SSaaffeettyy ooff PPeerrssoonnss
• The system has its own power source (the battery) Consequently, the power outlets may be
energized ven if the systems is disconnected from the AC power source Dangerous voltage
levels are resent within the system It should be opened exclusively by qualified service
personnel
• The system must be properly grounded at all times
• The battery supplied with the system contains small amounts of toxic materials To avoid
accidents, the directives listed below must be observed:
–Servicing of batteries should be performed or supervised by personnel knowledgeable about
batteries and the required precautions
–When replacing batteries, replace with the same type and number of batteries or battery
packs
–Do not dispose of batteries in a fire The batteries may explode
–Batteries constitute a danger (electrical shock, burns) The short-circuit current may be very
high
• Precautions must be taken for all handling:
–Wear rubber gloves and boots
–Do not lay tools or metal parts on top of batteries
–Disconnect charging source prior to connecting or disconnecting battery terminals
–Determine if battery is inadvertently grounded If inadvertently grounded, remove source
from ground Contact with any part of a grounded battery can result in electrical shock The
likelihood of such shock can be reduced if such grounds are removed during installation and
maintenance (applicable to equipment and remote battery supplies not having a grounded
supply circuit)
PPrroodduucctt SSaaffeettyy
• To connect the UPS, instructions and operation described in the manual must be followed in the
indicated order
• CAUTION - To reduce the risk of fire, the unit connects only to a circuit provided with 20 or 30
amperes maximum branch circuit overcurrent protection in accordance with the National Electric
Code, ANSI/NFPA 70 (US installations only)
• Check that the indications on the rating plate correspond to your AC powered system and to the
actual electrical consumption of all the equipment to be connected to the system
• For PLUGGABLE EQUIPMENT, the socket-outlet shall be installed near the equipment and shall
be easily accessible
• Never install the system near liquids or in an excessively damp environment
• Never let a foreign body penetrate inside the system
• Never block the ventilation grates of the system
• Never expose the system to direct sunlight or source of heat
• If the system must be stored prior to installation, storage must be in a dry place
• The admissible storage temperature range is -25ºC to +55ºC without batteries, 0°C to 40°C with
batteries
• The system is not for use in a computer room AS DEFINED IN the standard for the Protection of
Information Technology Equipment, ANSI/NFPA 75 (US installations only)
