DMXPEN Control Box Bedienungsanleitung
Manual / UK 1 DMXPEN ControlBox
INDEX
Introduction .................................................................. page 3
Warnings ...................................................................... page 4
Description ................................................................... page 5
SetUp / Connections ...................................................... page 6
Tec nical Specification ................................................... page 7
Input Circuit .................................................................. page 9
Output Circuit ............................................................... page 10
PIN Assignment ............................................................ page 10
Device Configuration ..................................................... page 12
Remote Control ............................................................ page 17
Warranty ...................................................................... page 18
Maintenance / Cleaning ................................................. page 18
Manual / UK 2 DMXPEN ControlBox
INTRODUCTION
T anks to buy t is DMXPEN series products.
A correct use of t is product, will ensure a correct functionality, a long life and at t e
same time will avoid product failure.
Please read t is manual carefully and be sure to understand t e information provide to
ensure a safe and reliable application, to learn a suitable knowledge of t e product and
is necessary precaution before using it.
Manual / UK 3 DMXPEN ControlBox
WARNINGS
1. T is manual describes t e DMXPEN ControlBOX operating functions. T e user must
operate t e product according to t e performance specifications described in t e
operation manuals.
2. W ile every effort as been made to ensure t at t e information on t is manual is
accurate and complete, we would appreciate any errors or omissions submitted to
our attention.
3. Maintenance, inspection, and replacement of parts must be performed only by
aut orized personnel.
4. We reserve t e rig t to c ange t e specifications of t e ardware and software
described in t is manuals at any time and wit out prior notice.
5. Do not use DMXPEN ControlBOX wit wet finger and do not place water on t e
touc panel.
6. After t e package opening, please make t is c eck:
• T e received product correspond wit t e ordered one.
• No part are missing on t e received product.
• T e product is not damaged.
• Contact immediately a DMXPen distributor in case of fault.
Manual / UK 4 DMXPEN ControlBox
DESCRIPTION
DMXPen ControlBOX device as t e following features:
–DMX512 Signal Recording and Playback
–ArtNet Signal Recording and Playback
–ArtNet - DMX Conversion
–DMX - ArtNet Conversion
–Recording and Playback remote control t roug et rnet port
–Playback remote control t roug MIDI port
–Recording and Playback control t roug touc panel user interface
–On board ROTARY SWITCH and grap ic display allow system control and set up
–8 digital / analog input
–4 digital output
–2 analog output
–2 RS485 port
–2 RS232 port
–1 MicroSD card
Briefly t e DMXPen products mission is record and carry easily:
“Design your s ow, record and
bring wit you”.
W y recording?
T e first goal of a professional lig t programmer is to select a lig t desk and
learn to use it in t e best way, because t is means freedom of expression and productivity.
T e DMXPen products range improve t is concept taking care of recording w at t e lig t
programmer realize w it is preferred equipment.
W y carry?
Often t e lig t programmer presence is not necessary during t e s ow playback, so
e can realize t e s ow and record it so t e user as only t e duty to activate is playback (i.e.
fair boot , s op, club, etc.)
Moreover doing t is wit a normal lig t desk, mean carry eavy or expensive equipment t at
usually are not so familiar to t e users (i.e. barman, custodian, etc.).
T is is anot er issue improved from t e DMXPen products because contains only t e s ow
engine wit a simple user interface at a very low cost.
Manual / UK 5 DMXPEN ControlBox
SET UP/CONNECTION
Wire t e needed line and t e power supply on t e provided removable connector (be
sure t at t e screw up is correct). Be sure to ave t e microSD card inserted on t e
socket (t e product is supplied wit t e microSD card inserted on t e socket).
Note: t e device do not as a main ON/OFF switc and is necessary remove power
supply to make maintenance.
Technical Specification
Features
–8 digital/analog INPUT
–4 digital OUTPUT
–2 analog OUTPUT
–2 RS485
–1 MIDI IN
–1 MIDI OUT
–2 RS232
–1 micro SD Card
–1 Et ernet Port
Manual / UK 6 DMXPEN ControlBox
Technical Specification
Dimension ( L x W x H ) 200 x 160 x 88 mm
Weig t 260 gr.
Material / finis ing Aluminium / Black Oxide
Degree protection IP 30
Operating Relative Humidity : from 30% to 85% wit out condensation
Operating Temperature -5°C + 50°C
DMX IN Connector 5 pole XLR Neutrik male
DMX OUT Connector X5 pole XLR Neutrik female
Et ernet Connector RJ45 Neutrik
Power Supply 12-24 VDC – 500 mA
DIGITAL INPUT
- NPN/PNP configurable
- 24 VDC INPUT max.
- 8 c annel s ared wit analog INPUT
ANALOG INPUT
- 10 bits converter
- 10 VDC INPUT max.
- 8 c annel s ared wit digital INPUT
DIGITAL OUTPUT
- 4 c annel
- low RDSon (<0.015 O m) mosfet
- 24 VDC max.
- 20 A max. peak
- 4 A max. continuos
- current monitor s ared wit analog INPUT
ANALOG OUTPUT
- 2 c annel
- 8 bits converter
- 10 VDC OUTPUT max.
- 100 mA OUTPUT max.
RS485
- 2 Optocoupled full duplex c annel
- 500 Mbps max. communication speed
- 1 c annel s ared wit RS232
RS232
- 2 full duplex c annel
- 500 Mbps max. communication speed
- 1 c annel s ared wit RS485
MIDI - 1 MIDI IN port
- 1 MIDI OUT port
MicroSD card - 1 MicroSD card socket
- FAT16 file system
Et ernet - IEEE 802.3 10Base – T Et ernet interface
Power supply - 12-24 VDC
- 200-500 mA
standard reference
EN 55022, EN 61000-4-2, EN 61000-4-4, EN 61000-4-5,
EN 61000-4-6, EN 61000-4-11, EMC 89/336/CEE,
BT 73/23/CEE
Manual / UK 7 DMXPEN ControlBox
Manual / UK 8 DMXPEN ControlBox
10982
7 6 5 4
12113 13 141
1. Rotary Switc
2. RS232
3. Et ernet
4. Slot for MicroSD card
5. DMX IN/OUT
6. MIDI IN/OUT
7. POWER IN
8. DIGITAL/ANALOG INPUT
9. I OUT MEASURE ENBLE
10. DAC
11. DIGITAL OUTPUT
12. INPUT CONFIG
13. 2° RS485
14. COM1 - COM2
INPUT CIRCUIT
T e analog/digital inputs can be configured as NPN type or PNP type t roug t e on board Input
Configuration Jumper. T e equivalent input circuits for all 8 input are:
Manual / UK 9 DMXPEN ControlBox
Figure 2: Equivalent Input Circuit wit Input Configuration =
PNP
Figure 1: Equivalent Input Circuit wit Input
Configuration = NPN
OUPUT CIRCUIT
T e digital outputs are open drain mosfet and t e equivalent output circuits for all 4 output are:
A clamp diode for inductive load is internally provided and we suggest to connect t e positive load to
t e +V OUT COM as indicated in t e figure above. Maximum positive load voltage is 24VDC.
PIN ASSIGNMENT
Manual / UK 10 DMXPEN ControlBox
Figure 3: Equivalent Digital Output circuit
MIDI
Pin Description
1 MIDI IN+
2 MIDI IN-
3 MIDI OUT-
4 MIDI OUT+
Power Supply
Pin Description
1 GND
2 12-24VDC
DMX – SCREW PLU
Pin Description
1 DMX+
2 DMX-
3 GND
2nd RS485
Pin Description
1 RS485+
2 RS485-
3 GND
Inhaltsverzeichnis
Beliebte Steuereinheit Handbücher anderer Marken
Festo
Festo Compact Performance CP-FB6-E Stücklistenhandbuch
Elo TouchSystems
Elo TouchSystems DMS-SA19P-EXTME Bedienungsanleitung
JS Automation
JS Automation MPC3034A Bedienungsanleitung
JAUDT
JAUDT SW GII 6406 Series Kurzanleitung
Spektrum
Spektrum Air Module System Bedienungsanleitung
BOC Edwards
BOC Edwards Q Series Bedienungsanleitung
