Efento SP. J.
Ul.Krupnicza 14/5
31-123 Kraków
●Measurement problem - exclamation mark icon next to the sensor’s name. Sensor
is damaged and can’t take proper measurements (measurements are out of scale, or
the device is not able to take measurements at all). If you see this warning, contact
Efento’s support team at help.efento.io.
●Sensor has not been restarted - during the first startup, we recommend resetting
the sensor to set the measurement period and time. If the sensor has not been reset,
all measurements data will be lost after removing the battery.
●Software update - if a new version of the software is available, information about it
will appear under the sensor name and serial number. To update the sensor’s
software, simply click on it and enter the sensor's PIN code (you can find it on the
sticker on the enclosure).
Application configuration
To configure the application settings, click on the menu in the upper left corner of the
application. Open the settings where you will be able to:
●Activation Energy settings are a constant used when calculating the average kinetic
temperature. Its default value is 83.14472 kJ / mol.
●Default encryption keys settings are used to automatically decrypt the sensor
communication when it is encrypted with the same key (e.g. key "qwerty123" has
been added as the default encryption key in the application. From now on, each
sensor encrypted with the key "qwerty123" will be decrypted by the application
automatically). It can add up to five default encryption keys.
●Location in PDF reports - if this option is selected, the address of the place where
the report was generated will be added to the footer of PDF reports generated by the
application. The address is downloaded based on the GPS signal from Google Maps
●Forget sensor - the application removes the encryption keys and reset codes of the
selected sensor
Sensor configuration
From the list of the sensors in range, select the one you want to configure and tap on it. If
you selected an encrypted sensor, enter the correct encryption key to allow the application to
communicate with it. The application will connect to the sensor and you will be able to
configure the sensor. Enter the settings menu by tapping three dots icon in the upper right
corner of the screen to:
●Change sensor’s name - enter the new name of the selected sensor, and then enter
the PIN code (The PIN code is a four-digit number 4 assigned to each sensor - you
can find it on a sticker on the sensor's enclosure). If you have entered the correct
PIN, you will be able to change the device name. The new name will be visible on
every phone / tablet that connects to the sensor.
●Clear sensor’s memory and / or change the measurement period - select a new
measurement period using the sliders and enter the PIN code (you will not be asked
to enter the PIN code, if you have already entered the PIN code for this sensor
before). The application automatically calculates how many measurements will be
