5. OPERATION OF REFRIGERATOR
● This wine cellar was designed for temp double control, in two totally
independent areas.
● The refrigerator inside temperature depends on the room temperature. The
refrigerator makes sure values from 9℃—18℃(±1°C) for upper zone and
6℃—12℃for lower zone, when, as an example, the cellar was placed in a
room with an ideal temperature of 25℃.
● By the first turn on, without putting any bottle inside the refrigerator, the product
can be cooled to 15° after 1.5 hours and after 2~2.5 hours more will reach to the
temperature programmed by the manufacturer.
● Turning the combo cooler on, the cooling system activates automatically.
● When the power is connected, cooling system starts to work.
● The temp you want for upper compartment can be set by touching sensor buttons
“ ” and “ ” with your finger. When the inside temperature higher than the
set point Cooling system will be working normally. When the inside temperature
is lower than the set point, the cooling system stop working then it starts
automatically again when temperature rises above the set point. At this point, the
refrigerator starts an automatic condition allowing a constant control of
temperature and energetic save, as a matter of fact during this phase, cooling
system stops while cold distribution (fans) turns more slowly and promote a
bigger energetic save.
● The Light can be turned OFF or ON by touching . If you forget to turn it off,
this will be automatically turned off after 10 minutes.
● The lower room temperature is controlled by the thermostat (pic. 4).
● The first time you turn the unit on, set the temperature control to “Max”. The
