Dimplex RFV-800 Bedienungsanleitung

7201010001rev10In keeping with our policy of continuous product development, we reserve the right to make changes without notice.

Dimplex North America Limited

1367 Industrial Road Cambridge ON Canada N1R 7G8

1-800-668-6663 www.dimplex.com

Installation, Operation &

Maintenance Instructions

Forced Air Heater

Series “D” RFV-800

Remove heater from carton. The front grill and trim can

be lifted off assembly, and placed in carton to prevent

damage. Remove screws securing heater assembly to

the recess box and separate (Fig. 1).

NOTE: Mount the heater a minimum of 12 inches (30.5

cm) from the nished oor.

Recessed Installation

1. The recess box provided with the heater is designed

for attachment between studs placed on 16” (40.6cm)

centres. If different spacing exists, construct frame

to suit the box in order to avoid any vibration and

noise caused by loose mounting (Fig. 2a).

2. Note orientation of box (“TOP” shown on recess box)

and secure to studs using four holes provided on side

anges, ensuring these anges are ush with

nished surface of wall (Fig. 2b).

Surface Installation

1. Secure optional surface mount box (Part No. RFP8D)

by angling screws through holes provided in rear of

surface box into studs or nished surface.

2. Position recess box into surface box and secure with

four screws provided in parts bag of surface box.

Fig. 1

Ground

Screw

Front Panel (Grill)

& Trim Frame

Heater

Assembly

Recess Box

Fig. 2

19 3/4”

(50 cm)

MIN. 12”

(30.5 cm)

14 1/4”

(36 cm)

(a) (b)

Side

Flanges

15”

(38 cm)

Finished Wall

Surface

7/8” (22 mm) Dia.

Knockout

14 1/4”

(36 cm)

19 3/4”

(50 cm)

3 5/8”

(9 cm)

Finished

Floor MIN. 12”

(30.5 cm)

NOTE: Dimensions are shown as

size of rough opening in stud wall

Supply Wiring and Heater Installation

1. Insert approximately 15” (38cm) of supply wire into recess box

through knockout provided in upper left hand corner (Fig. 2b).

Wire should be rated for a minimum of 75°C (167°F)

2. Connect power supply to terminals provided marked L1 and L2.

Ground wire should be secured to green ground screw provided

on side of heater assembly (Fig. 1).

3. All units are factory prewired for operation with built-in thermostat.

If remote thermostat operation is required follow appropriate

wiring diagram located on inside of recess box.

NOTE: All wiring must comply with National Electrical Code and

local codes.

4. Secure heater assembly to recess box using four (4) M4 screws

removed at the start of these instructions.

Front Panel Installation

1. Remove trim frame from front panel assembly.

2. If tamperproof built-in or remote thermostat operation is required,

secure the louvered door to the front panel using two (2) M3

screws (not included) through the holes provided. The knob can

then be removed and adjustment of the thermostat can be made using a slotted screwdriver through the front

panel.

3. Check to see that the fan blade is free to turn and that no residue remains in the unit. Front panel can then

be secured to assembly using four (4) M4.8 x 37 screws provided.

4. Follow the steps in Fig. 3.

Operation and Maintenance

1. Set thermostat to desired temperature and both fan and heat should come on. Note that when desired

temperature is reached the fan operation will continue for a short period after the elements have de-

energized in order to remove residual heat from the unit.

2. The fan motor is permanently lubricated and sealed at the factory and is maintenance free.

3. It is suggested that at the beginning of each season the front panel is removed and the wire connection

condition is checked and the unit is cleaned of dust and dirt with a vacuum cleaner.

NOTE: Always open the circuit breaker to disconnect power to the unit prior to performing any maintenance or

service operation.

WARNING: Should the Over Temp light come on, disconnect power to the heater or turn down the thermostat

fully counterclockwise and call a licenced electrician. DO NOT USE HEATER UNTIL PROBLEM IS

DETERMINED AND FIXED.

CATALOGUE NO. MOTOR CAPACITOR FAN BLADE ELEMENT CUT-OUT FAN DELAY THERMOSTAT FRONT PANEL KIT

RFV831551 RFVFPA

RFV831551W RFVFPW

RFV831581 RFVFPA

RFV831581W RFVFPW

RFV842051 RFVFPA

RFV842051W RFVFPW

RFV842081 RFVFPA

RFV842081W RFVFPW

2600060400RP

16210094RP

00029001RP

3200070100RP

REPLACEMENT PART

2000260100RP

00010034RP

16210091RP

00009114RP

00033002RP

2600060400RP

16210093RP

00029001RP

16210092RP

Fig. 3

(A) Place frame over top of tabs.

(B) Push in at bottom until frame is ush

with front panel.

place.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Dimplex Heizung Handbücher

Dimplex

Dimplex EPX Bedienungsanleitung

Dimplex

Dimplex SRX 080 EM Bedienungsanleitung

Dimplex

Dimplex DHCH20H Bedienungsanleitung

Dimplex

Dimplex CVP1 Bedienungsanleitung

Dimplex

Dimplex Free-E Bedienungsanleitung

Dimplex

Dimplex PFH30R Bedienungsanleitung

Dimplex

Dimplex DX 521 Bedienungsanleitung

Dimplex

Dimplex FW 550S Bedienungsanleitung

Dimplex

Dimplex OFC1005 Bedienungsanleitung

Dimplex

Dimplex BLF7451 Bedienungsanleitung

Dimplex

Dimplex DXUF2T Bedienungsanleitung

Dimplex

Dimplex DHCER24SG Bedienungsanleitung

Dimplex

Dimplex CFS120 Bedienungsanleitung

Dimplex

Dimplex DHCER20 Bedienungsanleitung

Dimplex

Dimplex OFC1000 Bedienungsanleitung

Dimplex

Dimplex NELSON DELUXE NLS20RC Bedienungsanleitung

Dimplex

Dimplex TAYLOR SUITE Bedienungsanleitung

Dimplex

Dimplex SRX 070C Bedienungsanleitung

Dimplex

Dimplex AC3N Bedienungsanleitung

Dimplex

Dimplex DHOP1341 Bedienungsanleitung

Dimplex

Dimplex LPC Series Bedienungsanleitung

Dimplex

Dimplex SLR 200WE Bedienungsanleitung

Dimplex

Dimplex CHESIL CLS20 Bedienungsanleitung

Dimplex

Dimplex FX 20V Bedienungsanleitung

Beliebte Heizung Handbücher anderer Marken

oventrop

oventrop Regucor Series Bedienungsanleitung

Blaze King

Blaze King CLARITY CL2118.IPI.1 Bedienungsanleitung

ELMEKO

ELMEKO ML 150 Bedienungsanleitung

BN Thermic

BN Thermic 830T Bedienungsanleitung

KING

KING K Series Leitfaden

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Kurzanleitung

Well Straler

Well Straler RC-16B Bedienungsanleitung

EUROM

EUROM 333299 Bedienungsanleitung

Heylo

Heylo K 170 Bedienungsanleitung

Eterna

Eterna TR70W Bedienungsanleitung

Clarke

Clarke GRH15 Bedienungsanleitung

IRSAP

IRSAP The Radiator Company Ovali Bedienungsanleitung

Empire Heating Systems

Empire Heating Systems WCC65 Bedienungsanleitung

Wetekom

Wetekom 92 86 43 Bedienungsanleitung

Desa

Desa SPC170-F Bedienungsanleitung

Watlow

Watlow Watrod Electric Tubular Heaters Bedienungsanleitung

Haverland

Haverland ECO-DRY GPS Series Stücklistenhandbuch

Stelpro

Stelpro ASILVC2060 Series Bedienungsanleitung