Directed 6867T Gebrauchs- und Pflegehandbuch

Product Description

The 6867T control center is compatible with the following modules: DS4

and DS4+.

Mounting the Control Center

Note Once this replacement control center has been installed, all

remote controls must be paired with your system. See Remote

Pairing for details and follow the instructions for your remote

control type.

The control center’s position should be discussed with the vehicle owner

prior to installation since the antenna, with built-in status LED and Valet/

Program, must be visible/accessible to the customer.

The best position to locate the control center is centered high on the front

windshield. It can be mounted vertically or horizontally relative to the

windshield. Metallic window tint can also aect range negatively, so this

should be a consideration when determining the mounting location.

After you determine the best mounting location, follow these steps:

Clean the mounting area with a quality glass cleaner or alcohol to remove

any dirt or residue.

Plug the cable into the control center.

Mount the control center with double-sided tape.

Route the cable down the window pillar to the control module and plug

the cable in the control module.

CONTROL CENTER

CABLE

CONTROL

MODULE

Remote Pairing

Prepare the vehicle system to be Paired with a new remote

1. Open at least one vehicle door.

2. Turn the key to the ON position.

3. Within 5 seconds press and release the Control button on the Control

Center one time.

4. Within 5 seconds, press and hold the Control button on the Control

Center. The status LED begins ﬂashing in single ﬂash sequence and

the siren/horn sounds once to conﬁrm the system is ready for remote

pairing. Release the button.

5. Locateyour remote control model below andfollow the instructions.

System Pairing will exit if:

• The ignition is turned o

• The open door is closed

• 60 seconds lapses with no actions

Note

:Make sure the remote to be paired with the system is set for the de-

sired Car 1 or Car 2 operation.

LCD Remote Control:

1. Press and hold the

AUX

button for 8 seconds, the remote beeps once,

Main Menu is displayed. Release the

AUX

button.

2. Press the AUX or

AUX

buttons until Pair is displayed.

3. Press and hold the

AUX

button until the remote beeps 3 times thenre-

lease the

AUX

button. The remote is now ready to pair with the system.

4. Press the

AUX

button.

5. Wait several seconds for feedback as the remote generates a security

encryption and sends it to the Control Center. If pairing is successful

the siren/horn sounds and the remote emits several tones. The screen

displays if the Pairing is successful or failed with corresponding text. If

pairing fails repeat step 4.

To exit pairing mode on the remote:

• Press and release the

A U X

button.

•Wait 30 seconds without pressing a command button on the remote.

Responder LED or Companion Remote Control:

1. Pressand holdthe

AUX

button for 8 seconds. The transmit LED will come

on solid. Release the

AUX

button.

2. Press and hold the

AUX

until the transmit LED ﬂashes 3 times then

comes on solid.

3. Press the

AUX

button.

4. Wait several seconds for feedback as the remote generates a security

encryption and sends it to the Control Center. If pairing is successful

the siren/horn sounds and the 2-way remote emits several tones (the

companion remote does not generate tones). If pairing is not suc-

cessful press and release the

AUX

button once and then repeat steps

2 and 3.

To exit pairing mode on the remote:

• Press and release the

AUX

button once, thenpress and hold until the

transmit LED shuts o.

•Wait 30 seconds without pressing a command button on the remote

control.

6867T

Replacement

Digital Control Center

GOVERNMENT REGULATIONS

920-10012-01

This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause

harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable

operation.

This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates and can radiate radio frequency energy and, if not installed and used in accordance with the instruction

manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur

in a particular installation. If this equipment does cause harmful interference to radio or television, which can be determined by

turning the equipment OFF and ON, the user is encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio / TV technician for help.

To satisfy FCC RF exposure compliance requirements, the device and its antenna must maintain a separation distance of 20 cm

or more from the person’s body, except for the hand and wrists, to satisfy RF exposure compliance.

WARNING! : Changes or modifications not expressly approved by Directed Inc. could void user's authority to operate the

equipment.

This device complies with Industry Canada licence-exempt RSS-247 standards. Operation is subject to the following two

conditions:

(1) this device may not cause interference, and

(2) this device must accept any interference, including interference that may cause undesired operation of the device.

Cet appareil est conforme avec Industrie Canada exempts de licence standards RSS-247. Son fonctionnement est soumis

aux deux conditions suivantes:

(1) cet appareil ne doit pas provoquer d'interférences et

(2) cet appareil doit accepter toute interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.”

Health Canada RF Exposure Warning:

This device complies with Health Canada’s Safety Code. The installer of this device should ensure that RF radiation is not

emitted in excess of the Heath Canada’s requirement. The device must maintain a separation distance of 20cm or more from the

person’s body, except for the hands and wrists. Information can be obtained at:

http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-lignes_direct/index-eng.php

Lignes Directrices de Santé Canada sur l’exposition aux radiofréquences:

Cet appareil est conforme avec Santé Canada Code de sécurité 6. Le programme d’installation de cet appareil doit s’assurer

que les rayonnements RF n’est pas émis au-delà des limites établies par Santé Canada. L’emplacement de l'appareil doit se

situer à une distance de 20cm ou plus par rapport au corps de la personne, à l’exception des mains et des poignets. Les

informations peuvent être obtenues à l’adresse Internet suivante:

http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-lignes_direct/index-fra.php

LIMITED ONE YEAR CONSUMER WARRANTY

For a period of ONE YEAR from the date of purchase of a Directed Electronics remote start or security product, Directed

Electronics. (“DIRECTED”) prom -ises to the original purchaser, to repair or replace with a comparable reconditioned piece,

the security or remote start accessory piece (hereinafter the “Part”), which proves to be defective in workmanship or

material under normal use, provided the following conditions are met: the Part was purchased from an authorized

DIRECTED dealer; and the Part is returned to DIRECTED, postage prepaid, along with a clear, legible copy of the receipt

or bill of sale bearing the following information: consumer’s name, address, telephone number, the authorized licensed

dealer’s name and complete product and Part description.

This warranty is nontransferable and is automatically void if the Part has been modified or used in a manner contrary to its

intended purpose or the Part has been damaged by accident, unreasonable use, neglect, improper service, installation or

other causes not arising out of defect in materials or construction.

TO THE MAXIMUM EXTENT ALLOWED BY LAW, EXCEPT AS STATED ABOVE, ALL WARRANTIES, INCLUDING BUT

NOT LIMITED TO EXPRESS WARRANTY,

IMPLIED WARRANTY, WARRANTY OF MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE AND

WARRANTY OF NONINFRINGEMENT OF INTELLECTUAL PROPERTY, ARE EXPRESSLY EXCLUDED; AND

DIRECTED NEITHER ASSUMES NOR AUTHORIZES ANY PERSON OR ENTITY TO ASSUME

FOR IT ANY DUTY, OBLIGATION OR LIABILITY IN CONNECTION WITH ITS PRODUCTS. DIRECTED HEREBY

DISCLAIMS AND HAS ABSOLUTELY

NO LIABILITY FOR ANY AND ALL ACTS OF THIRD PARTIES INCLUDING DEALERS OR INSTALLERS. DIRECTED IS

NOT OFFERING A GUARANTEE OR INSURANCE AGAINST VANDALISM, DAMAGE, OR THEFT OF THE

AUTOMOBILE, ITS PARTS OR CONTENTS, AND DIRECTED HEREBY DISCLAIMS

ANY LIABILITY WHATSOEVER, INCLUDING WITHOUT LIMITATION, LIABILITY FOR THEFT, DAMAGE, OR

VANDALISM. IN THE EVENT OF A CLAIM

OR A DISPUTE INVOLVING DIRECTED OR ITS SUBSIDIARY, THE PROPER VENUE SHALL BE SAN DIEGO COUNTY

IN THE STATE OF CALIFORNIA. CALIFORNIA STATE LAWS AND APPLICABLE FEDERAL LAWS SHALL APPLY AND

GOVERN THE DISPUTE. THE MAXIMUM RECOVERY UNDER ANY

CLAIM AGAINST DIRECTED SHALL BE STRICTLY LIMITED TO THE AUTHORIZED DIRECTED DEALER’S PURCHASE

PRICE OF THE PART. DIRECTED SHALL

NOT BE RESPONSIBLE FOR ANY DAMAGES WHATSOEVER, INCLUDING BUT NOT LIMITED TO, ANY

CONSEQUENTIAL DAMAGES, INCIDENTAL

DAMAGES, DAMAGES FOR THE LOSS OF TIME, LOSS OF EARNINGS, COMMERCIAL LOSS, LOSS OF ECONOMIC

OPPORTUNITY AND THE LIKE. NOTWITHSTANDING THE ABOVE, THE MANUFACTURER DOES OFFER A LIMITED

WARRANTY TO REPLACE OR REPAIR AT DIRECTED’S OPTION

THE PART AS DESCRIBED ABOVE.

This warranty only covers Parts sold within the United States of America and Canada. Parts sold outside of the United

States of America or Canada are sold “AS-IS” and shall have NO WARRANTY, express or implied. Some states do not

allow limitations on how long an implied warranty will last or the exclusion or limitation of incidental or consequential

damages. This warranty gives you specific legal rights and you may also have other rights that vary from State to State.

DIRECTED does not and has not authorized any person or entity to create for it any other obligation, promise, duty or

obligation in connection with this Part. For further details relating to warranty information of Directed products, please visit

the support section of DIRECTED’s website at: www.directed.com

3920-10012-01

Andere Directed Controller Handbücher

Directed

Directed XDR G6867T Bedienungsanleitung

Beliebte Controller Handbücher anderer Marken

Digiplex

Digiplex DGP-848 Betriebsanleitung

YASKAWA

YASKAWA SGM series Bedienungsanleitung

Sinope

Sinope Calypso RM3500ZB Bedienungsanleitung

Isimet

Isimet DLA Series Style 2 Installationshandbuch

LSIS

LSIS sv-ip5a Bedienungsanleitung

Airflow

Airflow Uno hab Bedienungsanleitung

ABB

ABB ACS580-01 drives Bedienungsanleitung

Panasonic

Panasonic GM1 Series Bedienungsanleitung

Emerson

Emerson SW93 Bedienungsanleitung

AutoAqua

AutoAqua Smart ATO micro SATO-120P Bedienungsanleitung

Panasonic

Panasonic FP? Positioning Unit RTEX Bedienungsanleitung

Alpha IP

Alpha IP MIOB 21001 Bedienungsanleitung

Siemens

Siemens OpenAir GMA 1 Series Bedienungsanleitung

Surecom

Surecom SR-629 Bedienungsanleitung

Regulus

Regulus SRS1 T Bedienungsanleitung

3M MicroTouch EX113 Bedienungsanleitung

KUHN

KUHN TKS Bedienungsanleitung

S&C

S&C PMH Bedienungs- und Wartungshandbuch