Ecom X.COM 200 -EX Montageanleitung
x.com 200 -Ex
Safety instructions
15
Table of Contents
1. Application 16
2. Safety precautions 16
3. Faults and damage 16
4. Safety regulations 17
5. Ex-Data 18
6. Specifications 18
7. Button functions 19
8. Rechargeable battery and commissioning 20
8.1 Changing the battery 20
8.2 Commissioning 20
8.3 Safety precautions 22
9. Repair 23
10. Cleaning, maintenance and storage 23
11. Disposal 24
12. Warranty and liability 25
13. EC Declaration of Conformity 26
14. Certificate of Conformity 27
Note:
The current safety precautions, operating instructions, EC
Declaration of Conformity and the Certificate of Conformity
can be downloaded from the relevant product page at www.
ecom-ex.com, or alternatively they can be requested directly
from the manufacturer.
16
1. Application
The x.com 200 –Ex is an explosion-shielded, water-, dust-
and impact-resistant mobile phone for industrial application
in areas with an increased risk of explosion in zone 2 in
accordance with directive 1999/92/EC (ATEX 137) and 94/9/
EC (ATEX 95).
2. Safety precautions
These operating instructions contain information and safety
regulations which are to be observed without fail for safe
operation in the described conditions. Non-observance of this
information and these instructions can have serious conse-
quences or it may violate regulations.
Please read these operating instructions carefully before
starting to use the unit! In the event of conflicting information
the details specified in the safety precautions shall apply.
In case of any doubt (in the form of translation or printing
errors) the German version shall apply.
3. Faults and damage
If there is any reason to suspect that the safety of the unit has
been impaired, it must be withdrawn from use and removed
immediately from the Ex-area. Measures must be taken to
prevent it from being restarted accidentally.
The safety of the unit may be compromised, if, for example:
- there is visible damage to the housing.
- the unit has been subjected to excessive loads.
- the unit has been improperly stored.
- the unit has been damaged in transit.
- unit markings or inscriptions are illegible.
- malfunctions occur.
- permitted limit values have been exceeded.
17
4. Safety regulations
Use of the x.com 200 –Ex explosion-shielded mobile phone
assumes that the operator observes the conventional safety
regulations and has read the certificate of conformity in order
to eliminate faulty operation of the unit.
The following points are to be observed:
- The device has to be protected against strong impact.
- The unit should not be opened inside the Ex-area.
- The battery module may not be changed inside the Ex-area!
- The battery module may only be charged outside the Ex-
area and only then using the following appropriate chargers:
battery charger DSA-0051-05C, USB data cable PCX 20 or
car charger ALX 20
- The battery module may only be charged in a temperature
range of 0 °C - 45 °C.
- Only accessories approved by ecom instruments GmbH
may be used.
- Observe the corresponding laws that are in force in the re-
spective country regarding the use of mobile phones while
operating a vehicle!
- Use of the mobile phone in an airplane is not permitted!
- Switch off the mobile phone when in close proximity to
medical instruments and if you are requested to do so by
corresponding regulations!
- Manufacturers of cardiac pacemakers recommend a
minimum distance of 15.3 cm (6“) is maintained between a
mobile phone and a pacemaker.
- Do not switch on the mobile phone when the use of such
devices is prohibited, as it may cause interference or result
in danger.
- Only the original battery module AM X20 (Li-Polymer 3.7V)
should be used!
-
The charging socket cover must be firmly engaged in the unit.
- When changing the battery the unit and the battery terminals
are to be checked for cleanliness and cleaned, if necessary.
- It must be ensured that the unit is not taken into zones 0 or 1!
18
5. Ex-Data
Certificate of Conformity no.: PTB 09 ATEX 2042 X
Ex-designation: II 3G Ex nA nL IIC T4
x.com 200 –Ex
Approved for zone 2, device group II, explosion group IIC
(explosive gases, vapours or mist), temperature class T4.
6. Specifications
Networks:
GSM: 900 MHz
1800 MHz
1900 MHz
Power supply: Battery module AM X20
Dimensions: 119 x 57 x 25 mm
Weight: approx. 160 g
CE-designation: 0 0102
Ambient temperature: -20 °C ... +50 °C
Protection rating: IP 57
19
7. Button functions
Volume control
Phonebook/
PTT-function
Left
selection
button
Accept/Make-
call button
Press and hold
to access
the mailbox
For entering a ‚+‘ for
international numbers
Charging socket cover
Press and hold
to activate/
deactivate
the silent mode.
To activate/deactivate
the loud-
speaker during a call.
To display the ring
type menu
in the standby mode.
On/Off/Call
end button
Flashlight
Menu button
Navigation buttons
(up/down/left/right)
Press and hold
to lock/unlock
the keypad.
Right selection
button
20
8. Rechargeable battery and commissioning
8.1 Changing the battery
The AM X20 battery module for the x.com 200 –Ex unit may
only be changed outside the Ex-area. Only those battery
modules which are approved by the manufacturer for your
device type may be used (see Safety regulations under point
4). Other battery modules may not be taken into the Ex-area.
8.2 Commissioning
1) Unscrewing the cover:
Switch off the phone. To
open the battery compart-
ment cover turn the screws
in the cover anti-clockwise.
2) Lifting the cover:
Remove the cover for the
battery compartment.
3) Inserting the SIM:
Remove the battery. Slide the
silver card holder to the right
and carefully lift the SIM card
holder. Insert the SIM card
into the designated holder in
the lower part of the phone.
21
4) Securing the SIM:
Lower the SIM card holder.
Slide the card holder gently to
the left over the SIM card.
5) Inserting the battery:
Insert the battery. Close
the cover for the battery
compartment. Turn the screws
of the battery compartment
clockwise.
6) Charging the phone:
The battery supplied with the
phone is not fully charged. It
is recommended to charge
the phone for three hours be-
fore using it for the first time.
The full capacity of the battery
is reached after 4-6 complete
charge/discharge cycles.
IMPORTANT: To ensure water tightness the screws should
only be tightened by hand!
22
NOTE - There is a risk of explosion if the battery is not ex-
changed properly or if it is exposed to a flame.
Do not short-circuit the battery.
The battery does not contain any parts that can be ex-
changed. The casing of the battery should not be opened
under any circumstances.
Only use ecom charging accessories (see point 4).
The use of other chargers or batteries is not permitted. If such
items are used, your Ex-protection will expire.
Used batteries are to be disposed of properly.
If you do not intend using the phone for a prolonged period,
you should remove the battery.
We strongly advise against connecting your phone to the
charger if the battery is not inserted.
If the battery is completely discharged, the phone will not
switch on and the display will not show a charging process.
Connect the phone to the charger. After charging for a few
minutes the display will appear again and you can then
switch on the phone.
8.3 Safety precautions
Damaged batteries and chargers should be removed from
use and sent to ecom instruments GmbH for inspection.
Note:
Extreme temperatures can have an adverse effect on char-
ging the battery module AM X20.
Do not dispose of the battery module in a fire!
Do not short-circuit the battery module!
Dispose of the battery module in accordance with local
regulations. Do not dispose of the battery module with normal
household waste.
High quality lithium-ion batteries are used in your x.com 200
–Ex. These batteries have numerous advantages in everyday
use, such as a low weight and high capacity in a nevertheless
compact construction. In addition these batteries also exhibit
practically no memory effect.
23
However, these batteries are susceptible to a natural ageing
process which impairs their functionality. Modern batteries
today have a lifespan of around 500 charge cycles, which,
when used daily, corresponds to a service life of approxi-
mately 2 years. The ageing process increases rapidly after
this period, which means that the batteries are deemed
technically defective after 500 charge cycles. Moreover, the
batteries could blow up and cause irreparable damage to
your device in a worst case scenario.
For this reason rechargeable batteries with lithium cells
should be replaced after 2 years at the latest or after reaching
a battery capacity that is 50% of its initial value.
Note: The battery used in this unit poses a fire hazard and
can cause chemical injuries if it is used improperly. Neit-
her the battery nor the battery cells should be opened or
disassembled and they should not be burned or exposed to
temperatures exceeding 100 °C.
9. Repair
Repairs are to be conducted by ecom instruments GmbH
or by personnel or service centres authorised by ecom
instruments GmbH, because the safety of the unit needs to be
tested after repairs are implemented.
10. Cleaning, maintenance and storage
- Only use a suitable cloth or sponge to clean the phone.
Do not use any solvents or abrasive cleaning agents when
cleaning.
- It is recommended that you have the functionality and
accuracy of the phone inspected by the manufacturer every
two years.
- The battery should be removed from the phone during
prolonged periods of storage.
- Do not exceed the permissible storage temperature range of
-20 °C ... +50 °C!
Inhaltsverzeichnis
Andere Ecom Handy Handbücher
Beliebte Handy Handbücher anderer Marken
Point Mobile
Point Mobile PM60 Bedienungsanleitung
Blackbe;rry
Blackbe;rry Q10 Bedienungsanleitung
Blackbe;rry
Blackbe;rry Bold 9900 Bedienungsanleitung
Blackbe;rry
Blackbe;rry STORM 9500 - VERSION 5.0 Bedienungsanleitung
LG
LG LM-K420EMW Bedienungsanleitung
ISAFE MOBILE
ISAFE MOBILE IS655.2 Bedienungsanleitung