Distianert HC300A Bedienungsanleitung

ENG-1

Distianert

Wild Camera

HC300A

Instruction Manual

ENG-2

Table of Contents

1. Instructions .................................................................................................................. 3

1.1 General Description........................................................................................... 3

1.2 Camera Body Interface ...................................................................................... 3

1.3 Camera components and features .................................................................... 3

1.4 Remote Control ................................................................................................. 3

1.4.1 Navigating ................................................................错误!未定义书签。

1.5 Shooting Information Display............................................................................ 4

1.6 Supported Format ............................................................................................. 5

2. Cautions ....................................................................................................................... 5

3. Easy Operation ............................................................................................................. 6

3.1 Power Supply..................................................................................................... 6

3.2 Insert the SD-card.............................................................................................. 6

3.3 Power on and Enter into the ON Mode............................................................. 6

3.4 Enter into the TEST Mode.................................................................................. 7

3.4.1 Custom Settings ...................................................................................... 7

3.4.2 Manual Capturing ................................................................................... 7

3.4.3 View Images or Videos ........................................................................... 7

3.5 Power Off........................................................................................................... 7

4. Advanced Operations................................................................................................... 8

4.1 Settings Menu.................................................................................................... 8

4.1.1 Photo Setting........................................................................................... 8

4.1.2 Video Setting........................................................................................... 9

4.1.3 System Setting......................................................................................... 9

4.1.4 Default................................................................................................... 10

4.1.5 General Settings .................................................................................... 10

4.1.6 Set Camera Mode ................................................................................. 10

4.1.7 Format SD-Card..................................................................................... 10

4.1.8 Set Photo Size........................................................................................ 11

4.1.9 Set Video Size........................................................................................ 11

4.1.10 Set Date and Time ................................................................................ 11

4.1.11 Set Multi ............................................................................................... 11

4.1.12 Set ISO .................................................................................................. 11

4.1.13 Set Video Length .................................................................................. 12

4.1.14 Set Video Sound ................................................................................... 12

4.1.15 Set Delay............................................................................................... 12

4.1.16 Set Timer .............................................................................................. 12

4.1.17 Enter Password..................................................................................... 12

4.2 Playback........................................................................................................... 13

4.2.1 Viewing Photo or Video........................................................................ 13

4.2.2 Delete Photo or Video .......................................................................... 13

4.3 File Numbering................................................................................................ 13

4.4 Firmware Upgrade........................................................................................... 13

Appendix Ⅰ: Technical Specifications ................................................................................. 14

Appendix Ⅱ: Parts List…………………………………………….………………………………………………14

ENG-3

1. Instructions

1.1 General Description

This digital trail camera is a surveillance camera working automatically. It can be

triggered at once by any movement of human (or animals) in a certain region of

interested (ROI) monitored by a high sensitive Passive Infrared (PIR) motion sensor, and

then automatically captures high quality pictures (up to 12M pixels) or records 1080p HD

video clips (WVGA or QVGA).

At sunrise the unit begins to take color photos and video until there is insufficient light

(dusk) when it begins to take infrared (monochrome) photos and video.

It is easy to use, there is a 2.0 inch colorful LCD display on camera. It is resistant against

water and snow for outside uses.

1.2 Camera Body Interface

The camera has the following I/O interfaces: USB connector, SD-card slot, TV output.

Take a few moments to familiarize yourself following the camera controls and displays. It

is helpful to bookmark this section and refer to it as you read through the rest of the

manual.

1.3 Camera components and features

1) Bottom cover

2) SD-Card slot

3) USB connector

4) TV out connector

5) PIR

6) Infrared flash

7) Lens

8) 2 inch color LCD Display

9) Sound recorder

10) Lock

11) Power switch

12) Battery depot

13) Portable remote controller

1.4 Remote Control

ENG-4

Note: Press the punctuation “ ” for laser light.

Note(Under TEST mode):

1. Press “Shot”directly, the camera will take picture or video directly.

2. Press “OK”directly, the picture or video recorded can be viewed.

3. Viewing picture, press “Up”or “Down”.

4. Viewing video, press “Left”to start, again to stop, press “OK”to return.

ENG-5

1.5 Shooting Information Display

When the camera is turned on (the power switch is slid to TEST position), the shooting

information will be displayed in the monitor.

1.6 Supported Format

Item

Format

Photo

JPG

Video

AVI

File Format

FAT32

Here are some important notices. You don’t need to concern about the file system

format of the camera unless you have problems with reading the SD-card by your other

equipment. If this happened, please format the SD-card in the camera or in a computer

at first and then reinsert the card into your camera to make a try.

2. Cautions

The working voltage of the camera is 12.0V. The camera is supplied by eight AA batteries.

Please unlock the write-protect before inserting the SD-card.

Please insert the SD-card when the power switch is at OFF position before testing the

camera.

Please do not insert or take out the SD-card when the power switch is at ON position.

It is recommended to format the SD-card by the camera when used at the first time.

The camera will be in USB mode when connected to a USB port of a computer. In this

case, the SD-card functions as a removable disk.

Please ensure sufficient power when having firmware upgrade, otherwise the upgrade

process could be interrupted incorrectly. If any fault occurs after improper upgrading

process, the camera may stop function properly.

ENG-6

3. Easy Operation

3.1 Power Supply

To supply power for the camera, four or eight AA size batteries are needed.

Open the bottom cover. Confirm that the power switch is at the OFF (Right) position, pull

out the battery depot. Load the fully charged batteries into the depot according the

polarities sign shown below. Push back the battery compartment to the battery

chamber.

The following batteries with 1.5V output can be used:

1. High-density and high-performance alkaline batteries (Recommended)

2. Rechargeable NiMH batteries

When in Test Mode, camera will be automatically shut down to save power if without

any operation within 3 minutes; it could be waked up by any movement detection.

When in low-battery state, camera will be also automatically shut down. Please change

the batteries in time.

3.2 Insert the SD-card

Insert SD-card into the card slot with marked side upwards.

Please note that the SD-card can only be plugged in one direction. Make sure that the

write-protect switch of the SD-card is on the “write” position.

3.3 Power on and Enter into the ON Mode

Before switching on, please pay attention to the following:

1. Avoid temperature and motion disturbances that could be construed as animals

or humans such as trees that are exposed to direct sunlight for much of the day

or any other heat source. These may cause false triggers.

2. The height from ground for placing the camera should 1 meter with the object.

For example for deer waste height is good size appropriately. In general, one to

two meters are preferred.

Slide the power switch to the ON position to power on the camera and enter into the ON

mode.

After switching on the camera, the motion indication LED (red) will blink for about 15s.

The 15s is a buffering time before automatic capturing photos or videos, e.g. for closing

and locking the bottom cover, fixing the camera on a tree and walk away.

In ON mode, the camera will take pictures or videos automatically according to the

default settings or previous custom settings. The camera has the sound recording

function, so the sound will be embedded in the video clip while capturing a video.

ENG-7

3.4 Enter into the TEST Mode

Slide the power switch to the TEST position to enter into the TEST mode. There are some

functions in TEST mode: Custom settings, manual capture, preview.

3.4.1 Custom Settings

Press the MENU switch to enter into menu setting. The camera can be taken over control

to manually customize the camera settings which display on the camera or external TV

monitor. The detailed operations will be described in “Advanced Operations” chapter.

3.4.2 Manual Capturing

You can press OK to manually capture photos or recording video.

3.4.3 View Images or Videos

There are two ways to view the captured images or videos:

1. LCD screen on camera.

2. TV monitors which connects to camera with TV cable.

Turn right the select switch to view images, the latest image will be shown in the LCD

screen on camera or TV monitor. Press UP to view the previous image and press DOWN

for the next. The detailed operations like deleting images or videos will be described in

“Advanced Operations” chapter.

3.5 Power Off

Slide the power switch to OFF position to power off the camera. Please note that even in

the OFF mode, the camera still consumes certain power at µA level.

Therefore, please remove the battery if the camera will not be used for a long time.

ENG-8

4. Advanced Operations

From the basic operations of the camera in previous chapter, we know that the camera

has three basic operation modes:

1. OFF mode: Power switch is at OFF position (Right).

2. ON mode: Power switch is at ON position (Left).

3. TEST mode: Power switch is at TEST position (Middle).

In the above three modes, the OFF mode is the specified safe mode when replacing the

SD-card or batteries and transporting the camera.

This chapter explains the advanced operations for customizing the camera settings. The

settings can only be customized in TEST mode and the remote control is needed.

4.1 Settings Menu

To view the camera settings menu, press MENU in the TEST mode (called settings menu

in this chapter).The settings menu will be shown on the LCD on camera or the external

TV monitor.

4.1.1 Photo Setting

ENG-9

4.1.2 Video Setting

4.1.3 System Setting

ENG-10

4.1.4 Default

Default Settings are listed as below:

Setting

Default

Items

Mode

Camera

Camera, Video, Camera&Video

Resolution

(Camera)

12MP, 8MP ,5MP Interpolated

Interval

1 Seconds

1-30 Seconds,1-30 Minutes

Multi

Single

Single,3,6,9 Pictures

ISO

200

100,200,400

Resolution

(Video)

1080P

1080P, 720P, WVGA ,QVGA

Video Length

10s

10s,30s,60s,90s

Date/Time

Same as last time

YY/MM/DD,MM/DD/YY,DD/MM/YY

Adjust

Distance

High

High, Normal, Low

Language

English

English, French, Germany, Spanish ,

Russian, Danish, Dutch, Poland,

Portuguese, Swedish, Italian, Finnish

Timer

0 0 0 to 23 59 59

Adjust

Format

Internal Memory

Internal Memory, SD Card

TV Mode

NTSC

NTSC,PAL

Password

Off

Off, On

4.1.5 General Settings

The operating steps are suitable for following menu items: Camera Mode, Photo Size,

Video Size, Multi, Video Length, Delay, and Timer.

4.1.6 Set Camera Mode

There are three camera modes: Camera, Video and Camera + Video. The way to set the

camera mode is via setting menu.

The following shows how to set camera mode to Video, provided that the previous

option is Photo:

a) Press MENU to display the setting menu.

b) Press DOWN to select Mode.

c) Press RIGHT to select Video.

d) Press down the select switch to save the current setting.

Press MENU to cancel setting and return to info display.

4.1.7 Format SD-Card

The system will delete all images or videos stored in the SD-card after formatting, make

sure that you have made a backup of important data.

a) Press MENU to display the setting menu.

b) Press RIGHT to select System setting.

c) Press DOWN to select Format.

d) Press RIGHT to select SD Card.

e) Press down the select switch to choose Enter to enter into submenu.

f) Press down to select OK. OK will be highlighted.

g) Press OK to start formatting the SD-card. During formatting, the display screen

will show a message “Please Wait” as below.

Press MENU to cancel setting and return to info display.

Please Wait!

Inhaltsverzeichnis

Andere distianert Digitalkamera Handbücher

distianert

distianert DH-8 Bedienungsanleitung

Beliebte Digitalkamera Handbücher anderer Marken

Mercury

Mercury 350K Bedienungsanleitung

Pentax

Pentax Optio LS 465 Bedienungsanleitung

Sanyo

Sanyo VPC-S1085 Bedienungsanleitung

GE SMART A1255 Bedienungsanleitung

Point Grey

Point Grey Gazelle Bedienungsanleitung

Nikon

Nikon COOLPIX A Bedienungsanleitung

Pentax

Pentax P-5 Bedienungsanleitung

BlazeVideo

BlazeVideo A280 Bedienungsanleitung

Sony

Sony MCA-20 Bedienungsanleitung

Sony

Sony Alpha DSLR-A290 Bedienungsanleitung

ATIK Cameras

ATIK Cameras One Bedienungsanleitung

CohuHD Costar

CohuHD Costar 3930 Series Bedienungsanleitung

Leica

Leica M10-R Bedienungsanleitung

FujiFilm

FujiFilm FinePix A700 Bedienungsanleitung

Lorex

Lorex LNZ81P25 Series Bedienungsanleitung

GE J1470S Bedienungsanleitung

Sony

Sony A6700 Benutzerhandbuch

Canon

Canon EOS ELAN7 Bedienungsanleitung

distianert HC300A Bedienungsanleitung

Beliebte Digitalkamera Handbücher anderer Marken