Dimplex MULTIFIRE DF3015 Kurzanleitung

PARTS AND SERVICE MANUAL

FOR

DIMPLEX MULTIFIRE™

ELECTRIC FIREPLACE

MODEL NUMBER:

DF3015

Valued Customer,

We are pleased that you have chosen to purchase an electric fireplace

manufactured by Dimplex North America Ltd.Over the years, valuable

memories ill occur around the armth and comfort of your hearth. Thank you

for allo ing our product to be the backdrop for those special moments.

TABLE OF CONTENTS

OPERATION PAGE 2

PARTS DRAWING PAGE 7

PARTS LIST PAGE 8

LOWER LIGHT BULB REPLACEMENT PAGE 9

UPPER LIGHT BULB REPLACEMENT PAGE 10

MAIN ON/OFF SWITCH REPLACEMENT PAGE 11

SWITCH CIRCUIT BOARD REPLACEMENT PAGE 11

FLAME MOTOR/REFLECTOR ROD REPLACEMENT PAGE 12

HEATER ASSEMBLY REPLACEMENT PAGE 13

CIRCUIT BOARD REPLACEMENT PAGE 14

POWER CORD REPLACEMENT PAGE 15

DF3015

OPERATION

ELECTRIC FIREPLACE MANUAL CONTROL

The manual controls for the fireplace are located in the lower right hand corner.

A. Main On/Off Switch

Supplies power to the 3 position manual control switch.

B. 3 Position Manual Control Switch

Remote (right position): The unit is operated with the remote control.

Flame (center position): The flame effect is turned ON.

Flame & Heat (left position): The flame effect and heater are turned ON simultaneously.

When the manual control is in the Flame & Heat position the heater does not run on the

remote operated thermostat.

NOTE

When the manual control switch is in the Flame and Flame & Heat positions, the fireplace

unit will not operate with the remote control.

RESETTING THE TEMPERATURE CUTOFF SWITCH

Should the heater overheat, an automatic switch will turn the heater off and it will not come

back on without being reset. The temperature cutoff switch can be reset by unplugging the

unit, waiting 5 minutes and plugging the unit back in.

Initialization

Button

3 Position

Manual

Control

Main

On/Off

Switch

CAUTION

If you need to continuously reset the heater, unplug the unit and call Dimplex North America

Limited at 1-800-668-6663 and press 4 for technical support. Please have your model and

serial number ready when calling.

REMOTE CONTROL

The remote control has a range of approximately 50 ft. (15.25m), it does not have to be

pointed at the fireplace and can pass through most obstacles (including walls). It is supplied

with 243 independent frequencies to prevent interference with other units.

BATTERY INSTALLATION

1. Depress tab on the battery cover on the back of the remote transmitter and remove

battery cover.

2. Install 2 AAA batteries into the remote control. (included)

3. Ensure child lock is in the “unlocked” position.

4. Replace the battery cover.

NOTE

When the “BAT”symbol is present on the remote control it is recommended to replace the

batteries promptly, to maintain full functionality of the remote/fireplace. The remote transmitter

has a battery backup time of only several hours.

INITIALIZING THE REMOTE CONTROL

1. Plug cord into 120 volt wall outlet.

2. Ensure the Main On/Off switch located in the switch box on the fireplace in the lower

right hand corner is in the ON position.

3. Set the 3 position manual control to the Remote position (right position).

4. Press and hold the initialization button on the unit.

5. While holding the initialization button, press the flame/heat ON/OFF button or the

Purifire™ ON/OFF button on the remote control transmitter.

6. Release the initialization button on the unit.

7. Press the Flame/Heat On/Off button to turn the Flame/Heat function ON or press the

Purifire™ On/Off button to turn the Purifire™ function ON.

FREQUENCY INTERFERENCE

If the fireplace does not respond properly to the remote control, the remote operating

frequency may have to be reset. The remote control can send another frequency code to the

circuit board to eliminate interference.

1. Simultaneously press the “SLEEP TIMER DOWN” button and the “PURIFIRE LOW

SPEED” button on the remote control.

Batteries

FIGURE 3

2. “COD” will appear in place of the sleep timer digits.

3. Release the “SLEEP TIMER DOWN” button and the “PURIFIRE LOW SPEED” button.

4. Press the initialization button on the unit.

5. press the button on the remote.

Your remote will now have a different frequency communicating with the fireplace.

REMOTE CONTROL FUNCTIONS

FLAME/HEAT ON/OFF BUTTON

Press the “Flame/Heat On/Off “button to turn the Flame/Heat function ON. When the “Set

Temperature” is higher then the “Room Temperature” the heat will come on. To turn the

heat off, lower the “Set Temperature” so that it’s setting is lower then the “Room

Temperature”. The default temperature setting is 72°F (22°C).

NOTE

When using the remote control the heater runs on a thermostat. Press the “Temperature Up”

or “Temperature Down” button to adjust the set temperature. Once the desired set

temperature is reached the heater will turn OFF. The heater will cycle ON and OFF to

maintain the desired set temperature.

PURIFIRE ON/OFF BUTTON

Press the “Purifire™ On/Off” button to turn the Purifire™ function ON. When the

Purifire™ function is ON the Purifire™ symbol will flash. When off the symbol will be solid.

The default setting for the Purifire™ is set at low speed. Press the “Purifire™ On/Off” button

to turn the Purifire™ function OFF.

NOTE

To turn the Flame/Heat and Purifire™ “OFF” at the same time, press both control buttons

simultaneously.

FIGURE 5

Temperature Up

Temperature

Down

Dimmer

Down

Dimmer Up

Flame Speed

Down

Flame Speed Up

Sleep Timer

Down

Sleep Timer Up

Purifire Low

Speed

Purifire High Speed

Flame & Heat

On / Off

Purifire On / Off

Batteries

Child Lock

Purifire

Room Temperature

Set Temperature

Dimmer

Flame Speed Control

Sleep Timer

SET TEMPERATURE

1. Press “Flame Heat On/Off” button to turn fireplace on.

2. Press “Temperature Up” to raise thermostat.

3. Press “Temperature Down” to lower thermostat.

4. Press both “Temperature Up” and Temperature Down” to change °F to °C.

FLAME SPEED

1. Press the “Flame/Heat On/Off” button to turn the Flame/Heat ON.

2. Press the “Flame Speed Up” to increase the speed of the flame.

3. Press the “Flame Speed Down” to decrease the speed of the flame.

LIGHT DIMMER

1. Press the Flame/Heat button to turn the Flame/Heat ON.

2. Repeatedly press the “Light Dimmer Up” or “Light Dimmer Down” button to decrease

or increase the brightness of the upper lights.

CHILD LOCK

1. Depress tab on the battery cover on the back of the remote transmitter and remove the

battery cover.

2. Move “Child Lock” tab to the right to lock the remote transmitter.

3. Move “Child Lock” tab back to the left to unlock the remote transmitter.

4. Replace the battery cover.

NOTE

To temporarily unlock the remote transmitter press (in order) “Temperature Down” then

“Temperature Up” then “Dimmer Down”.

When the remote transmitter’s backlight is illuminated the “Child Lock” is bypassed. When

the backlight is off the “Child Lock” is re-activated.

Child Lock Switch

Locked

Unlocked

Figure 6

PURIFIRE™

The Purifire™ includes a high efficiency filter to help improve the quality of air.

1. Press the button for the Purifire™ function.

2. Press the “Purifire Low Speed” button or the “Purifire High Speed” button to select

LOW or HIGH.

3. Press the button to turn the Purifire™ ON, press the button to turn the Purifire™

OFF.

SLEEP TIMER

The Sleep Timer automatically shuts off the fireplace after a preset time (from 30 minutes to 8

hours).

1. Press the Flame/Heat On/Off button to turn the fireplace ON.

2. To set the sleep timer press the “Sleep Timer Up” button.

3. Set the timer from 30 minutes through 8 hours.

5. The fireplace will automatically turn OFF when the sleep timer reaches 0 minutes.

6. The sleep timer can be cancelled at any time by pressing the “Sleep Timer Down”

button repeatedly until the sleep timer displays “0”.

DF3015

REPLACEMENT PARTS

FIREBOX, 30" - DIMPLEX

CATALOGUE NO. DF3015

PART NO. 6903020159

MOD LEVEL: NONE

MADE IN: CHINA

REPLACEMENT PART REPLACEMENT PART NO.

1. 30” URETHANE LOG SET ASSEMBLY 0439070100RP

2. HEATER ASSEMBLY 2200490600RP

3. UPPER LIGHT HARNESS 2500400200RP

4. LOWER LIGHT HARNESS

(left and right bulbs)

2500400100RP

LOWER LIGHT HARNESS

(center bulb)

2500150200RP

5. FLAME MOTOR 3000240200KIT

6. REMOTE CONTROL – SENDER 3000300100RP

7. REMOTE CONTROL RECEIVER 3000300200RP

8. CORD SET 4100040400RP

9. REFLECTOR ROD 5900080700RP

10.MIRROR, SEMI-SILVERED 5900680100RP

11.FRONT GLASS 5900310400RP

12.FOOT 8800090100RP

13.FILTER 0439060100RP

14.MAIN ON/OFF SWITCH 2800070700RP

15.SWITCH CIRCUIT BOARD 3000300300RP

DF3015

If unit was operating prior to servicing allow at least 10 minutes for light bulbs and

heating element to cool off to avoid accidental burning of skin.

Disconnect power before attempting any maintenance or cleaning to reduce the risk of

electric shock or damage to persons.

Light bulbs need to be replaced when you notice a dark section of the flame. There are

four bulbs under the log set which generate the flames and embers. It is a good idea to

replace all of the light bulbs at one time if they are close to the end of their rated life.

Group replacement will reduce the number of times you need to open the unit to replace

the light bulbs.

TO REPLACE LOWER BULBS:

1. Slide fireplace out of mantel 2-3 inches.

2. Remove 4 Phillips screws from the right side of trim.

3. Slide glass to right side of fireplace to remove.

4. Pull the front edge of the plastic ember bed or plastic grate up and forward until the

rear tab releases from the ledge located at the bottom of the mirror.

IMPORTANT:Only handle the logset by the emberbed.

NOTE: Logset fits tightly into firebox, some force may be necessary to remove.

5. Set logset in front of fireplace.

6. Disconnect the logset LED wire harness from unit.

7. Hold the socket while unscrewing the old bulb.

8. Hold the socket while screwing in the new bulb.

9. Reassemble in the reverse order as above.

LIGHT BULB REQUIREMENTS

Quantity of 4 clear chandelier or candelabra bulbs with an E-12 (small) socket base,

60 watt rating.

Andere Handbücher für MULTIFIRE DF3015

Inhaltsverzeichnis

Andere Dimplex Kamin im Innenbereich Handbücher

Dimplex

Dimplex Cavendish CSH20 Bedienungsanleitung

Dimplex

Dimplex VIVALDI DE LUXE Bedienungsanleitung

Dimplex

Dimplex Optiflame Toluca Deluxe TLC20LX Bedienungsanleitung

Dimplex

Dimplex Albany Optimyst ABN15-RGB-EU Bedienungsanleitung

Dimplex

Dimplex Revillusion SWD20-AU Bedienungsanleitung

Dimplex

Dimplex DF2690 Bedienungsanleitung

Dimplex

Dimplex OPTIMYST CAS250 Bedienungsanleitung

Dimplex

Dimplex MULTIFIRE DF3015 Bedienungsanleitung

Dimplex

Dimplex OPTIMYST RTOPI20BR Bedienungsanleitung

Dimplex

Dimplex SYMPHONY SF5598 Kurzanleitung

Dimplex

Dimplex RANA LED Bedienungsanleitung

Dimplex

Dimplex NAVARRA NAV15P PEBBLE Betriebsanleitung

Dimplex

Dimplex ELECTRALOG DF203A Bedienungsanleitung

Dimplex

Dimplex VCX1525 Bedienungsanleitung

Dimplex

Dimplex DF2608 Bedienungsanleitung

Dimplex

Dimplex 6911540100 Bedienungsanleitung

Dimplex

Dimplex CASTILLO CS3540 Bedienungsanleitung

Dimplex

Dimplex EWMC-CC-SS Bedienungsanleitung

Dimplex

Dimplex Sierra 48 Bedienungsanleitung

Dimplex

Dimplex Auvergne Log 2920 Bedienungsanleitung

Dimplex

Dimplex BELLINI BLN15W Bedienungsanleitung

Dimplex

Dimplex SP16 Bedienungsanleitung

Dimplex

Dimplex THWG XLF50 Bedienungsanleitung

Dimplex

Dimplex Revillusion RBF30C-AU Bedienungsanleitung

Beliebte Kamin im Innenbereich Handbücher anderer Marken

Brigantia

Brigantia 35-DVRS31N-2 Betriebsanleitung

Nordpeis

Nordpeis Bergen Bedienungsanleitung

Superior

Superior BCT2536TMN Bedienungsanleitung

Quadra-Fire

Quadra-Fire 5100I-GD-B Bedienungsanleitung

Renaissance

Renaissance RUMFORD 1000 Bedienungsanleitung

Lacunza

Lacunza IV-800 Bedienungsanleitung

Baxi

Baxi 940 Gebrauchsanweisung

Dru

Dru Maestro 60/2 Tall RCH Bedienungsanleitung

Diamond Fireglass

Diamond Fireglass SS-O22 Bedienungsanleitung

HearthStone

HearthStone Windsor Bay 8830 Programmierhandbuch

Napoleon

Napoleon ASCENT B42 Bedienungsanleitung

Enviro

Enviro E33GI Bedienungsanleitung

Smeg

Smeg L30 FABE Montageanleitung

KEDDY

KEDDY K700 Bedienungsanleitung

Godin

Godin 3451 Bedienungsanleitung

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Bedienungsanleitung

Austro Flamm

Austro Flamm Heidi Back 2.0 945048 Bedienungsanleitung

Desa

Desa CCFPDFT Bedienungsanleitung