DIVELINK COM-S01R Bedienungsanleitung
SCUBA WIRELESS VOICE
COMMUNICATION SYSTEM
OPERATOR’S MANUAL
MODEL COM-S01R
All Models
Surface Unit
Table of Contents
INTRODUCTION ...........................................................................1
Determining the Options and Capabilities of your Model........2
OPERATING INSTRUCTIONS......................................................4
Orientation...........................................................................................4
Battery Pack ........................................................................................5
How to charge the Surface Unit.........................................................7
Transducer...........................................................................................8
Power ON and Volume Control..........................................................9
Push To Talk Button...........................................................................9
Audio Outputs.....................................................................................9
OPERATING TIPS..............................................................................10
CARE AND MAINTENANCE ..............................................................10
WHAT TO EXPECT WHEN COMMUNICATING UNDERWATER
.....................................................................................................11
Range Considerations ........................................................................12
Two Channel Units (COM-S01 with OPTION-2CH-xxS)..........13
TECHNICAL SPECIFICATIONS.................................................15
WARRANTY................................................................................16
SERVICING.................................................................................18
Contact Information.............................................................................18
Warranty/Repair Conditions ................................................................18
Sending Procedure .............................................................................18
Rev 06/18
COM-S01R (All Models) Surface Units
1
INTRODUCTION
Congratulations! You have just purchased the most advanced sport
communicator on the market.
The model COM-S01R is a PUSH TO TALK wireless transceiver for
underwater communication between the surface vessel and SCUBA divers
equipped with a DIVELINK communicator.
The COM-S01R Surface Unit is worn on the head as a headset with a boom
microphone. The headset has two ear muffs to reduce unwanted sound in a
noisy environment.
DIVELINK employs the latest in micro-electronics technology, and has been
engineered to be as simple to use as possible. There are no adjustments to
slow you down. DIVELINK is fully automatic.
COM-S01R (All Models) Surface Units
2
Determining the Options and Capabilities of your Model
The Head Mount Surface Unit Model COM-S01R comes with two
battery options and other parts that may also be ordered separately:
Powered by Alkaline Batteries
This Surface Unit comes with
MIC-S01 detachable microphone,
XDR-S01 transducer on 10 meter
cable, and BAT-S01 battery holder
for 8 AA alkaline cells:
BAT-S01 XDR-S01
(batteries not included)
Powered by Rechargeable Pack
COM-S01R shown with battery pack
undergoing charge while inside earcup.
Also included is a rechargeable
battery pack BAT-S01R-NIMH
and charger CHG-QC1-UNIV
COM-S01R (All Models) Surface Units
3
At the time of ordering, the following options can be selected:
OPTION
-1CH-BS 1 channel Surface Unit with Public Safety Frequency
-1CH-CS 1 Channel Surface Unit with 32768 Hz Ref. Frequency
-2CH-ABS 2 Channel Surface Unit with
Channel 1: 31250 Hz, Channel 2: Public Safety
-2CH-ACS 2 Channel Surface Unit with
Channel 1: 31250 Hz, Channel 2: 32768 Hz
-2CH-CBS 2 Channel Surface Unit with
Channel 1: 32768 Hz, Channel 2: Public Safety
Check the model number and options by looking at the serial number
sticker, which can be found inside the battery earcup:
COM-S01R (All Models) Surface Units
4
OPERATING INSTRUCTIONS
Orientation
The Surface Unit has one earphone in the same ear cup as the volume
control, microphone and push to talk button. You can wear the Surface Unit
with the earphone on the left or right side of the head.
The Surface Unit uses a "Push To Talk" button. If you are right handed, you
may want to place the ear cup with the push to talk button over the left ear.
You will then have a free right hand while using the left hand to press the
push to talk button.
The headset has two
microphone jacks. The boom
microphone plugs into one of the two jacks
that suit placement of the earphone on the left
or right side of the head. The boom microphone
may also be unplugged for storage or replacement.
When speaking, ensure that the side marked
"TALK" is directed towards your mouth.
MIC-S01
COM-S01R (All Models) Surface Units
5
Battery Pack
When operating, a LOW
POWER BEEP will sound
every 8 seconds when the
battery is almost
discharged.
The battery compartment is
in one ear cup. Batteries
may be accessed by pulling
off the ear muff pad and
removing the battery pack.
Your Surface Unit contains
the AA Alkaline battery
holder BAT-S01. Install
fresh alkaline AA cells.
BAT-S01 BAT-S01
(empty) (loaded)
Make sure that all battery
cells are loaded with the
correct polarity. If they are
incorrectly loaded, the low power
beep tone will be heard.
Caution: Please do not attempt
to connect any other battery or
external power to the terminals.
The warranty will be voided if
power other than the Surface Unit
battery pack is applied to the
power terminals. In particular,
over 12.5 volts is not to be
applied to the terminals.
COM-S01R (All Models) Surface Units
6
If instead you want to use the rechargeable system, then you use the
rechargeable pack BAT-S01R-NIMH and the DIVELINK charger
CHG-QC1-NIMH.
BAT-S01R-NIMH is a matched cell battery pack with an energy
management system to allow fast charging.
BAT-S01R-NIMH CHG-QC1-UNIV
Rechargeable Battery Specifications
Model BAT-S01R-NIMH
Battery Type: Nickel Metal Hydride
Battery Rating: 1650 mAH matched cells
Battery Life: Over 9 hours.
Amperage: Up to 300 mA continuous
current is available.
Short circuit protected.
Voltage: 9.6 Volts under load
at full charge.
The battery pack clips onto the
button terminals and is placed inside
the battery compartment.
The felt cover is replaced over the
battery with the button hole located
at the top for the purpose
of recharging.
The battery pack is protected
by a resettable fuse.
CHARGE STATUS LIGHTS
20% 40% 60% 80% 100% Charged
RED AMBER AMBER AMBER GREEN GREEN
COM-S01R (All Models) Surface Units
7
How to charge the Surface Unit
There is no need to remove the battery pack from the earcup. Plug your
charger CHG-QC1-NIMH into the mains power, then look for the button hole
in the battery ear cup. Plug the DC power plug into the battery pack and
wait until the charge lights indicate full charge (may be seen if the battery
pack is removed).
Make sure that the Surface Unit is OFF while charging.
Also charge the battery in a cool environment. Direct sunlight will overheat
the battery and it will not accept a charge until cool enough.
Do NOT immerse the battery pack. Doing so will void the one year
warranty.
COM-S01R (All Models) Surface Units
8
Transducer
Uncoil the transducer cable and put the transducer into the water. Place the
transducer at the same depth as the diver, or as deep as possible but not
right on the ocean floor. Secure the cable to the side of the vessel. Allow
yourself sufficient cable to move about.
1. Apply a small coating of grease, such as Dow Corning® 4 Electrical
Insulating Compound, onto the contacts of the extension cable plug.
2. Plug the transducer into the connector at the bottom of the ear cup.
Caution: The transducer is most subject to damage
when it is attached to the extension cable, as it can
swing easily and hit objects while being lowered into
the water. Particular care must be taken to avoid this
occurrence.
3. Lower the transducer into the water and position it below the
thermocline. If there are excessive currents in the area, or if
operating while under way, attach a small weight to the transducer
to prevent it from drifting upwards or away from the boat.
Inhaltsverzeichnis
Andere DIVELINK Konferenzsystem Handbücher
Beliebte Konferenzsystem Handbücher anderer Marken
Kramer
Kramer VIA GO Bedienungsanleitung
AVT
AVT MAGIC AC1 Go Bedienungsanleitung
ProSoft Technology
ProSoft Technology AN-X4-AB-DHRIO Bedienungsanleitung
Sony
Sony PCS-I150 Bedienungsanleitung
Middle Atlantic Products
Middle Atlantic Products VTC Series Bedienungsanleitung
Prentke Romich Company
Prentke Romich Company Vanguard Plus Leitfaden
