DWT Prio Expert MO580 Bedienungsanleitung
MO580
MO___
Reverse Osmosis
Filtration System
(Storage Tank,
Main Filtration Unit Set)
Prio®Expert
User’s Guide
2
Before operating this appliance, please read the instructions carefully. You
may want to save this guide for your future reference. Failure to follow the
instructions or meet the operating requirements may lead to the product’s
failure, malfunction, property damage or personal injury.
Safety Warning
■Plug the ltration unit into an electrical outlet only aer you nish the in-
stallation.
■Check if the voltage indicated on the ltration unit or power adapter corre-
sponds to the local mains voltage before you connect the appliance.
■Do not use the ltration unit if it is damaged in any way. Take it to an autho-
rized service center for repair.
■Do not open the power adapter, low-pressure switch, high-pressure switch
and pump. There are no serviceable parts inside.
■When unplugging the ltration unit from the mains, do not pull on the pow-
er cord. Avoid touching the plug with wet hands.
■Do not place ltration unit near the sources of heat, radiators, etc. Do not
place it in a tightly closed space where it may overheat.
■Keep the appliance out of reach of pets or other animals.
■In case of leakage malfunction or water presence around the appliance shut o
the electrical power to the circuit rst, then pull the plug out of the electrical outlet.
■Remove the plug from the electrical outlet and close the inlet valve during your
vacations or other extended periods of time when the appliance is not in use.
■Unplug the pump unit from the electrical outlet while servicing the ltration
unit, and changing the membrane or lters.
■Do not use the appliance if operating requirements such as water tempera-
ture/water pressure/electrical supply, etc. are not met. There may be other
local regulations to comply with.
■Do not use the appliance with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or aer the system.
■The ltration unit was not designed to be used with power cord extenders,
power lters, outlet splitters, etc.
■Do not use the waste water produced by the appliance for drinking or cooking.
■Never store or operate the appliance in direct sunlight.
■This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction con-
cerning use of the appliance by a person responsible for their safety.
■Children should be supervised to ensure that they do not play with the ap-
pliance.
■At the end of its life, the appliance should be disposed o in an appropriate
manner.
Disposal
Old appliances still contain many recyclable materials. Therefore, please take
used unit to your retailer or recycling center so that it can be recycled.
3
Description
Congratulations on your purchase of the Prio® Expert R.O. ltration system! With proper
installation and maintenance, it will provide you with high quality drinking water for many
years.
This R.O. system removes odor and most harmful substances such as heavy metal ions and
total dissolved solids from tap water making it tasty, fresh and vital.
Please familiarize yourself with the general concept behind the product and main modes of
operation.
Key Features:
■Clean and safe drinking water right in your home. No need to transport and dispose of
bottled water any more.
■Factory-preinstalled lters and membrane for faster and easier setup.
■Filters and membrane quick-change housings for easy regular maintenance.
■Compact and beautiful design.
■Quick ttings for easy tube connections and change of lters.
■The booster pump increases pressure to radically improve the performance and eective-
ness of the R.O. unit in all three key areas: increases ltered water ow (production rate),
increases rejection rate (improves water purication quality), increases recovery rate (de-
creases amount of waste water).
■Prolongs the membrane and pre-lter(s) service life due to increased recovery rate.
4
How It Works:
This Prio® Expert reverse osmosis system is a multi-stage automatic ltration machine.
Reverse Оsmosis (R.O.) is a water purication technology that uses a semipermeable mem-
brane to remove ions, molecules and larger particles from drinking water. R.O. can remove
many types of dissolved and suspended species from water, including bacteria, and is used in
both industrial processes and the production of potable water.
Water supply is done through the inlet valve, ltered water is rst stored in the water tank and
then delivered through the faucet, and waste water is drained through the drain saddle. Detailed
connection scheme is shown on the following charts.
Pump:
The ltration unit is equipped with a built-in low voltage booster pump powered by the included
transformer for safe operation.
Pressure Switches:
The ltration unit is equipped with low and high pressure switches. The low pressure switch shuts
o the pump when there is no inlet water or its pressure is too low. The high pressure switch shuts
o the pump when the ltered water faucet is turned o and water storage tank is full.
Inlet Valve:
An adapter ball valve is included to be installed into the cold water supply line to feed water
to the ltration unit inlet.
5
Faucet:
Designer faucet for ltered water is included and usually mounted on the sink deck or counter-
top for dispensing the clean, ltered water from the ltered water storage tank.
Water Storage Tank:
Air pressurized storage tank is used for ltered water storage.
Drain Saddle:
Fits a standard 1.5” diameter drain pipe to drain the waste water from the drain outlet of the
ltration unit.
Pre-Filters:
The ltration unit has coconut carbon block pre-lter. It provides initial ltration of the wa-
ter and protect the following thin lm composite R.O. membrane from dirt and aggressive
chemicals such as
chlorine oen found in tap water.
R.O. Membrane:
Main stage of the ltration is R.O. membrane. It is “semi-permeable”, which means that it
allows water to pass through but prevents dissolved particles from passing through. It splits
the feed water into two streams: clean water goes to the post-lter and then onto the tank
and faucet. Waste water with rejected particles goes down the drain.
Post-Filter:
Last stage of ltration is an activated carbon post-lter and/or remineralization for ne con-
ditioning and keeping the extra freshness of your water.
Specication
Operating Requirements:
■Minimum supply water pressure: 7.25 psi (0.05 MPa)
■Maximum supply water pressure: 80 psi (0.55 MPa)
■Minimum water temperature: 41 oF (5 oC)
■Optimal water temperature: 59–77 oF (15–25 oC)
■Maximum water temperature: 95 oF (35 oC) / up to 105 oF (40.5 oC) short-term
■Ambient air temperature: 41–105 oF (5–40.5 oC)
■Water source: tap water supply, chlorinated or non-chlorinated, bacteriologically safe
■Supply water pH range: 4.0-11.0
■Supply water turbidity: < 1 NTU
■Supply water components: Hardness (CaCO3) <180 mg/L (<10.5 gpg), Iron <0.1 mg/L,
Manganese <0.05 mg/L, Hydrogen Sulde 0.00 mg/L
■Maximum supply water TDS: 1000 ppm
■Indoor use only.
■Tubing: ¼”
■Electrical input: AC 100-240V 50/60 Hz
6
Performance:
Performance of the appliance such as ltered water delivery rate, rejection rate, etc. is highly
dependent on local conditions (inlet water pressure, temperature, TDS and degree of contam-
ination, tank air pressure, etc.) and R.O. system use pattern. Actual performance may vary.
■Filtered water production rating: 75 gpd (270 lpd) maximum
■Filtered water delivery rate (from the tank), typical: 0.27–0.74 gpm (1–2.8 l/min)
■Membrane rejection rate1, typical: 90%
■Recovery rate (system eciency2), typical: 15%
■Drain water ow restrictor: 300 cc (ml/min) nominal, up to 360 cc in working mode.
■Tank Storage Capacity (Total Volume): up to 2.5G (4.0G)3
■Tank full rell time4, typical: 35-45 min
Weight and Size:
R.O. Filtration Unit:
Size (WDH), body only, excluding protrusions: 13.46 x 3.35 x 14.80” (342 x 85 x 376 mm)
Weight, without water and tubing: 8.8 lbs (4.0 kg)
Storage tank:
Tank model No. X842G X852G
Storage Capacity (Total Volume) up to 2.0G (3.2G) up to 2.5G (4.0G)
Size (WxDxH), body only,
excluding protrusions
9.8 x 9.8 x 13.6”
(250 x 250 x 347 mm)
10.55 x 10.55 x 14.90”
(268 x 268 x 378 mm)
Weight, without water and tubing 4.7 lbs (2.1 kg) 6.0 lbs (2.7 kg)
Warranty:
1 year worldwide limited warranty (+ local regulations if applicable)
Package Contents:
(1) The R.O. ltration unit with built-in pump
and installed lters
(1) Storage tank
(1) Universal worldwide adapter ball valve
(G1/2” - G3/8” - UNEF 9/16”-24 - JG 1/4”)
(1) Teon tape roll
(1) Faucet
(1) Drain saddle
(1) Wrench
(1) ¼” tank valve
(26 / 8 m) Water tubing ¼”
(1) ¼” x ¼” union check valve
(2) ¼” x ¼” x ¼” union tee tting
User’s guide
1 For all dissolved solids combined as measured by TDS or conductivity meter.
2 Eciency rating means the percentage of the inuent water to the system that is available to the user as
reverse osmosis treated water under operating conditions that approximate typical daily usage.
3Depending on current SKU scope of supply.
4 Depending on supply water pressure.
7
Installation
Notes:
1. Shut o the cold water supply under the sink or the location where the system will be
installed. If the existing valve is inoperable, the water supply to the house must be shut
o. Then, relieve the water pressure by opening the cold water tap. Do not connect the
system to hot water source.
2. Depending on your plumbing system and sink/countertop type you may need to use tools
like variable speed drill, drill bits, screw driver, wrench, etc. You may want to ask a profes-
sional service provider such as certied plumber to install the inlet valve adapter, faucet,
and drain saddle to assure a trouble-free setup.
3. During installation you will need to cut the supplied ¼” tubing into segments as needed.
Use your utility knife for that or similar tool. See the following charts to determine the
connection scheme and length of hoses necessary. You may need to purchase extra tubing
for far-reaching or other corner case installations.
4. Do not connect the ltration unit to the electrical supply until the setup is completed.
5. With initial operation, check for leaks. If a leak is observed, verify that the tubing is pushed
into the quick tting far enough to seal the tubing against the O-ring and that the tubing
was cut at 90°.
8
drain
saddle
check valve
tank
waste water outlet
permeate outlet to the tank
to drain or waste water
collection container
filtered
water
faucet
filtration unit inlet
inlet valve
(optional)
General Connection Chart
9
IMPORTANT: Cut tubing at 90° to ensure a
watertight seal:
Units Placement Guide:
Remember this unit must be serviced at regular intervals. Therefore it should be reasonably
accessible (for changing lters or membrane, etc.).
To connect the tubing to a tting:
1. Remove the lock if present (not present in self-locking ttings).
2. Push. Insert the tube rmly until full stop.
3. Pull the collet back slightly.
4. Replace the lock (if present).
To disconnect the tubing:
1. Remove the lock if present (not present in self-locking ttings).
2. Push the collet and hold.
3. Pull the tubing out.
4. Replace the lock (if present).
No skewed cut!
1
4
3
2
1
4
2
3
10
Installation Steps:
1. Install adapter ball valve (included) to the
cold water supply.
Use some Teon or plumbers sealing tape to
prevent leaks. Use three included threaded
adapters to make dierent connection con-
gurations (see chart for details).
2. Create ½” hole for the ltered water faucet and install it.
Tip: If you have a soap dispenser or a water
sprayer in an existing hole you may remove it
and use its hole for the ltered water
faucet.
3. Install drain saddle.
t
The square foam gasket with a circle cut out must be applied to the inside of the drain sad-
dle. Remove sticky tape backing and stick to the drain saddle as shown.
1
23
4
56
7
8
9
10
11
1. Faucet
2. Chrome washer
3. Black rubber washer
4. Countertop or
sink deck
5. Black washer
6. Lock washer
7. Lock nut
8. Insert
9. Sleeve
10. Compression nut
11. Tubing
UNEF 9/16”-24
G3/8” G1/2”
G1/2”
Adapter Adapter
UNEF 9/16”-24
UNEF 9/16”-24
G3/8”
G1/2”
1
Adapter
1
Adapter
2
3
Inhaltsverzeichnis
Andere DWT Wasserfiltersystem Handbücher
Beliebte Wasserfiltersystem Handbücher anderer Marken
Gaggenau
Gaggenau BRITA INTENZA 467873 Bedienungsanleitung
Brita
Brita SAFF-100 Bedienungsanleitung
HEISSNER
HEISSNER FPU24000-00 Bedienungsanleitung
BGS technic
BGS technic 1518 Bedienungsanleitung
Reverse Osmosis
Reverse Osmosis RF Series Bedienungsanleitung
ubbink
ubbink Filtramax Series Bedienungsanleitung