Eiki LC-WAU200 Bedienungsanleitung

Quick Start Guide

MODEL

Use this book as a start guide when setting up the projector.

For detailed information about installation, setup and operation of projector,

refer to the owner's manual on the CD-ROM.

Read the safety instructions in this quick start guide before using projector.

LC-XAU200

LC-WAU200

Quick Start Guide

MODEL

Use this book as a start guide when setting up the projector.

For detailed information about installation, setup and operation of projector,

refer to the owner's manual on the CD-ROM.

Read the safety instructions in this quick start guide before using projector.

LC-XAU200

LC-WAU200

Package Overview

Unpack and inspect the box contents to ensure all parts listed below are in

the box. If something is missing, please contact your dealer.

Owner's Manual(CD) AC Power cord Remote control with batteries

(AAA or LR03)

VGA cable Quick start guide

Adjusting

Positioning the projector

Note:

● The brightness in a room has a great inuence on picture quality. It is recommended to limit the

ambient lighting in order to get the best image.

● All measurements are approximate and may vary from the actual sizes.

Install remote control batteries

① Open the battery

compartment lid.

②Install new batteries

into the compartment.

③Replace the

compartment lid.

Two AAA batteries

For correct polarity

(+ and –), be sure

battery terminals

are in contact

with pins in the

compartment.

Operating range

Point the remote control toward the projector

remote receiver when pressing any button.

The maximum operating range for the remote

control is about 5 meters and 60 degrees

vertically and horizontally.

30°

LC-XAU200 (4:3):

LC-WAU200(16:10):

Screen size

(WxH)mm

4:3 aspect ratio

50" 60" 70" 80" 100"

1016x762 1219x914

1422x1067 1626x1219

2032x1524

Throw Distance 0.46m 0.55m 0.65m 0.75m 0.94m

Screen size

(WxH)mm

16:10 aspect

ratio

50" 60" 70" 80" 100"

1077x671 1292x808

1508x942 1723x1077

2154x1346

Throw Distance 0.48m 0.59m 0.69m 0.80m 1.00m

0.55 m

0.65 m

0.75 m

0.94 m

Fixed

50”

60”

70”

80”

100”

0.46 m

A:B=21:-1

A:B=5.3:-1

A:B=7.25:-1

0.60 m

0.71 m

0.82m

1.03 m

Fixed

50”

60”

70”

80”

100”

0.50 m

0.59 m

0.69 m

0.80 m

1.00 m

Fixed

50”

60”

70”

80”

100”

048 m

(Diagonal:Inch)

(Center)

0.55 m

0.65 m

0.75 m

0.94 m

Fixed

50”

60”

70”

80”

100”

0.46 m

A:B=21:-1

A:B=5.3:-1

A:B=7.25:-1

0.60 m

0.71 m

0.82m

1.03 m

Fixed

50”

60”

70”

80”

100”

0.50 m

0.59 m

0.69 m

0.80 m

1.00 m

Fixed

50”

60”

70”

80”

100”

048 m

(Diagonal:Inch)

(Center)

Adjusting

1.Complete peripheral connections (with a

computer, HD recorder, etc.) before turning

on the projector.

2.Connect the projector’s AC power cord into

AC outlet.The POWER indicator turns red.

3.Press the POWER button on control panel or

on the remote control. The POWER indicator

becomes green and the cooling fans start to

work. The preparation display appears on the

screen and the countdown starts.

4.If the projector is locked with a PIN code, a

PIN code input dialog box appears. Enter the

PIN code as instructed below.

Turn on the projector

The projection angle can be adjusted up to 10

degrees with the adjustable foot.

Lift the front of the projector and press the lock

on the adjustable foot to release it.

The foot is then locked. Rotate the foot to

adjust the height and tilt angle.

Keystone distortion of projected images can be

corrected by remote control or menu operation.

Adjustable foot

Connecting the AC power cord

This projector uses nominal input voltages of

100–240V AC and it automatically applies to

different input voltages. It is designed to work

with a single-phase power system having a

grounded neutral conductor. To reduce the risk

of electrical shock, do not plug into any other

type of power system. If you are not sure of

the type of power being supplied, consult your

authorized dealer or service station. Connect

the projector with all peripheral equipment

before turning it on.

Connect the AC power cord to the projector.

The AC outlet should be near this equipment

and must be easily accessible.

Note:

Note:

For safety, unplug the AC power cord when the projector is not in use. When the projector is

connected to an outlet with AC power cord, it is in stand-by mode and consumes a little electric

power.

Connecting to computer(Digital and analog RGB)

Cables used for connection:

● VGA cable ● Serial control cable*

● HDMI cable*

(*=Cables are not supplied with the projector)

HDMI output

HDMI

cable

HDMIRS-232C port

Serial output

Serial

control

cable

Monitor output Monitor input

VGA

cable

VGA

cable

VGA input VGA output

This terminal is

switchable. Set

up the terminal as

either VGA IN 2 or

VGA OUT. (See

page 42.)

Connecting

HDMI output

HDMI

cable

HDMI

Connecting to video equipment

Cables used for connection:

● Video cable* ● S-Video cable*

● RCA cable* ● Audio cable*

● HDMI cable*

(*=Cables are not supplied with the projector)

S-VIDEO IN

S-video

output

Video

output

Component

output

Audio

output

Audio

output

Audio

output

VIDEO IN

S-VIDEO

cable

RCA

cable

Audio

cable

Audio

cable

Audio

cable

Video

cable

COMPONENT AUDIO IN

L/R AUDIO IN

L/R

Connecting

(R) (L)

Audio

cable

Audio cable

(stereo)

Audio cable

(stereo)

Note: The left and right

channels are combined when

there is only the L(mono) is

inserted.

External audio equipment

Connecting to audio equipment

Cables used for connection:

● Audio cable*

(*=Cables are not supplied with the projector)

Audio input

Audio output

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Eiki Projektor Handbücher

Eiki

Eiki LC-XGA980E Einrichtungshandbuch

Eiki

Eiki LC-XB22 Bedienungsanleitung

Eiki

Eiki LC-XT4U Bedienungsanleitung

Eiki

Eiki LC-X4L Bedienungsanleitung

Eiki

Eiki LC-XBM21 Bedienungsanleitung

Eiki

Eiki EK-355UK Bedienungsanleitung

Eiki

Eiki LC-W4 Einrichtungshandbuch

Eiki

Eiki LC-X85 Bedienungsanleitung

Eiki

Eiki LC-WB42NA Installations- und Betriebshandbuch

Eiki

Eiki LC-180AR Bedienungsanleitung

Eiki

Eiki LC-7000U Einrichtungshandbuch

Eiki

Eiki LC-WGC500 Bedienungsanleitung

Eiki

Eiki LC-XNS2600 Bedienungsanleitung

Eiki

Eiki ESL Series Einrichtungshandbuch

Eiki

Eiki LC-SD15 Bedienungsanleitung

Eiki

Eiki LC-WXL200 Bedienungsanleitung

Eiki

Eiki LC-XB21A Bedienungsanleitung

Eiki

Eiki LC-XIP2610 Bedienungsanleitung

Eiki

Eiki LC-XB24 Bedienungsanleitung

Eiki

Eiki EIP-3000N Benutzerhandbuch

Eiki

Eiki LC-WNB3000N Bedienungsanleitung

Eiki

Eiki EK-355U Bedienungsanleitung

Eiki

Eiki EIP-10V Fehlerbehebungshandbuch

Eiki

Eiki LC-XAU200 Bedienungsanleitung

Beliebte Projektor Handbücher anderer Marken

iEmmet

iEmmet MP-312 Bedienungsanleitung

Epson

Epson VS400 Bedienungsanleitung

Sony

Sony VPL-HS10 Marketing Specifications & Features Bedienungsanleitung

Sony

Sony VPL-HW65ES Service-Handbuch

Toshiba

Toshiba TLP-791U Bedienungsanleitung

Philips

Philips LC1341 Referenzhandbuch

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Bedienungsanleitung

NEC

NEC NP600S EDU Bedienungsanleitung

BenQ

BenQ SH753P Bedienungsanleitung

Epson

Epson PowerLite Pro Cinema 6020UB Bedienungsanleitung

Epson

Epson PowerLite Home Cinema 705HD Bedienungsanleitung

Christie

Christie LHD700 Bedienungsanleitung

Navitar

Navitar FX Bedienungsanleitung

InFocus

InFocus LitePro 560 Bedienungsanleitung

Sony

Sony SRX-R815P Bedienungsanleitung

Vivitar

Vivitar DP1500 X Bedienungsanleitung

Acer

Acer C20 Series Bedienungsanleitung

Asus

Asus ZenBeam Latte Bedienungsanleitung