©2013 DJI Innovations. All Rights Reserved. - 6 -
The Ground end: 73mmx47.8mmx17.1mm
The Air end: 49.8mmx36.4mmx11.4mm
The Ground end: 93g The Air end: 32g
The Ground end: 9.9V-25.2V The Air end: 6V
Working Current (The Ground end)
Working Current (The Air end)
3.3 FAQ
2.4G Bluetooth Datalink Failure
The Ground Station fails to connect with the Main controller, please check the following items
The distance between the two ends of the 2.4G Bluetooth Datalink should be more than 1.5m.
Make sure the Ground end is connected correctly and the LED indicator of BTU is green.
If above are ok please power cycle, while this problem continues after powering cycle, there may be hardware
problems such as the Antenna is broken, please contact your authorized dealer.
3.4 Statements
FCC statement:
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications
or changes to this equipment. Such modifications or changes could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
CE statement
Due to the used enclosure material, the devices shall only be connected to a USB.
Interface of version 2.0 or higher. The connection to so called power USB is prohibited.
Hereby, SZ DJI TECHNOLOGY CO. LTD declares that this device is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC.
When using the device, ensure that the antenna of the device
is at least 20cm away from all persons.
