INSTALLANON . INSTRUCTION
DOMETIC HEATER KIT . A7OO1 1
Remove control panel from air distribution box. Disas-
semble air box housing by removing six #B X 112" Lg.
screws. Slide therrnobulb out from holder and remove six
#B X 1 /2' Lg. screws holding cei I ing retainer plate in place.
Disassemble control box from channel supports by remov-
ing four #BX 1/2' Lg. blunt point screws (See Fig. 1). Let
control box hang down inside coach.
BLUNT PT. SCREIYS
L G, SC RE Y/S
AIR BOX
THUMBSCREWS
Flgure 1
Tilting heater upward (See Fig. 2) slide through channel
supports and base pan. Position heater onto weld studs
provided on partition (See Fig. 4). While holding heater in
place with one hand, attach hex nuts to weld studs. Tighten
down nut with ratchet. Using right hand, grasp heater plug
and insert into connector located on paitition. Note: lf plug
does not insert, rotate 1B0o (See Fig. 3).
rJ
@
Ftgure 2
After heater is installed, reattach control box to channels
being sure to use four #B X 112" Lg. blunt point screws.
Reassemble ceiling plate, air box housing and control
panel respectively. Make sure to place thermobulb back
into holder.
F ilf.^lER QiECTOR B-UG
Ftgure 7
