Dukane TS200 Bedienungsanleitung

Page 1 of 9

TECHNICAL MANUAL

ULTRASONIC TEST SET

MODEL TS200

April 20, 2001

REV 00

DUKANE CORPORATION

SEACOM DIVISION

DUKANE CORPORATION ST. CHARLES, ILLINOIS 60174

PHONE: 630-584-2300 FAX: 630-584-5154

DOCUMENT NO. 03-TM-0045 DUKANE CORPORATION

E-MAIL: [email protected] INTERNET: www.dukane.com

Page 2 of 9

This manual should be read in its entirety prior

to operation of the TS200 Test Set

03-TM-0045 REV 00

Page 3 of 9

Figures

FIGURE 1. ULTRASONIC TEST SET MODEL TS200.............................5

FIGURE 2. TESTING BEACON ..................................................................7

Tables

TABLE 1. TS200 ULTRASONIC TEST SET SPECIFICATIONS..............5

03-TM-0045 REV 00

Table of Contents

SECTION I .................................................................................. 4

GENERAL INFORMATION ...................................................... 4

1.1. INTRODUCTION .................................................................................4

1.2. GENERAL DESCRIPTION..................................................................4

SECTION II................................................................................. 6

OPERATION ............................................................................... 6

2.1. OPERATION .........................................................................................6

SECTION III ............................................................................... 8

MAINTENANCE........................................................................ 8

3.1. BATTERY LIFE ....................................................................................8

3.2. BATTERY REPLACEMENT ...............................................................8

3.3. TEST SET CALIBRATION ..................................................................8

SECTION IV ............................................................................... 9

WARRANTY TEST SETS.......................................................... 9

Page 4 of 9

SECTION I

GENERAL INFORMATION

1.1. INTRODUCTION

1.1.1. GENERAL. This manual contains the description, operation and

maintenance of the TS200 Ultrasonic Test Set manufactured by Dukane Cor-

poration, Seacom Division, 2900 Dukane Drive, St. Charles, Illinois 60174.

See Figure 1.

1.1.2. SYMBOLS AND ABBREVIATIONS. All symbols and abbrevia-

tions used in this manual are in accordance with the ANSI Y14.15 and

MIL-STD-12, respectively.

1.2. GENERAL DESCRIPTION

1.2.1 FUNCTION. The TS200 is a battery operated heterodyne type

receiver that operates at an ultrasonic frequency of 37.5 kHz. The test set

was designed primarily as a self-contained, hand-held functional tester for

testing underwater acoustic beacons. Utilizing the internal microphone and

loudspeaker, the Test Set can perform an operational test on Dukane Corpo-

ration DK Series beacons without removing the beacon from its mount on

the aircraft. The test set can also be used to perform a voltage measure-

ment to test the battery in a Dukane underwater beacon.

1.2.2. SPECIFICATIONS. The specifications for the TS200 are given in

Table 1.

03-TM-0045 REV 00

Page 5 of 9

TABLE 1. TS200

ULTRASONIC TEST SET SPECIFICATIONS

Size.......................................3.3" (8.4 cm) x 6.5" (16.5 cm) x 1.2" (3.0 cm)

Weight..............................…13 ounces (368 grams)

Battery*................................9V

* NEDA Type 1604A.

Figure 1. Ultrasonic Test Set Model TS200

03-TM-0045 REV 00

Page 6 of 9

SECTION II

OPERATION

2.1. OPERATION

A. Turn the test set ON using the small slide switch located on the left side

of the housing.

B. If the display reads LB the TS200 battery voltage has fallen below the

level required for operation of the test set and the 9-Volt battery should

be replaced. See Maintenance Section 3.2

C. Testing Beacon Voltage. Attach the test probe clip to the pinger case.

See Figure 2. The clip has a spring action that will allow it to slip over

the housing on the beacon. Place the tip of the probe in contact with the

silver pad on the white dome at the end of the beacon. The display will

show the battery voltage of the beacon. Refer to the appropriate beacon

manual for the acceptable range of the beacon battery voltage.

D. Operational Test. Place the probes on the beacon as described above

and press the red button on the TS200 (the test set display will be blank

during this operation). The beacon should activate and a pinging sound

will be audible from the TS200. Please note that high levels of back-

ground noise can interfere with this test. If difficulty is experienced in

hearing the beacon the operator should repeat the test in a quieter area.

03-TM-0045 REV 00

Page 7 of 9

Figure 2. Testing Beacon

03-TM-0045 REV 00

Page 8 of 9

SECTION III

MAINTENANCE

3.1. BATTERY LIFE

3.1.1 Thetestset batteryshould bereplacedwhen itsload voltagehasdropped

to 7 volts or the display reads LB when the test set is turned on.

3.2. BATTERY REPLACEMENT

3.2.1 Any 9-volt battery may be used, but longer service will be obtained by

the use of premium batteries such as NEDA Type 1604A. The battery is ac-

cessible in the Test Set by removing the battery access door on the bottom rear

of the case and dropping out the old battery. A snap type connector facilitates

change of battery and prevents reversal of polarity, but as an additional pre-

caution, always turn the test set off before making the battery change.

3.3. TEST SET CALIBRATION

3.3.1 The TS200 Test Set is calibrated at the factory during manufacture.

Under normal operating conditions the test set will not require calibration for

a period of one year. The calibration due date is shown on the back of the test

set.

3.3.2 For calibration procedures please contact Dukane Corporation or

refer to the calibration procedures in the CT200 manual.

03TM-0045 REV 00

Page 9 of 9

SECTION IV

WARRANTY TEST SETS

Dukane Corporation warrants that the Test Set (referred to as the unit) will be free from

defects in materials and workmanship, when used under normal operating conditions as

determined solely by Dukane Corporation, for a period of one (1) year from the date of

shipment from Dukane Corporation.

As the sole remedy for breach of the foregoing warranty, Dukane Corporation shall repair

or replace, at Dukane Corporation’s option, any unit, component or part thereof found

defective or nonconforming within said one (1) year period from the date of shipment.

Customer shall give Dukane Corporation notice of any defect of nonconformity and, if so

instructed by Dukane Corporation, customer shall, at it’s expense, ship the unit, compo-

nent or part to Dukane Corporation. If Dukane Corporation determines that the unit, com-

ponent or part or is actually defective or nonconforming, it shall, at it’s expense, ship a new

or a rebuilt unit, component or part to the customer. The customer shall be responsible to

perform, at it’s own expense, any necessary installation work related to any defective or

nonworking unit, component or part. The functionality and operational aspects of the unit

is determine by the unit operating within the specifications and is independent of proper

maintenance as required to be performed by the customer.

Dukane Corporation shall not be liable for the any expense or damages resulting from

interruptions in the operation of the unit.

Dukane Corporation shall not be liable for the cost of any repairs undertaken by the cus-

tomer or any third party without Dukane Corporation prior written authorization.

Dukane Corporation shall not be liable for any incidental, special consequential or exem-

plary damages arising out of the installation, use, testing, servicing or maintenance of any

unit, component or part. This warranty is given in lieu of all other warranties, express or

implied, included the warranties of merchantability or fitness for a particular purpose.

Dukane Corporation’s total liability under this warranty is limited to the remanufacture or

replacement of the unit, component or part.

03TM-0045 REV 00

Inhaltsverzeichnis

Andere Dukane Prüfgeräte Handbücher

Dukane

Dukane 42A12D Bedienungsanleitung

Beliebte Prüfgeräte Handbücher anderer Marken

SMART

SMART KANAAD SBT XTREME 3G Series Bedienungsanleitung

Agilent Technologies

Agilent Technologies BERT Serial Bedienungsanleitung

Agilent Technologies

Agilent Technologies N3280A Bedienungsanleitung

Vernier

Vernier Go Direct Voltage Bedienungsanleitung

Lifeloc

Lifeloc R.A.D.A.R. Bedienungsanleitung

Fluke

Fluke T5-600 Bedienungs- und Montageanleitung

Mercury

Mercury TSL01 Bedienungsanleitung

MAHA

MAHA MBT Series Bedienungsanleitung

Fuji Electric

Fuji Electric P-61 Bedienungsanleitung

ETC

ETC SealerAtor Bedienungsanleitung

Skyfine

Skyfine ETHYWAY V2 Bedienungsanleitung

Appion

Appion G5 Twin Bedienungsanleitung

PCB Piezotronics

PCB Piezotronics 8159-0112A Bedienungsanleitung

BW Technologies

BW Technologies MicroDock II Bedienungsanleitung

Sun Nuclear

Sun Nuclear 1027 Bedienungsanleitung

Biomark

Biomark HPR LITE READER Bedienungsanleitung

Hioki

Hioki 3169-20 Bedienungsanleitung

Ashcroft

Ashcroft ATE-100 Bedienungsanleitung