Page 2 of 12
Drawing : - TPC159
Issue : - 4
Date : - 24/11/16
UNPACKING
Carefully remove the LD-82 dehumidifier process dryer and the Universal
Controller from its transit box and visually check for signs of transit damage. If
there is evidence of damage DO NOT attempt to operate the units, call your
supplier for advice. Do not discard the packing; it will be useful when
transporting the dehumidifier unit in the future.
INTRODUCTION
The LD-82 dehumidifier process dryer is supplied complete with a Universal
Controller (STC1) ready for installation into a pre-built drying chamber.
Instructions for the building of the drying chamber can be supplied by Ebac
Ltd.
Ask for the Ebac Technical Publication (TP 132), “Wood Drying with the Ebac
range of small scale wood dryers”
The LD-82 dehumidifier process dryer removes moisture from the air that is
circulating through the unit.
The LD-82 dehumidifier process dryer requires no previous experience with
drying as it is simple to install and operate. The process dryer is energy
efficient, quiet to operate and will cause no pollution problems.
The Ebac method of drying is a process of dehumidification. The LD-82
dehumidifier process dryer is placed in a sealed chamber with the produce
required to be dried. By continually removing moisture from the air which is
circulated through the product stack, the LD-82 process dryer creates a
condition in which the product progressively releases its moisture under the
controlled conditions.
As the process is one of re-circulation of the same air (within the chamber),
minimal energy loss occurs and therefore the running costs are kept low.
Capital costs are also kept low with the Ebac LD-82 dehumidifier process
dryer. However, the dried product is of the highest quality with consistent and
even moisture content.
Because the drying process is carried out within the controlled conditions, the
repeatability of each batch of product being dried is always of the same high
quality and moisture content.
The LD-82 dehumidifier process dryer themselves are easily installed in the
ready made chamber of the requisite size.
