Do not use fluxes containing chloride or acid. Use only rosin or activated resin fluxes.
Do not use any compound or anti-seize materials
Handle the heated soldering iron with extreme care, as the high temperature of the iron can cause fires or
painful burns.
Never file the specially-plated tip.
Maintenance
This tool must be placed on its stand when not in use.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly
qualified person in order to avoid hazard.
Operation
1)File off any dirt, rust or paint on the part you wish to solder.
2)Heat the part with the soldering iron.
3)Apply rosin-based solder to the part and melt it with the soldering iron.
Note: when using non-rosin-based solder, be sure to apply a soldering paste to the part before applying the solder.
4)Wait for the solder to cool and harden before moving the soldered part.
Tip replacement
Note: Tip replacement or cleaning should be done only when the iron is at room temperature or below.
After removing the tip, remove any oxide dust that may have formed in the tip retaining area of the barrel. Be
careful to avoid getting dust in your eyes. Care should be taken not to over tighten as this would damage the
element.
General cleaning
The outer case of the iron or station may be cleaned with a damp cloth using small amounts of liquid detergent.
Never submerse the unit in liquid or allow any liquid to enter the housing. Never use solvent to clean the case.
Warning
The appliance is not a toy, and must be kept out of children’s hands.
Before cleaning the appliance or changing the filter, always unplug it. Unscrewing the housing is not
permitted.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
