Chapter 1 Installing VG6000 Digital Gateway
Plug in the cord of your monitor, keyboard and mouse to the appropriate
socket on the rear panel of VG6000.
Step 3. Connecting to LAN
You need to connect VG6000 to your existing Ethernet network. Connect
an Ethernet cable from the network RJ45 port on VG6000 to any
10/100BaseT RJ45 port on a switching hub.
The default IP settings of VG6000 are as follows. You may change it to
conform to your network later.
Default IP Address: 192.168.1.206
Default Gateway: 192.168.1.254
Default Subnet Mask: 255.255.0.0
Step 4. Connecting Trunk Cables
Attach a cable from DSC/CSU equipment provided by your carrier or a
PBX’s T1/E1 interface if you prefer to set a tie line to a T1/E1 interface on
VG6000.
Pin signals for connecting to DSC/CSU (DB-15) provided by your carrier
RJ-48 Pin
(on T1/E1 PIC)
(Data numbering form)
DB-15 Pin
(Data numbering
form)
Signal
1 11 RX/Ring/- <-->RX/Ring/-
2 3 RX/Tip/+ <-->RX/Tip/+
4 9 TX/Ring/- <-->TX/Ring/-
5 1 TX/Tip/+ <-->TX/Tip/+
3 4 Shield/Return/Ground
6 2 Shield/Return/Ground
Pin signals for connecting to other PBX’s T1/E1 interfaces to set a Tie
Line
RJ-48 Pin
(on T1/E1 PIC)
(Data numbering form)
RJ-48 Pin
(Data numbering
form)
Signal
1 4 RX/Ring/- <-->TX/Ring/-
2 5 RX/Tip/+ <-->TX/Tip/+
4 1 TX/Ring/- <-->RX/Ring/-
