Possible Troubleshooting / Decalcification
Malfunction Possible cause / Remedy
It is not possible to switch on the
machine
The power supply to the machine is
interrupted, cause within the machine,
ontact the after-sales service
The machine is not being filled with
water
The check valve provided by the
customer is closed, the air trap is soiled –
therefore, the level switch does not work,
the inlet valve is soiled or defective
ontact the after-sales service
The machine fills up with water and
heats up, but it is not possible to start
the rinsing program
The door contact switch is not in
contact defective, the fine wire fuse is
blown
ontact the after-sales service
The machine is being filled continuously
with water
The overflow pipe is not inserted correctly
The bottles are not clean The rinsing temperature is too low, the
machine does not convey the cleaning
agent. The rinsing agent container is
empty, the jet nozzles are plugged
The bottles have a grey, smeary film Insufficient quantity of fresh water per
rinsing process – Check the water
pressure
The exterior of the machine should only be wiped with a damp cloth.
Please observe that life switches and control lights are in the area of the operating
panel.
Decalcifying the interior of the machine:
The supply system of the machine is only supplied with cold water Therefore, it is not
necessary to decalcify this area. Decalcify the machine as follows:
Clean the interior of the machine (refer to the instructions on the pages 5 and 6).
Remove the surface filter and the overflow pipe. Spray the interior, the overflow pipe,
the suction filter and the surface filter with a decalcifier (diluted or according the to
the instructions). Put the overflow pipe and the suction filter on the surface
filter.Warten Wait during the exposure time of the decalcifier. Switch on the machine
and wait for about 20 sec. Switch off the machine. Then reinsert the suction filter
and the overflow pipe according to the instructions. It is also possible to hose out the
interior after the decalcifying with a water hose Attention: Only spray into the
interior of the machine.
Attention: In particular, decalcify the heating elements in the inside of the tank in
regular intervals. Otherwise, the heating capacity would be reduced or they might get
damaged.
Page 7
