DTS PROFLO LED 200 CT Bedienungsanleitung

Le informazioni contenute in questo documento sono state attentamente redatte e

controllate. Tuttavia non è assunta alcuna responsabilità per eventuali inesattezze.

Tutti i diritti sono riservati e questo documento non può essere copiato, fotocopiato,

riprodotto per intero o in parte senza previo consenso scritto della D.T.S .

D.T.S. si riserva il diritto di apportare senza preavviso cambiamenti e modifiche

estetiche , funzionali o di design a ciascun proprio prodotto. D.T.S non assume alcuna

responsabilità sull’uso o sull’applicazione dei prodotti o dei circuiti descritti.

The information contained in this publication has been carefully prepared and

checked. However, no responsibility will be taken for any errors. All rights are

reserved and this document cannot be copied, photocopied or reproduced, in part or

completely, without prior written consent from D.T.S.

D.T.S. reserves the right to make any aesthetic, functional or design modifications to

any of its products without prior notice. D.T.S. assumes no responsibility for the use or

application of the products or circuits described herein.

Les informations contenues dans le présent manuel ont été rédigées et contrôlées

avec le plus grand soin. Nous déclinons toutefois toute responsabilité en cas

photocopié ou reproduit, dans sa totalité ou partiellement, sans le consentement

préalable de D.T.S.

D.T.S. se réserve le droit d'apporter toutes modifications et améliorations esthétiques,

fonctionnelles ou de design, sans préavis, à chacun de ses produits. D.T.S. décline

toute responsabilité sur l'utilisation ou sur l'application des produits ou des circuits

décrits.

Las informaciones contenidas en este documento han sido cuidadosamente

redactadas y controladas. Con todo, no se asume ninguna responsabilidad por

eventuales inexactitudes. Todos los derechos han sido reservados y este documento

no puede ser copiado, fotocopiado o reproducido, total o parcialmente, sin previa

autorización escrita de D.T.S.

D.T.S. se reserva el derecho a aportar sin previo aviso cambios y modificaciones de

carácter estético, funcional o de diseño a cada producto suyo. D.T.S. no se asume

responsabilidad de ningún tipo sobre la utilización o sobre la aplicación de los

productos o de los circuitos descritos.

INDEX:

1- SYMBOLS.................................................................................................................4

2- GENERAL WARNING ..............................................................................................4

3- GENERAL WARRANTY CONDITIONS....................................................................4

4- TECHNICAL FEATURES .........................................................................................5

5- ACCESSORIES ........................................................................................................6

6- IMPORTANT SAFETY INFORMATION....................................................................7

6.1 Fire prevention......................................................................................................7

6.2 Prevention of electric shock..................................................................................7

6.3 Safety...................................................................................................................7

6.4 Waste Electrical and Electronic Equipment directive............................................7

7- INSTALLATION........................................................................................................8

8- INPUT / OUTPUT CONNECTIONS...........................................................................9

9- DMX SIGNAL CONNECTION.................................................................................10

9.1 DMX Addresses..................................................................................................11

9.2 Selecting the DMX address................................................................................11

10- RDM FUNCTIONS ................................................................................................12

11- FIRMWARE UPDATING.......................................................................................13

12- DISPLAY FUNCTIONS.........................................................................................13

13- MANUAL MODE ...................................................................................................15

14- ERROR MESSAGES ............................................................................................16

15- DMX PROTOCOL.................................................................................................17

1- SYMBOLS

Graphic symbols used on this manual:

THIS SYMBOL INDICATES A HOT SURFACE

THIS SYMBOL INDICATES ELECTRIC SHOCK

RISK

THIS SYMBOL INDICATES GENERAL RISK

THIS SYMBOL INDICATES THE MAXIMUM

OPERATING AMBIENT TEMPERATURE

THIS SYMBOL MEANS “DO NOT STARE

AT THE OPERATING LIGHT SOURCE”

THIS SYMBOL INDICATES

PHOTOBIOLOGICAL SAFETY

THIS SYMBOL INDICATES THE EUROPEAN

COMMUNITY DIRECTIVE 2012/19/EC ON

WASTE ELECTRICAL AND ELECTRONIC

EQUIPMENT (WEEE)

2- GENERAL WARNING

Read the instruction contained in this user manual carefully, as they give important

information regarding safety during installation, use and maintenance.

The unit is not for residential use and must be installed by a qualified electrician or

experienced person.

Always disconnect the device from the mains before maintenance.

The device must always be equipped with an efficient ground connection.

3- GENERAL WARRANTY CONDITIONS

The unit is guaranteed for 36 months from the date of purchase against manufacturing

material defects.

4- TECHNICAL FEATURES

DTS product codes:

03.TP039.46 PROFILO LED 200 CT 5P BLACK

03.TP045.46 PROFILO LED 200 CT 3P BLACK

Output

Single high-power white LED with linearly tunable color temperature (2700K –6500K)

CRI > 90

LED lifespan: 50.000 hours (70% lumen output)

Optical group

15.5°- 38° linear zoom

High definition zoom lens with double optical condenser lens

Control

DMX 512 / RDM or Manual control

7 DMX channels (Default) or 2 DMX channels

4-digit 7-segment LED display + 4 soft keys

Internal operating system updatable via DTS Dongle Firmware Uploader

Power supply

Full-range 100-240Vac 50-60 Hz

Consumption: 200W Max

Connections

Power supply: PowerCON TRUE1 In&Out panel connectors

DMX: XLR 5 pins or XLR 3 pins In&Out panel connectors

Internal safety devices

Overvoltage and overtemperature circuits protection

Operating temperature

-10° / 40°C

Physical

IP20

Internal system with four removable shutters

Yoke featuring an exclusive sliding system with clutch for a wider tilt

Weight: 16 Kg

Certifications

DIMENSIONS

5- ACCESSORIES

On board

1 x Soft edge filter assembly (code 02TP0047)

1 x Filterframe black finishing (code 02M00420.49)

In the box

1 x PowerCON TRUE1 female cable connector (code 0520P066)

1 x XLR 5 pins female cable connector (code 0508B147)

1 x XLR 5 pins male cable connector (code 0508B148)

4 x Shutter blade assembly (code 02TP0045)

1 x User’s Manual

Optional (on request)

- Iris/diaphragm (code 03.TA225)

- Gobo holder (DTS Code 03.TA226)

- “C” Clamp G60 (Max. Load 50 Kg) (DTS Code 0521A004)

- Safety cable 3 mm x 60 cm, max capacity load 60 Kg (code 0521A010)

- DTS Dongle Firmware Uploader (code 03.LA.206)

6- IMPORTANT SAFETY INFORMATION

6.1 Fire prevention:

Replace any blown or damaged fuses only with those of identical value: T 3.15A 250V.

6.2 Prevention from electric shock:

High voltage is present inside the unit. Unplug the unit prior to performing any

operation which involves touching the inside of the unit.

This equipment must be grounded, do not connect to non-grounded supplies.

The use of a thermal magnetic circuit breaker is recommended for each PROFILO

LED 200 CT unit. Use only AC supplies 100-240V 50-60 Hz.

PROFILO LED 200 CT should never be located in position exposed to rain or in areas

of extreme humidity.

A good air ventilation is essential for proper equipment work.

6.3 Safety:

Risk Group 2 product according to EN 62471.

CAUTION. Do not look directly into the light output. May be harmful to the eyes and

skin.

Do not stare at the operating light source.

The luminaire should be positioned so that prolonged staring into the luminaire at a

distance of 6,71 m is not expected.

The light source contained in this luminaire shall only be replaced by the manufacturer

or his service agent or a similar qualified person.

The unit is not for household use and must be installed by a qualified electrician or

experienced person.

The external surface of the unit may exeed 70°C; never handle the unit until at least 5

minutes have elapsed since the unit was turned off.

Never install the unit in an enclosed area lacking sufficient air flow.

The ambient temperature should not exeed 40°C.

6.4 Waste Electrical and Electronic equipment (WEEE) directive:

The unit, accessories and packaging should be sorted for environmetal-friendly

recycling.

For EC countries: according to the European Directive 2012/19/EC for Waste

Electrical and Electronic Equipment and its implementation into national right,

luminaires that are no longer usable must be collected separately and disposed of in

an environmentally correct manner.

7- INSTALLATION

The unit is suitable for dry locations only.

PROFILO LED 200 CT can be installed on a truss or on the ceiling.

It is recommend the use of appropriate clamps to fix the unit to the mounting surface.

ATTENTION:

A safety cable (code 0521A010) must be securely fixed to the unit’s mounting bracket

and to the support structure of the projector as shown in the picture below.

Fixing clamps and safety cable are available on request.

8- INPUT / OUTPUT CONNECTIONS

9- DMX SIGNAL CONNECTION:

The unit operates using a digital DMX 512 signal.

Connection between the controller and the unit or between units must be carried out

using a two pair screened ø 0.5 mm.

Ensure that the conductors do not touch each other.

Do not connect the cable ground to the DMX connector chassis.

The plug housing must be isolated. Connect the mixer signal to the DMX IN projector

plug and connect it to the next projector by connecting the DMX OUT plug on the first

unit to the DMX IN plug of the second one.

In this way, all the projectors are cascade connected.

If the display showing the DMX address flashes, then one of the following errors has

occurred:

- DMX signal not present

- DMX reception problem

For Installations where long distance DMX cable connections are needed, we

suggest to use a DMX terminator.

The DMX terminator is a male XLR 3-5 pins connector with a 120 ohm resistor

Between pin 2 and 3.

The DMX terminator must be plugged into the last unit (DMX out panel connector) of

the DMX line.

PLACE A 120 OHM RESISTOR BETWEEN PIN 2

AND 3 OF A MALE XRL CONNECTOR AND PLUG IT

INTO THE DMX OUT PANEL CONNECTOR OF THE

LAST UNIT CONNECTED TO THE DMX LINE

OUT

120 ohm

PIN 3

PIN 2

Inhaltsverzeichnis

Andere DTS DJ-Equipment Handbücher

DTS

DTS SOPRANO Series Bedienungsanleitung

DTS

DTS Wonder D Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

DTS

DTS Synergy 7 Profile Bedienungsanleitung

DTS

DTS 03.MS014.EBLFP Bedienungsanleitung

DTS

DTS MINI BRICK Bedienungsanleitung

DTS

DTS BRICK Bedienungsanleitung

DTS

DTS SCENA LED 200 Series Bedienungsanleitung

DTS

DTS Portfolio Bedienungsanleitung

DTS

DTS XR250 WASH Bedienungsanleitung

DTS

DTS Titan HP Bedienungsanleitung

DTS

DTS ARTEMIO PROFILE Bedienungsanleitung

DTS

DTS Synergy 5 Spot Bedienungsanleitung

DTS

DTS XR2000 SPOT CMY Bedienungsanleitung

DTS

DTS SCENA LED 120 HQS Bedienungsanleitung

DTS

DTS X-BRICK Bedienungsanleitung

DTS

DTS Alchemy 7 Bedienungsanleitung

DTS

DTS XR2000 SPOT CMY Bedienungsanleitung

DTS

DTS ALCHEMY 5 Bedienungsanleitung

DTS

DTS SCENA LED 80 CT Bedienungsanleitung

DTS

DTS NICK NRG 1401 Bedienungsanleitung

DTS

DTS DOCTUS Series Bedienungsanleitung

DTS

DTS NICK NRG 1401 Bedienungsanleitung

DTS

DTS X BRICK Bedienungsanleitung

Beliebte DJ-Equipment Handbücher anderer Marken

ALPHA LITE

ALPHA LITE ALPHA 1500 Betriebsanleitung

Chauvet

Chauvet OVATION E-930VW Bedienungsanleitung

Snow Masters

Snow Masters Zig Oscillator Bedienungsanleitung

EuroLite

EuroLite 50530554 Bedienungsanleitung

Beamz

Beamz BUV243 Bedienungsanleitung

thomann

thomann Stairville DJ Lase 40-G MK-III Bedienungsanleitung

Eagletone

Eagletone 6 Eyes Flower Bedienungsanleitung

EuroLite

EuroLite FLD-1508 Bedienungsanleitung

Technical Pro

Technical Pro LG8xSEA Bedienungsanleitung

JB Systems

JB Systems Lounge Laser DMX Bedienungsanleitung

Lightmaxx

Lightmaxx Vega Halo 90 Bedienungsanleitung

Elation

Elation FUZE WASH Z350 Bedienungsanleitung

Maverick

Maverick MK3 WASH Bedienungsanleitung

Infinity

Infinity TF-260C7 Fresnel Bedienungsanleitung

Chauvet

Chauvet EVE E-50Z Bedienungsanleitung

Eliminator Lighting

Eliminator Lighting E 138 Bedienungsanleitung

EuroLite

EuroLite Mini Multicolor LED Flashing Light SC Bedienungsanleitung

KAM

KAM DMX Laser80 FScan Bedienungsanleitung