Please refer to the above figure for cable connection
Step l: Connect the front channels Output of the device (DVD) to the front Channels
Input sockets on the back panel with a 3.5mmφ_RCAx2 STEREO Cable.
(Connecting the PC with the system uses a 3.5φstereo_3.5φstereo cable instead
of a 3.5mmφ_RCAx2 STEREO Cable.)
Step 2: Connect the rear channels Output of the device (DVD) to the rear Channels
Input sockets on the back panel with a 3.5mmφ_RCAx2 STEREO Cable.
(Connecting the PC with the system uses a 3.5φstereo_3.5φstereo cable instead
of a 3.5mmφ_RCAx2 STEREO Cable.)
Step 3: Connect the centre/subwoofer channels Output of the device (DVD) to the
centre/subwoofer Channels Input sockets on the back panel with a
3.5mmφ_RCAx2 STEREO Cable. (Connecting the PC with the system uses a
3.5φstereo_3.5φstereo cable instead of a 3.5mmφ_RCAx2 STEREO Cable.)
Step 4: Connect all the satellite speakers to the speaker output Section on the back
panel of the woofer.
Step 5: Connect the AC power and turn on the switch on the back of the subwoofer.
SAFETY INSTRUCTIONS
IMPORTANT
Please unplug the system if any of the following conditions exist:
1. The power cord or plug becomes frayed or otherwise damaged.
2. Your system has been dropped or the enclosures have been otherwise
damaged.
3. Liquid has been spilt into a speaker enclosure.
4. You suspect that your system needs repairing.
5. Your system is exposed to rain or any other excessive moisture.
TROUBLESHOOTING
If you experience problems during the installation of your system please first check
the following conditions:
1. Make sure all the connections between the system and devices are fully seated.
2. Make sure that the power supply is switched on.
3. If connected to a non-standard game console or audio device, please consult
the manual of those devices for connection.
