DTK PRM-0080I Bedienungsanleitung

PRM-0080I VBX

High Performance

Pentium II PCI Mainboard

User’s Guide

Edition 1.00

P/N: 155100-8692

WARNING

For the system to operate normally, please make sure J6 of the mainboard is set as below. Refer

to Fig. 2 in this manual for the location J6.

If J6 is shorted to 2-3, no CMOS data can be retained.

CAUTION

The motherboard is an electrostatic sensitive device. Don’t open or handle except at a static-

free workstation.

POWER OFF

It needs to hold the power switch 4 seconds to turn off the power.

Windows, MS-DOS, and MS Word are trademarks of Microsoft Corporation.

Novell, Netware are trademarks of Novell, Inc.

Lotus, 1-2-3, and Symphony are trademarks of Lotus Development Corporation.

PC, AT, PC-DOS, OS/2 and Presentation Manager are trademarks of IBM Corporation.

UNIX is the trademark of AT&T.

Intel i82440LX and Pentium II are registered trademark of Intel Corporation.

All other brand and product names are trademarks or registered trademarks of their respective

companies.

The information presented in this publication has been carefully checked for reliability; however,

no responsibility is assumed for inaccuracies, whereas, specification is subjected to change

without notice.

CONTENTS

CHAPTER 1 INTRODUCTION 5

CHAPTER 2 JUMPER SETTINGS 7

2.1 JUMPERS PRESENTATION 7

2.2 GRAPHICAL DESCRIPTION OF JUMPER SETTINGS 8

2.3 J4 - CPU CLOCK SPEED 9

2.4 J6 - CLEAR CMOS DATA 9

2.5 J2 - VOLTAGE SELECTION FOR SYSTEM ROM 10

2.6 MEMORY CONFIGUARTION 10

CHAPTER 3 CONNECTOR CONFIGURATION 11

3.1 JP1 - IrDA CONNECTOR 12

3.2 JP8 - ATX POWER SUPPLY CONNECTOR 12

3.3 JP10 - FLOPPY DRIVE CONTROLLER 12

3.4 JP11, JP12 - PRIMARY/SECONDARY IDE CONNECTORS 13

3.5 JP13 - HDD LED 13

3.6 JP14 - POWER ON/OFF SWITCH 13

3.7 JP15 - POWER LED 13

3.8 JP16 - RESET 13

3.9 JP17 - SPEAKER 14

3.10 JP18 – LAN WAKE UP CONNECTOR 14

3.11 JP20 – SB LINK CONNECTOR 14

3.12 CPU FAN, SYSTEM FAN - FAN CONNECTOR 15

3.13 PS/2 KEYBOARD CONNECTOR 15

3.14 PS/2 MOUSE CONNECTOR 15

3.15 UNIVERSAL SERIAL BUS PORT 0 & 1 16

3.16 SERIAL PORT COM1 & COM2 16

3.17 PARALLEL PORT CONNECTOR 16

3.18 RETENTION MECHANISM KITS INSTALLATION GUIDE 16

CHAPTER 4 AWARD BIOS SETUP GUIDE 22

4.1 AWARD BIOS SETUP 22

4.2 STANDARD CMOS SETUP 24

4.3 BIOS FEATURES SETUP 25

4.4 CHIPSET FEATURES SETUP 27

4.5 POWER MANAGEMENT SETUP MENU 29

4.6 PCI CONFIGURATION 31

4.7 INTEGRATED PERIPHERALS SETUP MENU 33

4.8 LOAD SETUP DEFAULTS MENU 35

4.9 SUPERVISOR PASSWORD 35

4.10 USER PASSWORD 36

4.11 IDE HDD AUTO DETECTION 36

4.12 SAVE & EXIT SETUP MENU 36

III

4.13 EXIT WITHOUT SAVING MENU 36

CHAPTER 5 FLASH AND DMI UTILITY 37

5.1 AWARD FLASH UTILITY 37

5.2 DESKTOP MANAGEMENT INTERFACE (DMI) OVERVIEW 39

APPENDIX A QUICK GUIDE 43

CHAPTER 1 INTRODUCTION

Preface

The motherboard is a 4 layer, ATX form factor high performance PCI/AGP mainboard. It

includes VIA Apollo Pro chipset, Winbond W83977TF Super I/O controller.

Features

Processor

•Intel Pentium II and Celeron series.

•The mainboard can run with following speeds: 233-450MHz

Chipset

•VIA VT82C691 (PCI A.G.P. Controller)

•VIA VT82C596 (PCI ISA IDE Xcelerator)

•Winbond W83977TF (Super I/O Controller)

•Optional Winbond W83781D (System Voltage & Temperature Monitoring IC)

Main Memory

•Memory configurations up to 768MB SDRAM.

•DIMM socket for 3.3V SDRAM (PC/100 DIMM) or EDO (For 66MHz Front Size Bus

CPU Only).

•ECC Function ensures data correction and integrity.

Multi I/O

•On board Multi-I/O supports two serial, one parallel ports and floppy drive controller.

•Serial ports are 16550 Fast UART compatible.

•Parallel port has EPP and ECP capabilities.

•PS/2 keyboard and PS/2 mouse connector is provided.

•IrDA supported.

•USB supported.

Accelerated Graphics Port (AGP) Interface

•A.G.P. specification compliant

•A.G.P. 66/133MHz devices supported

PCI IDE

•On board supports PCI Master IDE Controller, two connectors support up to four IDE

devices such as HDD, CD ROM drive and Tape Back-up drives, etc.

•PCI Master IDE controller supports PIO Mode 3 and 4 devices, I/O data transfer rate can be

up to 16.6MB/s.

•Ultra DMA Mode supported. Transfer rate can be up to 33MB/s.

Chapter 1

System BIOS

•Award BIOS (128KB Flash EPROM).

Slots

•One AGP slot

•Four PCI slots (1 shared)

•Two ISA slots(1 shared)

Form Factor

•Full ATX Size (305mm x 180mm) 4 Layer

Fig. 1 Key Components of the Mainboard

SLOT 1

PCI 1

PCI 2

PCI 3

PCI 4

SYSTEM BIOS

ISA SLOT 1

ISA SLOT 2

Battery

DIMM 1

DIMM 2

DIMM 3

FDD

IDE 0 IDE 1

ATX POWER

CONNECTOR

USB

Parallel

COM 2 COM 1

W83977TF

AGP SLOT

9,$

97&

9,$

97&

:'

36 0286(

 .(<%2$5'

CHAPTER 2 JUMPER SETTINGS

2.1 JUMPERS PRESENTATION

Pins 1 and 2 are shorted with a jumper cap.

1 2 3

Pins 2 and 3 are shorted with a jumper cap.

1 2 3

The jumper is shorted when the jumper cap is placed

over the two pins of the jumper.

The jumper is open when the jumper cap is removed

from jumper.

Jumpers Convention

Different color of jumper caps (mini-jumpers) are used on the board to represent

different usage of the jumpers:

Red: CPU Clock setting

Black: Other

Chapter 2

2.2 GRAPHICAL DESCRIPTION OF JUMPER

SETTINGS

Fig. 2 Jumper Location of the mainboard

Jumper Settings

2.3 J4 - CPU CLOCK SPEED

The table below summaries the Pentium II Processor frequence and settings of each

jumper of the motherboard.

CPU Freq. Front Size

Bus Freq. Ratio Rating Setting

233MHz 66MHz

Pentium II 350MHz 100MHz 3.5x J4: 1-2 open

3-4 open

5-6 close

266MHz 66MHz

Pentium II/

Celeron 400MHz 100MHz 4.0x J4: 1-2 close

3-4 close

5-6 open

300MHz 66MHz

Pentium II/

Celeron 450MHz 100MHz 4.5x J4: 1-2 open

3-4 close

5-6 open

Pentium II/

Celeron 333MHz 66MHz 5.0x J4: 1-2 close

3-4 open

5-6 open

Celeron 366MHz 66MHz 5.5x J4: 1-2 open

3-4 open

5-6 open

Table 1: Jumper Setting

Reserve for future support

2.4 J6 - CLEAR CMOS DATA

J6 is used to clear the content of the CMOS Data in the RTC (build in PIIX4E chip).

Table 2: Clear CMOS Data

Chapter 2

2.5 J2 - VOLTAGE SELECTION FOR SYSTEM ROM

J2 is used to select the operation voltage of the system ROM.

Table 3: Voltage Selection for System ROM

2.6 MEMORY CONFIGUARTION

When 100MHz Front Size Bus Pentium II Processor is used. SDRAM DIMMs with

PC/100 specification and Serial Presence Defect (SPD) data structure are required.

For 66MHz Front Size Bus Pentium II Processor, SDRAM or EDO DIMM may be

used. Don’t use both SDRAM and EDO DIMM at the same time.

To enable the Error Checking and Correction (ECC) feature of the chipset. ECC

DIMM has to be used and the “DRAM Data Integrity Mode” on BIOS Chipset

Features Setup Menu has to be set to “ECC”.

Three DIMM sockets are provided for the 3.3V SDRAM or EDO:

DIMM1 - used memory rows 0 and 1

DIMM2 - used memory rows 2 and 3

DIMM3 - used memory rows 4 and 5

Table 4 provides the typical memory configurations supported by the mainboard.

Rows 0/1 (DIMM1) Rows 2/3 (DIMM2) Rows 4/5 (DIMM3)

Installed None None

None Installed None

None None Installed

Installed Installed None

Installed None Installed

Installed None None

None Installed Installed

None Installed None

None None Installed

Installed Installed Installed

Table 4

The maximum memory size is up to 768MB. The size of each DIMM can be 8MB,

16MB, 32MB, 64MB, 128MB or 256MB.

Andere Handbücher für PRM-0080I

Inhaltsverzeichnis

Andere DTK Hauptplatine Handbücher

DTK

DTK PAM-0057V Bedienungsanleitung

DTK

DTK PAM-0035S Bedienungsanleitung

DTK

DTK PRM-0084I ZX Bedienungsanleitung

DTK

DTK PAM-0050S Bedienungsanleitung

DTK

DTK PAM-0073I Bedienungsanleitung

DTK

DTK PAM-0075I Bedienungsanleitung

DTK

DTK PRM-0080I Bedienungsanleitung

DTK

DTK PTM-1230C Bedienungsanleitung

DTK

DTK PAM-0066I Bedienungsanleitung

DTK

DTK PRM-20I Bedienungsanleitung

DTK

DTK PRM-0074I Bedienungsanleitung

DTK

DTK PRM-0031I Bedienungsanleitung

DTK

DTK PAM-0067V E1 Bedienungsanleitung

DTK

DTK PRM-13i Bedienungsanleitung

DTK

DTK PRM-0077I Bedienungsanleitung

DTK

DTK PAM-0057I Bedienungsanleitung

DTK

DTK PIM-TB10 Bedienungsanleitung

DTK

DTK PRM-89I Bedienungsanleitung

DTK

DTK PRM-0084I VBX Bedienungsanleitung

DTK

DTK PRM-0076I Bedienungsanleitung

DTK

DTK PAM-0079V Bedienungsanleitung

DTK

DTK PRM-0080I Bedienungsanleitung

DTK

DTK PRM-0081I Bedienungsanleitung

DTK

DTK PAM-0070S Bedienungsanleitung

Beliebte Hauptplatine Handbücher anderer Marken

DFI

DFI SD170 Bedienungsanleitung

ASROCK

ASROCK ROMED8-2T Bedienungsanleitung

Asus

Asus P2L97A Bedienungsanleitung

Winmate

Winmate IC70 Bedienungsanleitung

Asus

Asus MES-B Bedienungsanleitung

Grantech

Grantech SYS8F377VGGA-3OMN Bedienungsanleitung

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Bedienungsanleitung

Gigabyte

Gigabyte GA-9IVDT Bedienungsanleitung

Texas Instruments

Texas Instruments ADS8372EVM Bedienungsanleitung

Commell

Commell MS-C73 Bedienungsanleitung

IBT Technologies

IBT Technologies MB860 Bedienungsanleitung

Nvidia

Nvidia TEGRA DG-04927-001_V01 Bedienungsanleitung

Biostar

Biostar M7VIT Bravo Bedienungs- und Montageanleitung

Intel

Intel D33217CK Bedienungsanleitung

Asus

Asus F1A55-M LX PLUS R2.0 Bedienungsanleitung

EPC

EPC EPC9147C Bedienungsanleitung

Asus

Asus EX-B760M-V5 D4 Bedienungsanleitung

EPOX

EPOX MU-8KHA0010 Bedienungsanleitung