EBN Technology X-PPC 710 Bedienungsanleitung
User’s Manual
X-PPC 710
Copyrights
©2011 All rights reserved. The information in this
document is subject to change without prior notice in
order to improve reliability, design and function and does
not represent a commitment on the part of the
manufacturer.
This document contains proprietary information
protected by copyright. All rights are reserved. No
part of this manual may be reproduced by any
mechanical, electronic, or other means in any form
without prior written permission of the manufacturer.
All trademarks are property of their respective
owners
Liability Disclaimer
In no event will the manufacturer be liable for direct,
indirect, special, incidental, or consequential
damages arising out of the use or inability to use the
product or documentation, even if advised of the
possibility of such damages.
Regulatory Information
FCC Notices
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
Part 15 of the Federal Communications Commission
(FCC) Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Increase the separation between the equipment
and the receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio or
television technician for help.
This device complies with Part 15 (A) of the FCC
Rules. Operation is subject to the following two
conditions:
1) this device may not cause harmful interference
and
2) this device must accept any interference received,
including interference that may cause undesired
operation.
NOTE: THE MANUFACTURER IS NOT
RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED
MODIFICATIONS TO THIS DEVICE. SUCH
MODIFICATIONS COULD VOID THE USER'S
AUTHORITY TO OPERATE THE DEVICE.
CE Notice
This device complies with EMC Directive
2004/108/EC issued by the Commission of the
European Community.
i
Copyrights
WEEE Notice
The WEEE mark applies only to countries within the
European Union (EU) and Norway.
This appliance is labeled in accordance with
European Directive 2002/96/EC concerning waste
electrical and electronic equipment (WEEE). The
Directive determines the framework for the return
and recycling of used appliances as applicable
throughout the European Union. This label is applied
to various products to indicate that the product is not
to be thrown away, but rather reclaimed upon end of
life per this Directive.
RoHS Notice
This device is full compliance with EU Directive
2002/95/EC (the RoHS Directive) that restricts the
use of the hazardous substances listed below in
electrical and electronic equipment.
Safety Statement for Lithium Battery
ii Copyrights
Contents
Copyrights .................................................................................................i
Liability Disclaimer ...................................................................................i
Regulatory Information.............................................................................i
FCC Notices.......................................................................................................... i
CE Notice .............................................................................................................. i
WEEE Notice........................................................................................................ ii
RoHS Notice ........................................................................................................ ii
Safety Statement for Lithium Battery ................................................................ ii
Contents...................................................................................................iii
1. Hardware Setup....................................................................................4
1.1. Quick Tour .................................................................................................... 4
Front View and Side View .............................................................................. 4
Back Panel I/O ............................................................................................... 5
1.2. Basic Peripherals Installation ..................................................................... 5
Power Adapter ............................................................................................... 5
USB Mouse, USB Keyboard and USB ODD .................................................. 5
LAN Cable...................................................................................................... 6
Cash Drawer .................................................................................................. 6
Customer Display........................................................................................... 6
WiFi Module ................................................................................................... 7
1.4. VESA Wall-mount Kit Installation.............................................................. 10
1.5. Turn on the device.......................................................................................11
2. Basic Driver Installation ....................................................................12
2.1. Before the installation................................................................................ 12
2.2. Chipset Software Installation .................................................................... 12
2.3. VGA Driver Installation .............................................................................. 13
2.4. Touch Screen Driver and Software Utility installation ............................ 15
2.5. LAN Driver Installation............................................................................... 18
3. eGalaxy Touch Control Utility Quick Guide .....................................22
3.1. Launch eGalaxy Touch Control Utility...................................................... 22
3.2. General........................................................................................................ 22
3.3. Settings....................................................................................................... 24
3.4. Tools............................................................................................................ 27
3.5. Edge Compensation .................................................................................. 28
4. I/O Definition.......................................................................................31
5.1. Power Connector ....................................................................................... 31
5.2. Serial Port ................................................................................................... 31
5.3. Cash Drawer ............................................................................................... 31
iii
5 Specification........................................................................................33
Contents
1.
1. Hardware Setup
1.1. Quick Tour
Front View and Side View
LED Indicator
The Power indicator will:
1. glow green when the power is on
2. glow red when the HDD is accessed.
Chapter 1 4
Back Panel I/O
1.2. Basic Peripherals Installation
Remove the rear I/O board cover from the device.
Power Adapter
Connect the DC cable to the DC in jack.
USB Mouse, USB Keyboard and USB ODD
Connect your Mouse and Keyboard to the mouse/keyboard port, and USB ODD
to the USB ports on the back panel of the device.
Chapter 1 5
LAN Cable
Connect one end of RJ-45 LAN cable to the LAN port on the back panel of the
device, another end to your internet device.
Cash Drawer
Connect one end of RJ-11 cable to the Cash Drawer port on the back panel of the
device, another end to your cash drawer.
Install the rear I/O board cover onto the device.
Customer Display
A. Hardware Installation
1. Remove the two screws fixing the customer display cover, and then remover
the VFD mounting hole cove from the device and pull out the connector from the
device.
Chapter 1 6
3. Adjust the hinge of the VFD, and then connect to the device as shown below.
4. Mount the VFD to the device and tighten the two M3 screws as shown below.
5. Finished.
WiFi Module
1. Remove the IO panel cover (if installed) form the device.
Chapter 1 7
2. Un-tighten four screws.
3. Open the device, and you’ll see the two antenna cable fixed by black acetate
tape.
4. Below is the layout of the Wi-Fi module.
Chapter 1 8
6. Assemble the WiFi module, antenna and WiFi module cable as shown.
8. Connect the another end of the WiFi module cable to the 4 pin USB header
(USB 4) on the main board. For the location of the USB4 on the main board,
please refer to the figure below.
9. Reassembly the device.
Chapter 1 9
Andere Handbücher für X-PPC 710
2
Inhaltsverzeichnis
Andere EBN Technology Touch-Terminal Handbücher
EBN Technology
EBN Technology XPOS75A-2B-2930 Bedienungsanleitung
EBN Technology
EBN Technology SPOS50-7W-LX800 Bedienungsanleitung
EBN Technology
EBN Technology XPOS85-5W-D525 Bedienungsanleitung
EBN Technology
EBN Technology XPOS72-2B-A16G Bedienungsanleitung
EBN Technology
EBN Technology EZPPC70-2B-C1G Bedienungsanleitung
EBN Technology
EBN Technology POS70-2EB-370 Bedienungsanleitung
EBN Technology
EBN Technology X-PPC 710 Bedienungsanleitung
EBN Technology
EBN Technology XPOS72-2B-2930 Bedienungsanleitung
EBN Technology
EBN Technology TM50-5B-VU Bedienungsanleitung
EBN Technology
EBN Technology XPOS75-5B-2930 Bedienungsanleitung
EBN Technology
EBN Technology TM-70 Bedienungsanleitung
EBN Technology
EBN Technology XPOS85-5W-D525 Bedienungsanleitung
EBN Technology
EBN Technology PPC-815 Bedienungsanleitung
EBN Technology
EBN Technology TM50A-5B-VR Bedienungsanleitung
EBN Technology
EBN Technology TM-550 Bedienungsanleitung
EBN Technology
EBN Technology POS60-5B-C1G Bedienungsanleitung
EBN Technology
EBN Technology X-POS855A Bedienungsanleitung
EBN Technology
EBN Technology XPOS72-8B-A16G Bedienungsanleitung
EBN Technology
EBN Technology POS50A-5B-LX800 Bedienungsanleitung
EBN Technology
EBN Technology X-POS950 Bedienungsanleitung
Beliebte Touch-Terminal Handbücher anderer Marken
Wincor Nixdorf
Wincor Nixdorf iPOS plus Advanced Bedienungsanleitung
Ingenico
Ingenico AXIUM EX4000 Bedienungsanleitung
Heisei Electronics
Heisei Electronics Q-POS 815 Bedienungsanleitung
Amano
Amano MTX-15 Bedienungsanleitung
FLOWBIRD
FLOWBIRD CWT Compact Touch Bedienungsanleitung
Demco
Demco SP7 Bedienungsanleitung
Motorola
Motorola MTP850 Bedienungsanleitung
YASKAWA
YASKAWA 62H-MDC0 Bedienungsanleitung
MVG industries
MVG industries NeptuLink Bedienungsanleitung
Price Industries Limited
Price Industries Limited FDC Gebrauchsanweisung
Honeywell
Honeywell TemaKey Bedienungsanleitung
EBN
EBN BPC65-B-A16G Bedienungsanleitung