5. Mount the adjustment pieces in the frame pieces by sliding the fixture into the groove of
the frame piece and orientate the hook-end toward the middle of the screen. Mount the
same number of adjustment pieces as there are eyelets in the screen material. Do the
same for each top/bottom piece and in each side frame piece. If your screen has vertical
support(s) remember to slide in the square M6 nut(s) in between the fixtures at correct
place. Example: If there is one vertical support and eight eyelets, the square M6 nut for
the vertical support must have four fixtures at each side.
6. For the wall mounts: Mount two M6 nuts in each side of the top frame piece (outside the
adjustment pieces) by sliding them into the groove. Mount one M6 nut in the top of each
side frame piece (above the adjustment pieces).
7. Slide an inner corner bracket into each end of the side frame pieces; four in total.
8. Assemble the frame by sliding the inner corner brackets from the side pieces into the top-
and bottom frame pieces. Do one side at a time. Mount loosely first, then affix by
tightening the M6x20 Allen bolts.
9. Distribute the adjustment pieces evenly along the top, bottom and sides.
10. Take out carefully the screen roll from the box – do not unroll it!
11. Make sure that the image area is facing out (a serial number label is placed in the upper
right corner on the rear side, not visible from the front). If the screen has been rolled
incorrectly, contact your Supernova dealer before you proceed.
12. Open the film roll carefully until the top or side metal rod is accessible (depending on the
screen size the film is rolled either horizontally or vertically)
13. Mount the top or the side of the film by placing the metal rod in the hooks at each eyelet
in the film. Tighten slightly.
14. Unroll the film carefully without kinking or scratching the front- or backside surface,
15. Mount the bottom or opposite side of the film by placing that metal rod in the hooks at
each eyelet in the film. Tighten slightly.
16. Slide the missing metal rods into the unused rod pockets of the film.
17. Mount the hooks in the frame pieces to the metal rods at each eyelet in the film. Do one
side at a time.
18. Adjust the adjustment pieces around the screen until the film is in correct position.
19. Tighten the adjustment pieces around the screen to make a perfect flat image area.
20. Snap the cover strips onto the back of the frame pieces (a small rubber hammer is
recommended but is not imperative). Remember to make space for the cover corners.
21. Snap the cover corners onto the back of the frame corners (a small rubber hammer is
recommended but is not imperative).
22. Attach the wall mounts onto the rear side of the frame in both top corners by screwing the
M6x20 bolts into the M6 nuts previously inserted in the frame pieces (section 6).
23. The screen is now assembled and ready to be mounted on the wall.
