Eaton CWGA-0 Series Handbuch
1
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria MA_xC_waterguard_Battery_CWGA-0D.indd / 11.2021a / IL019288ZU / 136211217
© 2021 by Eaton Industries (Austria) GmbH, www.eaton.eu/documentation All Rights Reserved / Printed in Austria
www.eaton.com/recycling
Battery Water Guard Detector
CWGA-0x/xx
Technical Data / Technische gegevens / Tekniske data /
Technische Daten / Technická data
Power supply
Battery CR2477N 3Vdc
Battery service life up to 5 years (TYP, when no alarm)
Alarm LED and Acoustic
Push button Alarm acknowledge
LED Multi-Color operation status
Water sensor
On device 2 contacts at the bottom
External Flat-cable water sensor support
Dimensions 51 x 46 x 18 mm (H x W x D)
RF 868.3MHz (xComfort compatible)
Max RF power 25 mW (ERP)
868.3 MHz
IP20
Instruction Leaflet
Montageanweisung
Notice d’installation
Instrucciones de montaje
Istruzioni per il montaggio
Инструкция по монтажу
Montagehandleiding
Montagevejledning
Οδηγίες εγκατάστασης
Instruções de montagem
Monteringsanvisning
Asennusohje
Návod k montáži
Paigaldusjuhend
Szerelési utasítás
Montāžas instrukcija
Montavimo instrukcija
Instrukcja montażu
Navodila za montažo
Návod na montáž
Монтажни инструкции
Instrucţiuni de montaj
Upute za montažu
Kullanma Talimatı
Инструкција за монтажу
Intruksjonsblad
Монтажна інструкція
ت ا ة
www.eaton.com/comfort
On-device operating to
acknowledge alarm
Onboard water sensor or
with external sensor cable
Acoustic and LED alarm
Multi-Color Status LED
Device Color
CWGA-0D/01 Pure white
CWGZ-CB/09 Cover Jet black
CWGZ-CB/03 Cover Silver
Battery 1x CR2477N
Long battery service life
CWGA-00/01 CWGZ-CB/xx
3x 3x 1x 1x 1x 3m 1x
MRF Version 2.80
xComfort Bridge Version 3.10
2
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria MA_xC_waterguard_Battery_CWGA-0D.indd / 11.2021a / IL019288ZU / 136211217
© 2021 by Eaton Industries (Austria) GmbH, www.eaton.eu/documentation All Rights Reserved / Printed in Austria
www.eaton.com/recycling
Mounting / Montage / Montage / Montering / Montage / Montáž
Warning! Device contains a small battery (< 32 mm) and should not be installed in a location
likely to be accessible to children. / Waarschuwing! Het apparaat bevat een kleine batterij
(< 32 mm) en mag niet worden geïnstalleerd op een locatie die mogelijk toegankelijk is voor
kinderen. / Advarsel! Enheten inneholder et lite batteri (< 32 mm) og bør ikke installeres på et
sted som sannsynligvis er tilgjengelig for barn. / Warnung! Das Gerät enthält eine kleine Batterie
(< 32 mm) und sollte nicht an einem Ort installiert werden, der für Kinder leicht zugänglich ist /
Varování! Zařízení obsahuje malou baterii (< 32 mm) a nemělo by být instalováno na místě,
které bude pravděpodobněpřístupné dětem.
3
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria MA_xC_waterguard_Battery_CWGA-0D.indd / 11.2021a / IL019288ZU / 136211217
© 2021 by Eaton Industries (Austria) GmbH, www.eaton.eu/documentation All Rights Reserved / Printed in Austria
www.eaton.com/recycling
External sensor (optional) / Externe sensor (optioneel) / Ekstern sensor (valgfri) / Externer Sen-
sor (optional) / Externí senzor (volitelně)
Connect sensor cable / Sensorkabel aansluiten / Koble til sensorkabelen / Sensorkabel an-
schließen / Připojení kabelu senzoru
4
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria MA_xC_waterguard_Battery_CWGA-0D.indd / 11.2021a / IL019288ZU / 136211217
© 2021 by Eaton Industries (Austria) GmbH, www.eaton.eu/documentation All Rights Reserved / Printed in Austria
www.eaton.com/recycling
How to apply the sensor cable / Hoe de sensorkabel aan te sluiten / Slik bruker du sensorkabel-
en / Anbringen des Sensorkabels / Jak instalovat kabel senzoru
- Surface must be clean, dry and dust-free / Ondergrond moet schoon, droog en stofvrij zijn /
Overflaten må være ren, tørr og støvfri / Oberfläche muss sauber, trocken und staubfrei sein /
Povrch musí být čistý, suchý a bezprašný
- Do not to touch the exposed adhesive area at any time / Raak het blootliggende kleefgedeelte
nooit aan / Ikke berør det eksponerte limområdet / Den freiliegenden Klebebereich nicht
berühren / Nedotýkejte se odkryté lepicí plochy
- Press firmly / Druk stevig aan /Trykk fast / Fest andrücken / Pevněpřitlačte
- Once mounted, the adhesive tape cannot be reused / Eenmaal gemonteerd, kan de tape niet
opnieuw worden toegepast / Når den er montert, kan ikke klebebåndet brukes på nytt / Nach
der Montage kann das Klebeband nicht wieder verwendet werden / Po namontování nelze
lepicí pásku znovu použít
Remove sensor cable / Sensorkabel verwijderen / Fjern sensorkabelen / Sensorkabel entfernen /
Odpojení kabelu senzoru
5
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria MA_xC_waterguard_Battery_CWGA-0D.indd / 11.2021a / IL019288ZU / 136211217
© 2021 by Eaton Industries (Austria) GmbH, www.eaton.eu/documentation All Rights Reserved / Printed in Austria
www.eaton.com/recycling
Basic mode
Connect Water Detector (Battery) / Water Guard-detector aansluiten (batterij) / Legg til Water
Guard Detektor (batteri) / Water Guard-Detektor (Batterie) verbinden / Spárování detektoru
zaplavení (bateriový)
Remove Water Detector (Battery) / Verwijder de Water Guard-detector (batterij) / Legg til Water
Guard Detektor (batteri) / Water Guard-Detektor (Batterie) trennen / Odpárování detektoru
zaplavení (bateriový)
Back to factory Default / Terug naar fabrieksinstellingen /Tilbake til fabrikkinnstilling / Zurück zu
den Werkseinstellungen / Uvedení do výrobního nastavení
6
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria MA_xC_waterguard_Battery_CWGA-0D.indd / 11.2021a / IL019288ZU / 136211217
© 2021 by Eaton Industries (Austria) GmbH, www.eaton.eu/documentation All Rights Reserved / Printed in Austria
www.eaton.com/recycling
LED during operation / LED tijdens bedrijf / LED under drift / LED im Normalbetrieb / LED
během provozu
během
provozu
Replace battery / Vervang batterij / Bytt batteri / Batterie wechseln / Vymĕnit baterii
No RF communication / Geen RF-communicatie / Ingen RF-kommunikasjion /
Keine Funk-Kommunikation / Žádná RF komunikace
7
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria MA_xC_waterguard_Battery_CWGA-0D.indd / 11.2021a / IL019288ZU / 136211217
© 2021 by Eaton Industries (Austria) GmbH, www.eaton.eu/documentation All Rights Reserved / Printed in Austria
www.eaton.com/recycling
Quick User Guide / Beknopte gebruikershandleiding / Hurtigveiledning / Schnellanleitung /
Stručný návod k obsluze
xComfort Water Guard
What to do if water is detected:
Reset the sound alert by
brieÀy (<0.5s) pressing
button A.
1
Check for water leakage.
Make sure that the installation
site is dry and in order.
Used with main Water Guard device.
To open the water valve, follow the steps
for the main Water Guard device.
Location:
2
3
<0.5s
etik_xc_waterguard_90x90mm.indd / 09.2021a / IL019296ZU / 136211222
8
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria MA_xC_waterguard_Battery_CWGA-0D.indd / 11.2021a / IL019288ZU / 136211217
© 2021 by Eaton Industries (Austria) GmbH, www.eaton.eu/documentation All Rights Reserved / Printed in Austria
www.eaton.com/recycling
A
ffixing date of CE mark: 2021
Doc.
Id.: CWGA_00-01_111121
Director Operations Director Quality
Friedrich Schröder
Gerhard Dischner
Declaration of Conformity
We, EATON Industries (Austria) GmbH
3943 Schrems, Eugenia 1
Austria
declare under our sole responsibility as manufacturer that the product (family)
Eaton - Battery Water Guard Detector
CWGA-00/01
(the declaration of conformity applies to all
listed types within our actual product catalogue)
provided that it is installed, maintained and used in the
application intended for, with respect to the relevant manufacturer’s
instructions, installation standards and “good engineering practices”
complies with the provisions of Council directive(s):
RED Directive 2014/53/EU
RoHS Directive 2011/65/EU + 2015/863
based on compliance with following standard(s):
EN 300220-2 V3.2.1, EN 301 489-1 V2.2.3, EN 301489-3 V2.1.1, EN
IEC 63044-5-1:2019, EN IEC 63044-5-2:2019, EN IEC 63044-5-
3:2019, EN IEC 62368-1:2020 + A11:2020, EN 63000:2018
Schrems, 11.11.2021
Inhaltsverzeichnis
Andere Eaton Sicherheitssensor Handbücher
Eaton
Eaton CEAG Style 22011 CG-S Service-Handbuch
Eaton
Eaton Powerware Series Bedienungsanleitung
Eaton
Eaton MEM Watchman 180 Bedienungsanleitung
Eaton
Eaton Crouse-hinds series Bedienungsanleitung
Eaton
Eaton 1450-CSA Handbuch
Eaton
Eaton COOPER POWER SERIES Bedienungsanleitung
Eaton
Eaton CEAG GuideLed Cinema 11011 CG-S Service-Handbuch
Eaton
Eaton MAP820 Gebrauchsanweisung
Eaton
Eaton ALL-PRO MS185DW Bedienungsanleitung
Eaton
Eaton CWGA-0 Series Handbuch
Eaton
Eaton Sure-Lites 2C Bedienungsanleitung
Eaton
Eaton HALO MS180 Bedienungsanleitung
Eaton
Eaton 2450 Series Bedienungsanleitung
Eaton
Eaton All-Pro MS245RW Bedienungsanleitung
Eaton
Eaton HaloHome MST20C18W Bedienungsanleitung
Eaton
Eaton DET-REXT-PIR30 Bedienungsanleitung
Eaton
Eaton CEAG EURO X LED Service-Handbuch
Eaton
Eaton xComfort CBMA-02/01 Handbuch
Eaton
Eaton MAB50R Bedienungsanleitung
Eaton
Eaton All-Pro MS180BT Bedienungsanleitung
