RUN
PWR Mediaprocessor
MFU
RUN GE2 GE3 RST
GE0 GE1 CONSOLE
PWR
MFU
RUN
PWR Mediaprocessor
Mediaprocessor
MFU
RUN
PWR
MFU
Mediaprocessor
MCU
RUN
PWR
MCU
100-240VAC50-60HZ
POWER0
POWER1
100-240VAC50-60HZ
SBC3000
Power Indicator for MFU
Running Indicator for MFU
Screws
Network port for service
Power Indicator for MCU
Running Indicator for MCU USB Interface
Network port
for service
Network port for
Management
Console Port
Reset Button
Grounding Lug Power
Jack
Power
Switch
Cooling Fan Screws
SBC3000
Attentions before Installing
4
The SBC1000/SBC3000 mounting cabinets should be 19 inches in width and 550 mm or
more in depth (Dinstar provides the required brackets for installation);
To guarantee device works normally and to lengthen the service life of the device, the
humidity of the equipment room where device is installed should be maintained at 10%-90%
(non-condensing), and temperature should be 0℃~45℃;
It's suggested that personnel who has experience or who has received related training be
responsible for installing and maintaining device;
Power supply of SBC300 should be 12V DC, and power supply of SBC1000/SBC3000
should be 100~240V AC;
It's advised to adopt uninterruptible power supply (UPS);
Please wear ESD wrist strap when installing device;
Please do not hot plug cables;
Ensure the equipment room is well-ventilated and clean.
