4
To lock your safe
This safe will lock when you push the drawer to the closed position with your last
programmed 4-6 digit Personal Code.
To change your Personal Code, please see “Changing your Personal Code” on page 3.
To unlock your safe
1) Press to activate the safe. Enter your 4-6 digit Personal Code. The LED Display
will show O , then O . The locking bolts will dis-engage and the drawer will
eject instantly.
“Hidden Code” mode
Press to trigger the mode. The LED Display will flash o.
In this mode, the LED Display will flash when you key in your Personal Code.
To exit the mode, press . The LED Display will flash OFF.
“Hold” mode
The safe automatically enters a 30 minutes “Hold” mode after an invalid code has
been entered 3 consecutive times. In this mode, the safe will not respond to any key
and the LED Display will flash , where the 30 is the holding time.
After 30 minutes, the safe will return to normal operation.
Override Key
If the electronic lock fails, or you do not have the Personal Code or Master Code
available, you may use the Override Key to open the safe.
Remove the Key Lock Cap and insert the Override Key. Turn anti-clockwise and the
drawer will eject.
Reprograming safe lock after Override Key use
1) With the drawer in open position, turn Override Key clockwise to engage the
locking bolts.
2) Press the Personal Code Reset Button on the back of the front panel.
3) Enter your 4-6 digit Personal Code and press .
Changing your Master Code
1) With the drawer in open position, press and the Factory Master Code (159),
followed by . The LED Display will flash . You will hear 1 short beeps.
2) Enter your new 4-6 digit Master Code and press . When the LED Display flash
, enter your new Master Code and press . You will hear 2 short beeps.
When the LED Display flash , you had successfully changed the Master Code.
The Master Code will remain when you change the Personal Code.
