ATTENTION: Unpack the unit and confirm all hardware are present. If any hardware required is missing, or if
you have any questions regarding our products, please contact D2G customer service at 844-221-3388.
Assemble the unit on a carpeted floor or on a soft surface work area to avoid any scratch. A phillips screw driver
is needed. 2 people recommended.
1. Insert 2 cam posts (H2) into holes in Panel E. Tighten only
until snug. Fit cam holes in the edge of Panel F over the cam
posts. Insert 2 cam locks (H1) into cam lock holes on Panel F,
use a phillips screw driver to turn cam locks clockwise to
secure cam posts.
DO NOT over-tighten.
2. Insert 4 cam posts into holes in Panel D as shown below.
Attach Panel C and assembled Panel E to Panel D by inserting
cam posts into the cam lock holes. Insert 2 cam locks into cam
lock holes on Panel E, turn cam locks clockwise with a phillips
screw driver to secure cam posts.
Fix Panel C the same way.
H1
Cam Lock H2
Cam Post
E
How to join 2 boards with CAM lock:
(a) (b) (c)
PARTS
A Top Panel
B Side Panel
C Middle Panel
1pc
2pcs
1pc
1pc
1pc
1pc
1pc
H1 Cam Lock
H2 Cam Post
H4 Concealed Hinge
H6 Screw
30pcs
30pcs
12pcs
2pcs
1pc
2pcs
ASSEMBLY INSTRUCTIONS
TRASH RECEPTACLE - CIRCULAR TOP OPENING
1 of 2
