DSPPA DSP40I Bedienungsanleitung

[email protected] /www.dsppatech.com The specifications will be subject to change without prior notice.

DSP40I Invisible Speaker System

The DSP40I is a 40W invisible speaker that can be radiated in all directions. Thanks to the special driver unit

and special material used in the surface cover, DSP40I can perform with wonderful sound when it is installed

inside the wall or ceiling.

Totally invisible. When installed in the wall or ceiling and furnished with paint, the DSP40I can be integrated

with the surroundings and be totally invisible. It is an ideal choice for industrial and commercial applications

in shopping malls, office building and museums where background music and paging is needed.

Input 70V/100V

Wide Freq. Response: 100Hz -20 kHz

Max SPL:103±2dB

High sensitivity:87±2dB

Totally invisible, installed in the wall or ceiling

Excellent sound quality, for installation in high-end places

Model

DSP40I

Freq. Response

100Hz -20 kHz

Sensitivity (1w/1m)

87±2dB

Dimension

300mm×400mm×52mm

Input Voltage

70V/100V

Normal Power

20W/40W

[email protected] /www.dsppatech.com The specifications will be subject to change without prior notice.

Coverage

The S.P.L fall-off

Conventional Cone Loudspeaker DSPPA Flat Panel

Max SPL

103±2dB

Weight

1.7 kg

[email protected] /www.dsppatech.com The specifications will be subject to change without prior notice.

Installation

1. Cut a small aperture where needed to install and measure the distance

between the frames; make sure there is enough space to avoid the frame

behind the wall in order to put the back cover in.

2. Mark lines to confirm the position with the additional cardboard

(304mm×404mm).

3. Cut the aperture according to the marked lines by a saw or knife (as

figure A).

4. Pull the audio line through the hole of back cover.

5. Put one side of back cover into the hole then put the whole back cover.

6. Fasten down the installation surface and back cover as figure B (each side fasten 4 additional screws,

totally 8).

7. Connect the audio wire to the terminal of speaker.

8. Push the surplus audio wire out to avoid getting in touch of speaker’s

back.

9. Connect the speaker to the back cover; make sure there is 2mm distance

between the speaker and the edge and whether the speaker is at the

same level (as figure C).

10. Please test the speaker immediately: first of all check the impedance on

the other side, then test audio frequency with scanning signal in order to

confirm whether there are noises from the surface of speaker, back cover

or neighboring surface.

Figure A

Figure B

Figure C

[email protected] /www.dsppatech.com The specifications will be subject to change without prior notice.

11. Putty the crack between the speaker and the installation surface.

12. Cover speaker and the crack with seaming mesh (as figure D).

13. Paint a 2mm depth putty on the whole installation surface (as figure E).

14. Test speaker once again.

15. After the test is over and when your plasterwork is completely dry, decorate the surface of the plaster

with paint, wallpaper, fabric or other coatings as required.

Figure D

Figure E

Inhaltsverzeichnis

Andere DSPPA Lautsprechersystem Handbücher

DSPPA

DSPPA DSP107 Bedienungsanleitung

Beliebte Lautsprechersystem Handbücher anderer Marken

JVC

JVC CA-MXK5R Bedienungsanleitung

LG NB4532B Bedienungsanleitung

JVC

JVC CA-FSH100 Bedienungsanleitung

5Core

5Core Pro Series Bedienungsanleitung

EAW

EAW MQV1394e Bedienungsanleitung

Lynx

Lynx GXR-LA10A Bedienungsanleitung

iLive

iLive ITB066B Bedienungsanleitung

RDX

RDX QuickStation 4 Bedienungsanleitung

Electro-Voice

Electro-Voice S-122 Bedienungsanleitung

Sven

Sven SPS-619 GOLD Bedienungsanleitung

Pioneer

Pioneer CS-7070 Bedienungsanleitung

EAW

EAW UB82e Bedienungsanleitung

Sondpex

Sondpex Active Speaker System and Digital Music... Bedienungsanleitung

JVC

JVC NX-PN7 Bedienungsanleitung

Yamaha

Yamaha NX-A01 - Speaker Sys Bedienungsanleitung

SE Audiotechnik

SE Audiotechnik I-LINE Bedienungsanleitung

Gemini

Gemini WRX-843 Series Bedienungsanleitung

TCL

TCL 6100 Series Bedienungsanleitung