Eiki LC-XNS2600 Bedienungsanleitung
Quick Start Guide
MODEL
Use this book as a start guide when setting up the projector.
For detailed information about installation, setup and operation of projector,
refer to the owner's manual on the CD-ROM.
Read the safety instructions in this quick start guide before using projector.
LC-XNS2600
LC-XNS3100
LC-WNS3200
Quick Start Guide
MODEL
Use this book as a start guide when setting up the projector.
For detailed information about installation, setup and operation of projector,
refer to the owner's manual on the CD-ROM.
Read the safety instructions in this quick start guide before using projector.
LC-XNS2600
LC-XNS3100
LC-WNS3200
5
Package Overview
Unpack and inspect the box contents to ensure all parts listed below are in
the box. If something is missing, please contact your dealer.
User's Manual(CD) AC Power cord Remote control with batteries
(AAA or LR03)
VGA cable Quick start guide
6
Adjusting
XNS2600,XNS3100 (4:3):
WNS3200 (16:10):
Positioning the projector
3Note:
ƽ7he brightness in a room has a great inÀuence on picture Tuality. It is recommended to limit the
ambient lighting in order to get the best image.
ƽAll measurements are approximate and may vary from the actual sizes.
Screen size
(WxH)mm
4:3 aspect
ratio
30100150200300
610x457 2032x1524
3048x2286 4064x3048
6096x4572
Maximum 0.88m 3.00m 4.49m 6.00m 9.02m
Minimum 1.06m 3.60m 5.40m 7.21m 10.83m
Screen size
(WxH)mm
16:10 aspect
ratio
30100150200300
646x404 2154x1346
3231x2019 4308x2692
6462x4039
Maximum 0.94m 3.17m 4.77m 6.37m 9.56m
Minimum 1.12m 3.81m 5.73m 7.64m 11.48m
30”
(Diagonal:Inch)
0D[ 0LQ
&HQWHU
6:1
0.88m
3.00m
4.49m
6.00m
9.02m
10.83m
30”
(Diagonal:Inch)
0D[ 0LQ
&HQWHU
13:1
0.94m
3.17 m
4.77 m
6.37 m
9.56 m
11.48m
Install remote control batteries
①Open the battery
compartment lid. ②Install new batteries
into the compartment. ③Replace the
compartment lid.
Two AAA batteries
For correct polarity
(+ and –), be sure
battery terminals
are in contact
with pins in the
compartment.
Operating range
Point the remote control toward the projector
remote receiver when pressing any button.
The maximum operating range for the remote
control is about 5 meters and 60 degrees
vertically and horizontally.
30°
30°
5m
7
Adjusting
1.Complete peripheral connections (with a
computer, VCR,etc.) before turning on the
projector.
2. Connect the projector’sAC power cord into
AC outlet.The POWER indicator turns red.
3. Press the POWER button on top control or
on the remote control. The POWER indicator
becomes green and the cooling fans start to
work. The preparation display appears on
the screen and the countdown starts.
4. If the projector is locked with a PIN code, a
PIN code input dialog box appears. Enter
the PIN code as instructed below.
Turn on the projector
The projection angle can be adjusted up to
10.0 degrees with the adjustable foot.
Lift the front of the projector and press the lock
on the adjustable foot to release it.
The foot is then locked. Rotate the foot to
adjust the height and tilt angle.
Keystone distortion of projected images can be
corrected by remote control or menu operation.
Adjustable foot
Adjustable foot
Connecting the AC power cord
This projector uses nominal input voltages of
100–240V AC and it automatically applies to
different input voltages. It is designed to work
with a single-phase power system having a
grounded neutral conductor. To reduce the risk
of electrical shock, do not plug into any other
type of power system. If you are not sure of
the type of power being supplied, consult your
authorized dealer or service station. Connect
the projector with all peripheral equipment
before turning it on.
Connect the AC power cord to the projector.
The AC outlet should be near this equipment
and must be easily accessible.
Note:
3Note:
For safety, unplug the AC power cord when the projector is not in use. When the projector is
connected to an outlet with AC power cord, it is in stand-by mode and consumes a little electric
power.
8
Connecting to computer(Digital and analog RGB)
Cables used for connection:
Ɣ9*$FDEOHƔ6HULDOFRQWUROFDEOH
Ɣ+'0,FDEOH
&DEOHVDUHQRWVXSSOLHGZLWKWKHSURMHFWRU
HDMI output
HDMI
cable
HDMIRS-232C port
Serial output
Serial
control
cable
Monitor output Monitor input
VGA
cable VGA
cable
VGA input VGA output
This terminal is
switchable. Set
up the terminal as
either VGA IN 2 or
VGA OUT. (See
page 42.)
Connecting
9
Connecting to video equipment (Video, S-Video)
Cables used for connection:
Ɣ9LGHRFDEOHƔ69LGHRFDEOH
Ɣ5&$FDEOHƔ$XGLRFDEOH
&DEOHVDUHQRWVXSSOLHGZLWKWKHSURMHFWRU
S-VIDEO IN
S-video
output Video
output
Component
output Audio
output Audio
output Audio
output
VIDEO IN
S-VIDEO
cable
RCA
cable Audio
cable Audio
cable Audio
cable
Video
cable
COMPONENT AUDIO IN
L/R AUDIO IN
L/R AUDIO IN
L/R
Connecting
10
Connecting
(R) (L)
(R) (L)
Audio
cable
Audio cable
(stereo) Audio cable
(stereo)
Note: The left and right
channels are combined when
there is only the L(mono) is
inserted.
External audio equipment
Connecting to audio equipment
Cables used for connection:
Ɣ$XGLRFDEOH
&DEOHVDUHQRWVXSSOLHGZLWKWKHSURMHFWRU
Audio input
Audio input
Audio output
Audio output
Andere Handbücher für LC-XNS2600
3
Dieses Handbuch passt für folgende Modelle
2
Inhaltsverzeichnis
Sprachen:
Andere Eiki Projektor Handbücher
Eiki
Eiki OHP-5751 Bedienungsanleitung
Eiki
Eiki LC-100 Bedienungsanleitung
Eiki
Eiki LC-SD10 Bedienungsanleitung
Eiki
Eiki LC-XG250L* Bedienungsanleitung
Eiki
Eiki LC-UXT3 Einrichtungshandbuch
Eiki
Eiki LC-XBM21 Bedienungsanleitung
Eiki
Eiki LC-HDT1000 Bedienungsanleitung
Eiki
Eiki EX-6100 Bedienungsanleitung
Eiki
Eiki LC-XT4U Bedienungsanleitung
Eiki
Eiki LC-X3L Bedienungsanleitung
Eiki
Eiki LC SX4L LC-SX4L LC-SX4L Einrichtungshandbuch
Eiki
Eiki 16mm Bedienungsanleitung
Eiki
Eiki LC-XIP2600 Installations- und Betriebshandbuch
Eiki
Eiki Projector Bedienungsanleitung
Eiki
Eiki LC-XNB5MS Bedienungsanleitung
Eiki
Eiki LC-XB200A Bedienungsanleitung
Eiki
Eiki LC-XB42 Bedienungsanleitung
Eiki
Eiki LC-XGA982U Bedienungsanleitung
Eiki
Eiki EK-100W Bedienungsanleitung
Eiki
Eiki LC-XWP2000 Bedienungsanleitung
Beliebte Projektor Handbücher anderer Marken
Panasonic
Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Bedienungsanleitung
NEC
NEC NP600S EDU Bedienungsanleitung
BenQ
BenQ SH753P Bedienungsanleitung
Epson
Epson PowerLite Pro Cinema 6020UB Bedienungsanleitung
Epson
Epson PowerLite Home Cinema 705HD Bedienungsanleitung
Christie
Christie LHD700 Bedienungsanleitung
