Edge-Core ECS4510-28P Bedienungsanleitung

Management Guide

www.edge-core.com

ECS4510-28T/P/F

ECS4510-52T

28/52-Port Layer 2+

Gigabit Ethernet Switch

ANAGEMENT

UIDE

ECS4510-28T GIGABIT ETHERNET SWITCH

Layer 2+ Gigabit Ethernet Switch

with 24 10/100/1000BASE-T (RJ-45) Ports,

2 10-Gigabit SFP+ Ports,

and Optional Module with 2 10-Gigabit SFP+ Ports

ECS4510-28P GIGABIT ETHERNET POE SWITCH

Layer 2+ Gigabit Ethernet PoE Switch

with 24 10/100/1000BASE-T (RJ-45) Ports,

2 10-Gigabit SFP+ Ports,

and Optional Module with 2 10-Gigabit SFP+ Ports

ECS4510-28F GIGABIT ETHERNET FIBER SWITCH

Layer 2+ Gigabit Ethernet Fiber Switch

with 22 SFP Ports,

with 2 10/100/1000BASE-T (RJ-45/SFP) Ports,

2 10-Gigabit SFP+ Ports,

and Optional Module with 2 10-Gigabit SFP+ Ports

ECS4510-52T GIGABIT ETHERNET SWITCH

Layer 2+ Gigabit Ethernet Switch

with 48 10/100/1000BASE-T (RJ-45) Ports,

2 10-Gigabit SFP+ Ports,

and Optional Module with 2 10-Gigabit SFP+ Ports

ECS4510-28T

ECS4510-28P

ECS4510-28F

ECS4510-52T

E122012/ST-R03

149100000182A

149100000189A

149100000191A

– 5 –

ABOUT THIS GUIDE

PURPOSE This guide gives specific information on how to operate and use the

management functions of the switch.

AUDIENCE The guide is intended for use by network administrators who are

responsible for operating and maintaining network equipment;

consequently, it assumes a basic working knowledge of general switch

functions, the Internet Protocol (IP), and Simple Network Management

Protocol (SNMP).

CONVENTIONS The following conventions are used throughout this guide to show

information:

OTE

Emphasizes important information or calls your attention to related

features or instructions.

AUTION

Alerts you to a potential hazard that could cause loss of data, or

damage the system or equipment.

ARNING

Alerts you to a potential hazard that could cause personal injury.

RELATED PUBLICATIONS The following publication details the hardware features of the switch,

including the physical and performance-related characteristics, and how to

install the switch:

The Installation Guide

Also, as part of the switch’s software, there is an online web-based help

that describes all management related features.

BOUT

HIS

UIDE

– 6 –

REVISION HISTORY This section summarizes the changes in each revision of this guide.

DECEMBER 2012 REVISION

This is the third version of this guide. This guide is valid for software

release v1.3.1.7. This release adds support for Layer 3 lite, including static

and dynamic routing. It also includes information on the following changes:

◆Added support for ECS4510-52T. (See Figure 2, "Front Panel

Indicators," on page 101.)

◆Updated description for "Setting an IP Address" on page 83.

◆Added “L3 Interface” parameter to the static VLAN configuration pages.

(See "Configuring VLAN Groups" on page 196.)

◆Updated default settings for storm control rate limit. (See "Storm

Control" on page 260.)

◆Changed method of configuring an IPv4 address to follow conventions

for a Layer 3 switch. (See "Setting the Switch’s IP Address (IP Version

4)" on page 615.)

◆Removed DHCP Relay Option 82 as an unsupported Layer 2 feature.

This switch now only supports configuring the address for relay servers.

(See "Configuring DHCP Relay Service" on page 645 and "DHCP Relay"

on page 1362.)

◆Added a chapter describing the general commands for Layer 3 lite

functions, including IP interface configuration, configuring static routes,

and displaying the routing table. (See "General IP Routing" on

page 653.)

◆Added trace route function (See "Using the Trace Route Function" on

page 658.)

◆Added chapter on unicast routing, including description of general

routing and the Routing Information Protocol. (See "Unicast Routing"

on page 669.)

◆Added the command "terminal" on page 753.

◆Updated description of the command "interface" on page 972.

◆Change configuration mode to VLAN interface for "ip dhcp relay server"

on page 1362.

◆Added max-failures parameter to "traceroute6" on page 1395.

◆Added the command "ipv6 hop-limit" on page 1396.

BOUT

HIS

UIDE

– 7 –

SEPTEMBER 2012 REVISION

This is the second version of this guide. This guide is valid for software

release v1.2.2.0. It includes information on the following changes:

◆Added support for ECS4510-28F and ECS4510-28P. (See Figure 2,

"Front Panel Indicators," on page 101.)

◆Added “Media Type” to Parameter list under "Configuring by Port List"

on page 151.

◆Added “Timeout Mode” to Parameter list under "Configuring a Dynamic

Trunk" on page 172.

◆Updated information on maximum ACL rules in the Command Usage

section under "Access Control Lists" on page 347.

◆Added description of LLDP-MED TLVs reported by end-node devices in

the Parameters section under "Displaying LLDP Remote Device

Information" on page 428.

◆Added "Power over Ethernet" on page 438 for the ECS4510-28P.

◆Added support for ERPSv2 as described under "Ethernet Ring Protection

Switching" on page 484.

◆Added more information for DHCP Option 60, 66 and 67 statements in

the Command Usage section under "Specifying A DHCP Client

Identifier" on page 643.

◆Added support for PPPoE IA as described under "Configuring the PPPoE

Intermediate Agent" on page 646.

◆Added "TFTP Configuration Commands" on page 742.

◆Added PPPoE IA configuration commands as described under "PPPoE

Intermediate Agent" on page 877.

◆Added lacp timeout command on page 999.

◆Added "Power over Ethernet Commands" on page 1005.

◆Added commands for ERPSv2, including "non-revertive" on page 1095,

"raps-def-mac" on page 1100, "raps-without-vc" on page 1100, "rpl

neighbor" on page 1103, "rpl neighbor" on page 1103, "version" on

page 1105, "clear erps statistics" on page 1106, "erps clear" on

page 1107, "erps forced-switch" on page 1107, and "erps manual-

switch" on page 1109.

◆Added lldp dot3-tlv poe and lldp med-tlv ext-poe commands on page

page 1280 and page 1283, respectively for the ECS4510-28P.

◆Added more information for DHCP Option 60, 66 and 67 statements in

the Command Usage section under the ip dhcp client class-id command

on page 1356.

BOUT

HIS

UIDE

– 8 –

MAY 2012 REVISION

This is the first version of this guide. This guide is valid for software release

v1.1.2.1.

– 9 –

CONTENTS

ABOUT THIS GUIDE 5

CONTENTS 9

FIGURES 47

TABLES 61

SECTION I GETTING STARTED 67

1INTRODUCTION 69

Key Features 69

Description of Software Features 70

IP Routing 74

Address Resolution Protocol 75

System Defaults 76

2INITIAL SWITCH CONFIGURATION 79

Connecting to the Switch 79

Configuration Options 79

Required Connections 80

Remote Connections 81

Basic Configuration 82

Console Connection 82

Setting Passwords 82

Setting an IP Address 83

Downloading a Configuration File Referenced by a DHCP Server 90

Enabling SNMP Management Access 92

Managing System Files 94

Saving or Restoring Configuration Settings 95

ONTENTS

– 10 –

SECTION II WEB CONFIGURATION 97

3USING THE WEB INTERFACE 99

Connecting to the Web Interface 99

Navigating the Web Browser Interface 100

Home Page 100

Configuration Options 101

Panel Display 101

Main Menu 102

4BASIC MANAGEMENT TASKS 119

Displaying System Information 120

Displaying Hardware/Software Versions 121

Configuring Support for Jumbo Frames 122

Displaying Bridge Extension Capabilities 123

Managing System Files 125

Copying Files via FTP/TFTP or HTTP 125

Saving the Running Configuration to a Local File 127

Setting The Start-Up File 128

Showing System Files 129

Automatic Operation Code Upgrade 130

Setting the System Clock 134

Setting the Time Manually 134

Setting the SNTP Polling Interval 135

Configuring NTP 136

Configuring Time Servers 137

Setting the Time Zone 141

Configuring the Console Port 142

Configuring Telnet Settings 144

Displaying CPU Utilization 145

Displaying Memory Utilization 146

Resetting the System 147

5INTERFACE CONFIGURATION 151

Port Configuration 151

Configuring by Port List 151

Configuring by Port Range 154

Displaying Connection Status 155

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Edge-Core Schalten Handbücher

Edge-Core

Edge-Core AS6712-32X Bedienungsanleitung

Edge-Core

Edge-Core AS7535-28XB Bedienungsanleitung

Edge-Core

Edge-Core AS7712-32X Betriebsanleitung

Edge-Core

Edge-Core ECS2000-50P Bedienungsanleitung

Edge-Core

Edge-Core ES3528-WDM Programmierhandbuch

Edge-Core

Edge-Core ECS4120 Series Bedienungsanleitung

Edge-Core

Edge-Core ES4624-SFP Bedienungsanleitung

Edge-Core

Edge-Core ECS4150-54T Bedienungsanleitung

Edge-Core

Edge-Core ES3526YA Bedienungsanleitung

Edge-Core

Edge-Core Wedge100BF-65X Bedienungsanleitung

Edge-Core

Edge-Core ECS4620-28T Bedienungsanleitung

Edge-Core

Edge-Core Gigabit Ethernet Switch Bedienungsanleitung

Edge-Core

Edge-Core ECS1100-5P Bedienungsanleitung

Edge-Core

Edge-Core ECS4130-28T Bedienungsanleitung

Edge-Core

Edge-Core AS5610-52X Bedienungsanleitung

Edge-Core

Edge-Core ES4005V Bedienungsanleitung

Edge-Core

Edge-Core ECS4210-12P Bedienungsanleitung

Edge-Core

Edge-Core AGR420 Bedienungsanleitung

Edge-Core

Edge-Core AS7816-64X Bedienungsanleitung

Edge-Core

Edge-Core ECS4150-28P Bedienungsanleitung

Edge-Core

Edge-Core Direk Tronik 24/48-Port Programmierhandbuch

Edge-Core

Edge-Core ES4528V-38 Programmierhandbuch

Edge-Core

Edge-Core ECS1100-5P Bedienungsanleitung

Edge-Core

Edge-Core SMCGS26C-Smart Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

MiLAN

MiLAN MIL-SM2401M Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung