contact operating timer can be adjusted in the
web-based user interface.
WALK TEST
In walk test mode, the detection LED option is set to
ON, and the pulse count option is set to 1. DW-DTWT
walk tester is sold separately.
1. The detection LED turns on each time the
SiteWatch™ detectors detect motion.
2. To enter the walk test mode, press the
programming button once. The detection LED
is enabled and pulse count 1 is automatically
selected. The walk test mode can also be entered
via the web-based user interface. The unit can
then be aligned. See the DW-DTWT QSG for more
information.
3. The test mode ends automatically ve minutes
after the last activation. Alternatively, press the
program button three times, to cancel the walk
test mode.
Note: When conducting a walk test, make sure that
the front cover of the detector is in place. Do not
conduct walk tests with the cover removed.
The range of the detector increases without the
protective front cover. Therefore, the front cover
must be tted to establish the correct beam pattern.
Use the programming chart to adjust the range as
necessary. Pan and tilt the lens module over the eld
of view to obtain the correct coverage area.
Microwave Frequencies
DW-DTMWIPW ONLY: 10.525GHz
10 dBm EIRP
9
