Eiki EIP-X350 Bedienungsanleitung

MULTIMEDIAPROJECTOR

MODEL EIP-X350

OWNER’S MANUAL

EN-1

Federal Communication Commission Notice

Note : This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures :

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Use of shielded cable is required to comply with class B limits in Subpart B of Part 15

of FCC Rules.

Do not make any changes or modifications to the equipment unless otherwise specified

in the instructions. If such changes or modifications should be made, you could be

required to stop operation of the equipment.

ModelNumber : EIP-X350

Trade Name : EIKI

Responsible party : EIKI International, Inc.

Address : 30251 Esperanza Rancho Santa Margarita CA 92688-2132

Telephone No. : 800-242-3454 (949-457-0200)

EN-2

Safety Instructions

Read all of these instructions before you operate your projector and save for future

reference.

CAUTION : TO REDUCE THE RISK OF ELECTRIC

SHOCK, DO NOT REMOVE COVER (OR

BACK). NO USER-SERVICEABLE PARTS

INSIDE EXCEPT LAMP REPLACEMENT.

REFER SERVICING TO QUALIFIED

SERVICE PERSONNEL.

THIS SYMBOL INDICATES THAT DANGEROUS

VOLTAGE CONSTITUTING A RISK OF ELECTRIC

SHOCK IS PRESENT WITHIN THIS UNIT.

THIS SYMBOL INDICATES THAT THERE ARE

IMPORTANT OPERATING AND MAINTENANCE

INSTRUCTIONS IN THE OWNER'S MANUAL WITH

THIS UNIT.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

0.7'(20cm)

1.5'(50cm) 3'(1m) 1.5'(50cm)

SIDE and TOP

REAR

Allowing the proper amount of space on the top, sides, and rear of the projector

cabinet is critical for proper air circulation and cooling of the unit. The dimension

shown here indicate the minimum space required. If the projector is to be built into

a compartment or similarly enclosed, these minimum distances must be maintained.

n appliance and cart combination should

e moved with care. Quick stops,

xcessive force, and uneven surfaces

ay cause the appliance and cart

ombination to overturn.

EN-3

1. Check that the operating voltage of your unit is identical with the voltage of your

local power supply.

2. Should any liquid or solid object fall into the cabinet, unplug the unit and have it

checked by the qualified personnel before operating it further.

3. Do not attempt to service this product yourself, as opening or removing covers may

damage the components inside and will void your warranty.

4. Do not place this product on an unstable cart, stand, or table. The product may fall,

causing serious damage to the product.

5. Unplug the unit from the wall socket if it is not to be used for several days. To

disconnect the cord, pull it out by the plug. Never pull the cord itself.

6. The wall socket should be near the unit and easily accessible.

7. Do not place the projector where the cord can be stepped on as this may result in

fraying or damage to the lead or the plug. Be alert to tripping hazards.

8. Never look into the projector lens when the lamp is switched on as the bright light

can damage your eyes. Never let children look into the lens when it is on.

9. Do not place your hand or objects near the ventilation holes. The air coming out is hot.

10. Never open any covers on the projector except the lamp cover. Dangerous electrical

voltages inside the projector can cause severe injury. Except as specifically directed

in this User’s Manual, do not attempt to service this product yourself. Refer all

servicing to qualified service personnel.

11. Unplug the projector from the wall socket before cleaning. Use a damp cloth for

cleaning the projector housing. Do not use liquid or aerosol cleaners.

12. Keep the plastic packing materials (from the projector, accessories and optional

parts) out of the reach of children as these bags may result in death by suffocation.

Be particularly careful around the small children.

13. For ventilation reasons, the fan continues to operate after the projector has been

powered off. Please do not unplug the power cord until the fan stops.

14. The projector is equipped with ventilation holes (intake) and ventilation holes

(exhaust). Do not block or place anything near these slots, or internal heat build-up

may occur, causing picture degradation or damage to the projector.

15. When you replace the projector lamp, never touch the new bulb with your bare

hands. The invisible residue left by the oil on your hands may shorten the bulb life.

Use lint-free gloves or finger cots are recommended.

EN-4

16. The product should be situated away from heat sources such as radiators, heat

registers, stoves, or other products (including amplifiers) that produce heat.

17. Do not overload wall outlets, extension cords, or integral convenience receptacles

as this can result in a risk of fire or electric shock.

EN-5

CONTENTS

Introduction ............................................................................................................... 6

Projector Features ............................................................................................. 6

Package Contents .............................................................................................. 7

Projector Overview ........................................................................................... 8

Using the Product ................................................................................................... 10

Control Panel ................................................................................................... 10

Terminals ......................................................................................................... 11

Remote Control ................................................................................................ 12

Installing the Batteries ...................................................................................... 13

Notes on AC Power Cord ................................................................................. 14

Remote Control Operation ................................................................................ 15

Installation ............................................................................................................... 16

Connecting the Projector .................................................................................. 16

Powering On/Off the Projector ........................................................................ 17

Adjusting the Projector .................................................................................... 18

Menu Operation ...................................................................................................... 21

Setup Menu ..................................................................................................... 22

Picture Menu .................................................................................................... 23

Source Menu ................................................................................................... 25

Help Menu ........................................................................................................ 25

Maintenance ........................................................................................................... 26

Cleaning the Lens ............................................................................................ 26

Cleaning the Projector Housing ........................................................................ 26

Replacing the Lamp .......................................................................................... 27

Specifications ......................................................................................................... 29

Appendix ................................................................................................................ 30

LED Indicator Messages .................................................................................. 30

Compatibility Modes ......................................................................................... 31

Troubleshooting ............................................................................................... 32

EN-6

Introduction

Projector Features

The projector integrates high-performance optical engine projection and a user-friendly

design to deliver high reliability and ease of use.

The projector offers the following features:

Single chip 0.7" Texas Instruments DLP®technology

XGA (1024 x 768 pixels) real resolution

Auto image re-sizing (Auto-Sync.) to 1024 x 768 full screen with scaling compression

compatibility for VGA, SVGA, XGA and SXGA*

Compatibility with Macintosh®computers

Compatibility with NTSC, PAL, SECAM, and HDTV

Multi-function remote control

D-Sub 15-pin terminal for analog video connectivity

User-friendly, multi-language on-screen display (OSD)

Advanced electronic keystone correction

* means compressed.

EN-7

Package Contents

When you unpack the projector, make sure you have all these components:

Projector with Lens Cap AC Power Cord VGA Cable (D-SUB to D-SUB)

Composite Video Cable

Owner’s Manual

Remote Control (IR)

Laser Page up

Page down

Hide

Resync

Quick Start Guide

AAA size batteries for

remote control

Save the original shipping carton and packing material; they will come

in handy if you ever to ship your unit. For maximum protection, repack

your unit as it was originally packed at the factory.

Audio Cable

Projector Carrying Case

S-Video Cable

EN-8

Projector Overview

Front View

1 Lens cap

2 Lens cap strap

3Elevator foot

4 Front IR remote control

sensor

5 Elevator button

3 4 6 87

910

12 12

51 2

6Projection lens

7 Focus ring

8 Tilt-adjustment foot

9 Control panel

10 Zoom ring

11 Speaker

12 Ventilation holes

EN-9

1 2 3

75 6

Rear View

1 Rear IR remote control sensor

2 Terminals

3 Main power switch

4 AC power socket

5 Tilt-adjustment foot

6Ventilation holes

7Kensington lock

This projector can be used with a ceiling mount for support. The ceiling

mount is not included in the package.

Bottom View

1 Lamp cover

2Ceiling mount

Inhaltsverzeichnis

Andere Eiki Projektor Handbücher

Eiki

Eiki SXGA Powerhouse Two Series LC-SX2U Bedienungsanleitung

Eiki

Eiki Conference LC-WUL100 Installations- und Betriebshandbuch

Eiki

Eiki EK-308U Bedienungsanleitung

Eiki

Eiki LC-WNB3000N Bedienungsanleitung

Eiki

Eiki LC-XS31 Bedienungsanleitung

Eiki

Eiki EIP-4500 Bedienungsanleitung

Eiki

Eiki LC-XBL21 Bedienungsanleitung

Eiki

Eiki LC-X990 Einrichtungshandbuch

Eiki

Eiki EIP-3500 Bedienungsanleitung

Eiki

Eiki Xenon ARC EX-1500 Bedienungsanleitung

Eiki

Eiki LC-XSP2600 Bedienungsanleitung

Eiki

Eiki LC-SM4 Bedienungsanleitung

Eiki

Eiki EK-812U Bedienungsanleitung

Eiki

Eiki EK-800U Bedienungsanleitung

Eiki

Eiki LC-X984 Einrichtungshandbuch

Eiki

Eiki LC-6000U Einrichtungshandbuch

Eiki

Eiki LC-4300 Bedienungsanleitung

Eiki

Eiki Brilliant LC-SB15 Bedienungsanleitung

Eiki

Eiki LC-SXIU Einrichtungshandbuch

Eiki

Eiki EK-306U Bedienungsanleitung

Eiki

Eiki LC-XB41 Bedienungsanleitung

Eiki

Eiki EIP-X5500 Bedienungsanleitung

Eiki

Eiki LC-XGA980U Einrichtungshandbuch

Eiki

Eiki LC-120 Einrichtungshandbuch

Beliebte Projektor Handbücher anderer Marken

iEmmet

iEmmet MP-312 Bedienungsanleitung

Epson

Epson VS400 Bedienungsanleitung

Sony

Sony VPL-HS10 Marketing Specifications & Features Bedienungsanleitung

Sony

Sony VPL-HW65ES Service-Handbuch

Toshiba

Toshiba TLP-791U Bedienungsanleitung

Philips

Philips LC1341 Referenzhandbuch

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Bedienungsanleitung

NEC

NEC NP600S EDU Bedienungsanleitung

BenQ

BenQ SH753P Bedienungsanleitung

Epson

Epson PowerLite Pro Cinema 6020UB Bedienungsanleitung

Epson

Epson PowerLite Home Cinema 705HD Bedienungsanleitung

Christie

Christie LHD700 Bedienungsanleitung

Navitar

Navitar FX Bedienungsanleitung

InFocus

InFocus LitePro 560 Bedienungsanleitung

Sony

Sony SRX-R815P Bedienungsanleitung

Vivitar

Vivitar DP1500 X Bedienungsanleitung

Acer

Acer C20 Series Bedienungsanleitung

Asus

Asus ZenBeam Latte Bedienungsanleitung