DR. Heater DR-910M Bedienungsanleitung

10,000W/240V GARAGE HEATER WITH CART

OWNER’S MANUAL

Model No.: DR-910M

10,000W 240V60Hz

IMPORTANT INSTRUCTIONS

READ & SAVE

TABLE OF CONTENTS

Important Instructions……………………………………….3

Installation Instructions………………………. ……………5-7

Specifications and Wiring Diagram ……………………….8

Parts of the Heater……………………….…………..……...9

Operating Instructions……………………….………....…...10

Maintenance and Cleaning………………………………...11

Troubleshooting…………………………………………….. 12

Warranty……………………………….............……………..13

IMPORTANT INSTRUCTIONS

PLEASE READ ALL INSTRUCTIONS BEFORE USING THIS

HEATER

NOTE: There may be a trace of smoke or odor when unit is first

operated. Don’t be alarmed. This indicates that a drop of oil

fell on the heating coil during the manufacturing process. It will

quickly evaporate and should not re-occur.

Make sure that the room in which the appliance is located is

well ventilated during this operation. It is normal for the

appliance to emit small cracking sounds when you turn it on

for the first time. Do not be alarmed.

WHEN USING ELECTRICAL APPLIANCES, BASIC

PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE

RISK OF FIRE, ELECTRICAL SHOCK, AND INJURY TO

PERSONS OR PROPERTY, INCLUDING THE FOLLOWING:

1) Read all instructions before using this heater.

2) This heater is hot when in use. To avoid burns, do not let bare

skin touch hot surfaces. Keep combustible materials, such as

furniture, pillows, bedding, papers, clothes, and curtains at least 3

feet (0.9 m) from the front of the heater and keep such materials

away from the sides and rear.

3) Extreme caution is necessary when any heater is used by or

near children or disabled persons and whenever the heater is left

operating and unattended.

4) Always switch off the heater when not in use.

5) Do not operate any heater after the heater malfunctions or has

been dropped or damaged in any manner. Disconnect power at

service panel and have heater inspected by a certified/licensed

electrician before reusing.

6) Do not use outdoors.

7) To disconnect heater, turn off power to heater circuit at main

disconnect panel.

8) Keep at least 4.5 inches (0.12m) from the back wall.

9) Do not insert or allow foreign objects to enter any ventilation or

exhaust opening as this may cause an electric shock or fire and

potentially damage the heater.

10) To prevent a possible fire, do not block air intakes or exhaust in

any manner.

11) A heater has hot and arcing or sparking parts inside. To reduce

the risk of fire, do not use in areas where gasoline, paint, or

flammable vapors and liquids are used or stored.

12) Use this heater only as described in this manual. Any other use

not recommended by the manufacturer may cause fire, electric

shock, or injury to persons.

13) This product must be installed by a certified/licensed electrician,

in accordance with applicable local codes.

14) For supply cables, use 6 AWG (13.3 mm2) copper wires.

SAVE THESE INSTRUCTIONS

WARNING –RISK OF FIRE, DO NOT USE AS A RESIDENTIAL

OR HOUSEHOLD HEATER.

WARNING: All wiring must be installed by a certified/licensed

electrician. The heater must be grounded in accordance with

applicable national and local building codes.

WARNING: To reduce the risk of fire, do not store or use gasoline

or other flammable vapors and liquids in the vicinity of the heater.

All wiring procedures and connections should be in

accordance with applicable national and local codes.

NOTE: Compatible with a 240V Line Voltage Double Pole Wall

Thermostat. Must be installed by a certified/licensed electrician.

Before installation:

Disconnect the main supply connection.

Supply cables should be 6 AWG (13.3 mm2) copper wires.

The heater must be connected to an individual branch circuit

protected by a 60 Amp circuit breaker only.

Supply cables must be equipped with a dual pole circuit breaker

rating at least 240V 60A/pole as main cutoff switch of power

connection to the heater.

Wiring compartment for accommodating supply cables and pigtail

leads are adequate and measured free space of 2524.67 cm3.

Tools/ Materials Needed (Not Included):

·Regular Screwdriver Set

Unpacking Contents：

·Heater

·Owner's Manual

·Warranty Card

·Heater Handle

INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS:

1. Do not install closer than 1 foot (or 0.3 m) to any adjacent

vertical surfaces or walls.

2. Keep at least 4.5 inches (0.12m) from the back wall (regardless

of whether the wall mount bracket is used).

3. Insert the hand hold and tighten the screws.

4. Run the electrical power supply cable in flexible conduit and

connect to the wiring compartment via the knock-out at the rear

of the heater.

6. Make the connections properly with connectors which are

suitable for the conductor size, including ground wires. After

making the connections, arrange the pigtail leads of unit and

power supply wires in the wiring compartment.

10,000W/240V GARAGE HEATER WITH CART

Model: DR-910M

Voltage: 240 V

Watts: 10,000 W

Frequency: 60 Hz

Recommended Heating Capacity: 1.25watts / ft³(0.03m³)

Thermostat Temperature Range: 37˚F~104˚F (3˚C~40˚C)

SPECIFICATIONS

PARTS OF THE HEATER

A. Hand Hold

B. Upper Housing

C. Louver for air

direction

D. Lower Housing

E. Tilt Adjustable

Knob

F. Wheel

G. Control Panel

H. ON/OFF Switch

I. Thermostat

Adjustment Knob

WARNING - The heater must be properly installed before it is

used.

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR

ARC FLASH:

Apply appropriate personal protective equipment (PPE)

and follow safe electrical work practices. See NFPA 70.

A circuit breaker must be installed and serviced only by

qualified electrical personnel.

Always use a properly rated voltage sensing device to

confirm power is off.

The switch on the heater is to start the Fan and Heater.

Use the circuit breaker as power ON/OFF for the

heater. The circuit breaker is to be installed by a

certified/licensed electrician and should be located in

line of sight from the heater location or should be

capable of being locked in open position. Follow the

operating instructions to reduce the risk of fire,

electric shock, injury, or death to persons.

Switch on the circuit breaker.

To turn off the heater, switch off the circuit breaker.

The circuit breaker serves as the power source for

the heater.

This heater includes a visual alarm to warn that parts of the

heater are getting excessively hot. If the alarm flashes,

immediately turn the heater OFF and inspect for any objects on

or adjacent to the heater that may cause high temperatures. DO

NOT OPERATE THE HEATER WITH THE ALARM FLASHING.

To reset the heater, switch the circuit breaker OFF. Then, wait

five to ten minutes for the heater to cool down before turning the

heater on again.

OPERATING INSTRUCTIONS

Inhaltsverzeichnis

Andere DR. Heater Heizung Handbücher

DR. Heater

DR. Heater DR-838 Bedienungsanleitung

DR. Heater

DR. Heater Elite Series Bedienungsanleitung

DR. Heater

DR. Heater DR-988 Bedienungsanleitung

DR. Heater

DR. Heater DR-975 Bedienungsanleitung

DR. Heater

DR. Heater DR-PS11024 Bedienungsanleitung

DR. Heater

DR. Heater DR-968 Bedienungsanleitung

DR. Heater

DR. Heater DR-238EU Bedienungsanleitung

DR. Heater

DR. Heater DR-928 Bedienungsanleitung

DR. Heater

DR. Heater DR-233 Bedienungsanleitung

DR. Heater

DR. Heater DR-338 Bedienungsanleitung

DR. Heater

DR. Heater DR-910F Bedienungsanleitung

DR. Heater

DR. Heater DR-908 Bedienungsanleitung

DR. Heater

DR. Heater DR-966 Bedienungsanleitung

DR. Heater

DR. Heater DR-239 Bedienungsanleitung

DR. Heater

DR. Heater DR-222 Bedienungsanleitung

DR. Heater

DR. Heater DR-999 Bedienungsanleitung

DR. Heater

DR. Heater DR-368 Bedienungsanleitung

DR. Heater

DR. Heater DR-966 Bedienungsanleitung

DR. Heater

DR. Heater DR218-1500 Installationsanleitung

DR. Heater

DR. Heater DR-101 Bedienungsanleitung

DR. Heater

DR. Heater DR-P130 Bedienungsanleitung

DR. Heater

DR. Heater DR-238 Bedienungsanleitung

DR. Heater

DR. Heater DR-968H Bedienungsanleitung

DR. Heater

DR. Heater DR-368 Bedienungsanleitung

Beliebte Heizung Handbücher anderer Marken

oventrop

oventrop Regucor Series Bedienungsanleitung

Blaze King

Blaze King CLARITY CL2118.IPI.1 Bedienungsanleitung

ELMEKO

ELMEKO ML 150 Bedienungsanleitung

BN Thermic

BN Thermic 830T Bedienungsanleitung

KING

KING K Series Leitfaden

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Kurzanleitung

Well Straler

Well Straler RC-16B Bedienungsanleitung

EUROM

EUROM 333299 Bedienungsanleitung

Heylo

Heylo K 170 Bedienungsanleitung

Eterna

Eterna TR70W Bedienungsanleitung

Clarke

Clarke GRH15 Bedienungsanleitung

IRSAP

IRSAP The Radiator Company Ovali Bedienungsanleitung

Empire Heating Systems

Empire Heating Systems WCC65 Bedienungsanleitung

Wetekom

Wetekom 92 86 43 Bedienungsanleitung

Desa

Desa SPC170-F Bedienungsanleitung

Watlow

Watlow Watrod Electric Tubular Heaters Bedienungsanleitung

Haverland

Haverland ECO-DRY GPS Series Stücklistenhandbuch

Stelpro

Stelpro ASILVC2060 Series Bedienungsanleitung