ARGO - INSTRUCTION FOR INSTALLATIO
he roof duct can be used for either a slopin
he roof duct can be supplied with an adhesive plate for a flat roof or with a universally ad
ustable tile for a sloping roof
nstall the concentric system as
➠
Construct the system from the (connection stub of the) appliance u
at least 50 mm between the outside o
stem and the walls and/or the ceiling;
the system is built-into a cove
or example, incombustible material should be applied all around
- Use heat-resistant insulating material for ducts made of combustible material
Some heat-resistant isolation materials contain volatile com
ed time; these are not suitable
e concentric pipe sections an
screw in places which will be inaccessible a
ter installation;
➠
Use enough brackets to ensure that the weight of the pipes does not rest on the appliance;
➠
Determine the remaining length o
- Make sure the universal roo
- Make sure the adhesive ashing sticks to the at roof properly
6.5.4 Connection to an existing flu
he appliance can also be connected to an existin
flexible SS pipe is placed in the chimne
for connection to an existin
if the special DRU chimne
.6 Building the chimney breas
cient space around the appliance to ensure a good heat distribution
breast should be ventilated b
- Use incombustible and heat-resistant material to construct the chimne
breast, including rear wall o
- The total free vent area of the vents, installed as high as possible, should be at least 200 c
ollowing points should be taken into account (see Fig. 2
the control box: this should be placed within 850 mm to the le
the appliance, as low as possible
- size of the control box; see section 8.2 Installing the control box
the glass window so that it can be
tted/removed once the chimney breast has been built;
- protecting the gas control block and hoses from cement and plaster
!Tip The vents should pre
be created in both sides o
ou could use DRU ventilation elements
➠
Check that the concentric system has been installed correctly
➠
Check that the clamping strips have been secured with self-tapping screws in places which will be inaccessible later
cient clearance round the appliance in the chimne
breast to enable the heat to disperse:
- minimum internal hei
rom the appliance could cause cracks
- it will then be impossible to remove/t the glass window
materials similar to stone, or is
nished with plaster, it should be dried-out at least 6 weeks
be
, in order to prevent cracks
