EdgeStar IP300P Bedienungsanleitung

TABLE OF CONTENTS

IMPORTANT SAFETY INSTRUCTIONS…………………………………………………1

PREPARING YOUR ICE MAKER FOR USE

IMPORTANT SAFETY TIPS.……………………………………………………………….2

GETTING TO KNOW YOUR UNIT…

……

….

OPERATING PROCEDURES & MAINTENANCE

UNPACKING YOUR ICE MAKER ..………….…………………………………………...4

CONNECTING YOUR ICE MAKER……………….……….……………………………..4

CLEANING AND MAINTAINING YOUR ICE MAKER….……………………………….4

USING YOUR ICE MAKER……………….……..………………………………………...5

TROUBLESHOOTING...……………………….……………………………………………6

TECHNICAL SPECIFICATIONS & CIRCUIT DIAGRAM…..……………..….………..7

LIMITED WARRANTY…………………………………………..……………..….………..8

TABLE OF CONTENTS and INTRODUCTIMPORTANT SAFETY INSTRUCTIONS ION

Your safety and the safety of others is very important.

We have provided many important safety messages in this manual and on your appliance.

Always read and obey all safety messages.

This is the safety alert symbol:

All safety messages will follow the safety alert symbol and the word “DANGER” or

“WARNING”.

DANGER

WARNING

These words mean:

You can be killed or seriously injured if you don’t immediately follow instructions.

All safety messages will tell you what the potential hazard is, tell you how to reduce the

chance of injury, and tell you what can happen if the instructions are not followed.

PREPARING YOUR ICE MAKER FOR USE

IMPORTANT SAFETY TIPS

When using electrical appliances, basic safety precautions should be followed to reduce the

risk of fire, electric shock, and/or injury to persons or property. Read all instructions before

using any appliance.

zDo not operate this or any other appliance with a damaged cord.

Connect to properly polarized outlets only. No other appliance should be plugged into the

same outlet. Be sure that the plug is fully inserted into the receptacle.

zDo not run cord over carpeting or other heat insulators. Do not cover the cord. Keep cord

away from traffic areas, and do not submerge in water.

zWe do not recommend the use of an extension cord, as it may overheat and become a

fire risk. If you must use an extension cord, use a cord of No.14 AWG minimum size and

rated for no less than 1875 watts.

zUnplug the ice maker before cleaning it or making repairs.

zExercise caution and use reasonable supervision when appliance is used near children.

zDo not clean your ice maker with flammable fluids. The fumes can create a fire hazard or

explosion.

zDo not tip over.

zDo not operate with side or back panels removed.

zIf the ice maker is brought in from outside in wintertime, give it a few hours to warm up to

room temperature before plugging it in.

GETTING TO KNOW YOUR UNIT

OPERATING PROCEDURES & MAINTENANCE

UNPACKING YOUR ICE MAKER

1. Remove the exterior and interior packaging. Check that ice basket and ice scoop are

included. If any parts are missing, please contact the vendor.

2. Clean the interior with lukewarm water and a soft cloth. Take out the ice basket and clean

it.

3. Find a location for your ice maker that is protected from direct sunlight and other sources

of heat (i.e., stove, furnace, radiator). Place the ice maker on a level surface. Maker sure

that there is at least 5 inches of space between the back and sides of your ice maker and

the wall.

4. Allow one hour for the refrigerant to settle before plugging ice maker in.

5. The appliance must be positioned so that the plug is accessible.

CONNECTING YOUR ICE MAKER

DANGER

* Improper use of the grounded plug can result in the risk of electrical shock. If the

power cord is damaged please call service.

1. This unit should be properly grounded for your safety. The power cord of this appliance is

equipped with a three-prong plug which mates with standard three prong wall outlets to

minimize the possibility of electric shock.

2. Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do not

under any circumstances cut or remove the third (ground) prong from the power cord. Any

questions concerning power and/or grounding should be directed toward a certified

electrician.

3. This appliance requires a standard 110~120 volt, 60Hz electrical outlet with three-prong

ground.

CLEANING AND MAINTAINING YOUR ICE MAKER

Before using your ice maker, you are strongly recommended to clean it thoroughly.

1. Take out the ice basket.

2. Clean the interior with diluted detergent, warm water and a soft cloth.

3. The outside of the ice maker should be cleaned regularly with a mild detergent solution

and warm water.

4. Dry the interior and exterior with a soft cloth.

5. When the machine is not in use, open the water drain cap to completely drain the water

reservoir.

USING YOUR ICE MAKER

1. Select the size of the ice cube by pressing the “Size” button. If the room temperature is

lower than 60°F, it is best to select the small or medium ice size, otherwise the ice cubes

might stick together.

2. Open the cover, remove the ice basket and pour water into tank.

Keep water level below the “Fill Line”.

3. Press “On” on the control panel to begin the ice making cycle.

4. The ice making cycle lasts 7 to 15 minutes, depending on the size of the ice cubes

selected.

5. While the ice maker is on, verify the water level periodically. If the water level is too low,

the ice maker will stop automatically, and the “Add Water” indicator will turn on.

Press the “Off” button, fill the unit with water, and then press the “On” button.

Allow the refrigerant inside the compressor at least 3 minutes to settle before restarting.

6. The ice maker automatically stops working when the ice basket is full.

7. If you fill the unit with water, but the ice maker still does not function, empty some water

out through the drain, then recap the drain. The machine should start automatically.

8. Change the water in the water reservoir periodically to ensure cleanliness and hygiene.

9. It is best to use tap water or bottled drinking water in the ice maker. Distilled water may not

work. If you do use distilled water and the ice maker will not function, try adding a little salt

into the water (a small amount of salt added to the water should be imperceptible).

10. If the ice does not taste good, or the unit develops a musty odor, try running a few cycles

of the ice maker with a mild white vinegar solution. Then empty out all the vinegar solution

and run a few cycles with plain water to eliminate all traces of the vinegar.

If the ice maker will not be used for an extended period of time, you should drain the water

from the reservoir.

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE SOLUTION

Low water level. Stop the ice maker, fill it with water,

and then restart it.

There is some air in the

lines.

Open the drain cap on the back of

the unit and drain out a small

amount of water. Replace the drain

cap and attempt to use the unit

again.

The “Add Water”

indicator is on.

The unit is filled with

distilled water- or some

other type of water with

no impurities.

Add a little bit of salt to the water or

use water from a different source

(tap water or bottled drinking water

is best).

The “Ice Full”

indicator is on. The ice basket is full. Remove ice from the ice basket.

The “Water” and

“Ice” indicators

are both flashing.

The ice pusher cannot

move.

Check if the ice is blocking the ice

pusher, otherwise, consult service.

The ice cycle is too long.

Stop the ice maker, and restart it

when the ice blocks melt. Select

the small ice button.

The ice cubes

stick together. The water temperature in

the inner tank is too low.

Change the water in the inner tank.

The ideal water temperature is

45°-90°F.

The unit is being run off

the wrong voltage or

frequency.

Plug the unit into a 110/120 Volt,

60 Hertz power source.

The compressor

makes a loud

buzzing noise The compressor was

damaged in shipping. Contact the shipper.

The unit does

nothing

Power is not supplied to

the unit.

Plug the unit into a 110/120 Volt,

60 Hertz power source.

The ambient temperature

or the water temperature

is too high.

Please run the ice maker in

temperatures below 90°F and/or

pour colder water into tank.

Refrigerant leakage. Consult a qualified technician.

The ice making

cycle seems

normal but no ice

is produced. A pipe in the cooling

system is blocked. Consult a qualified technician.

TECHNICAL SPECIFICATIONS & CIRCUIT DIAGRAM

TECHNICAL SPECIFICATIONS

(

)

CIRCUIT DIAGRAM

For information on EdgeStar and to view our

full line of products, please visit our website:

http://www.edgestar.com

EdgeStar Products

Box 81336

Austin, Texas 78708-1336

Toll Free: 1-866-319-5473

Inhaltsverzeichnis

Andere EdgeStar Eiswürfelbereiter Handbücher

EdgeStar

EdgeStar IP210 Bedienungsanleitung

EdgeStar

EdgeStar IP200 Series Handbuch

EdgeStar

EdgeStar IB450SSP Bedienungsanleitung

EdgeStar

EdgeStar IP210SS Bedienungsanleitung

EdgeStar

EdgeStar PIM300SS Bedienungsanleitung

EdgeStar

EdgeStar PIM100BL Bedienungsanleitung

EdgeStar

EdgeStar IB1000SS Bedienungsanleitung

EdgeStar

EdgeStar IP211SS Bedienungsanleitung

EdgeStar

EdgeStar OIM450SS Bedienungsanleitung

EdgeStar

EdgeStar PIM200SS Bedienungsanleitung

EdgeStar

EdgeStar IB120SS Bedienungsanleitung

EdgeStar

EdgeStar 01M450SS Bedienungsanleitung

EdgeStar

EdgeStar IB450SS Bedienungsanleitung

EdgeStar

EdgeStar IB250SS Bedienungsanleitung

EdgeStar

EdgeStar IB120SS Bedienungsanleitung

EdgeStar

EdgeStar IF80SS Bedienungsanleitung

EdgeStar

EdgeStar IW400SS Bedienungsanleitung

EdgeStar

EdgeStar IP200 Series Bedienungsanleitung

EdgeStar

EdgeStar IB450SSP Bedienungsanleitung

EdgeStar

EdgeStar OIM450SS Bedienungsanleitung

EdgeStar

EdgeStar IB450 Bedienungsanleitung

EdgeStar

EdgeStar IB650 Gebrauchs- und Pflegehandbuch

EdgeStar

EdgeStar IB450BL Bedienungsanleitung

EdgeStar

EdgeStar IB450SSP Bedienungsanleitung

Beliebte Eiswürfelbereiter Handbücher anderer Marken

Hoshizaki

Hoshizaki KMD-460MWJ Bedienungsanleitung

Sub-Zero

Sub-Zero 315I Gebrauchsanweisung

Kenmore

Kenmore 2217402A Bedienungsanleitung

Cornelius

Cornelius WM600 Betriebsanleitung

GE XPIO43SCSS Bedienungsanleitung

Hoshizaki

Hoshizaki KMD-901MAH Bedienungsanleitung

Whynter

Whynter FIM-450HA Bedienungsanleitung

U-Line

U-Line UMCR014-SC01A Installationshandbuch

Andrew James

Andrew James AJ000522 Bedienungsanleitung

Scotsman

Scotsman CME1356 Bedienungsanleitung

Scotsman

Scotsman ACM 25 Bedienungsanleitung

Kärcher

Kärcher IP 120 Bedienungsanleitung

U-Line

U-Line SS1095 Bedienungsanleitung

Maytag

Maytag MIM1554WRS - Ice Maker Bedienungsanleitung

Hoshizaki

Hoshizaki KM-630MAH Bedienungsanleitung

Princess

Princess Yonanas Bedienungsanleitung

Unold

Unold 48946 Bedienungsanleitung

Electrolux

Electrolux E15IM60GP Bedienungsanleitung