For more information please visit our website at www.echostreams.com
Copyright © 2017, Echostreams Innovative Solutions LLC. All rights reserved.
5. Install Motherboard Components (CPU,
heatsink, memory) using the guidelines below. For further
details, refer to the motherboard TPS.
6. Remove the Inner Rail from the slide rail.
1 – 2 Pull the inner rails out. Pull the blue release tab when it hits a stop.
3 – 4 Keep extending inner rail and pull the white detach tab
when it hits the second stop
5 – 6 Unretract the mid rail by pulling the latch on the mid rail
1 2
3 4
5 6
7. Install Inner Rails to the enclosure.
Yellow circles are for standoff screws
Secure inner rail with
M4x4L screw (red) To remove Inner rail from unit:
Pull the latch outward and remove
the keyhole from standoff
8. Install the Outer Rails to the Rack as follows:
Red rectangles are locations for slide
rail position (front and rear posts)
Place square nut at yellow circles for
enclosure screws (front only)
1U
2U
3U
Rear Bracket
Front Bracket
1 – 2 Snap the rear part of slide rail
to rear posts
3 – 4 Snap the front part of slide rail
to front posts
1 2
3 4
To remove slide rails, use the latches to undo the assembly as follows:
Rear Bracket Front Bracket
9. Install the Unit to the Rack as follows:
For a complete instruction on how to install unit to the rack,
please follow the Slide Rail Installation Guide.
At least two people are recommended for
mounting process.
10.Install 3.5” Drives to the enclosure as illustrated:
11.Install 2.5” Drives to the enclosure as illustrated:
12. Plug in the Power Cords to the AC
receptacles on the back of the unit.
13. Press the Power Button on the
front of the unit and for the system to boot up.
14. Access the Serial Console (when necessary) by
connecting a serial audio cable to the
console ports. See picture for detail.
Use a terminal console with baud set
115200, 8, N, 1, N. Type “help –a” for
a list of commands.
