Ekwb EK-FC970 GTX TF5 Handbuch

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.0. Released on 9th of October, 2014.

Installation and mounting manual for EK-FC970 GTX TF5 Backplate

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability

whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwb.com for updates. Before

installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

STEP 1: GENERAL INFORMATION. Sample picture of GeForce 980 GTX TF5 series graphics card.

STEP 2: PREPARING YOUR GRAPHICS CARD

EK-FC970 GTX TF5 Backplate is very easy to install. First install EK-FC970 GTX TF5 series water block according to its installation manual. If you

have it already installed, please check the picture below to see which mounting screws are to be left in their position and which are to be

removed. Please remove the four (4) M3x4 DIN7985 screws and their washers as well (marked with arrow).

STEP 3: APPLYING THE THERMAL PADS

EK-FC970 GTX TF5 Backplate features passive cooling of the printed circuit board and it’s components therefore it is mandatory to install the

enclosed thermal pad. Please install enclosed thermal pads (Thermal Pad A –1mm (100x16), Thermal Pad D –0,5mm (100x16) ) as shown on

the picture below. You may need to trim the excess thermal pad.

Thermal PAD A 1mm

EK-FC970 GTX

TF5 Backplate

Thermal PAD D 0.5mm

EK-FC970 GTX TF5

PCB (backside)

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.0. Released on 9th of October, 2014.

STEP 4: ATTACHING EK-FC970 GTX TF5 BACKPLATE TO THE GRAPHICS CARD

Take enclosed mounting screws and install them as shown on picture below. Use four (4) M3x8 DIN7991 screws and mount them on the back

side of backplate. Two (2) screws M3x4 DIN7885 are mounted with plastic washers from the front side of the pcb.

HINT: Do not tighten screws until they are all positioned in their mounting holes. The backplate has milled in standoffs, so there is no fear of over

tightening of the screws. Nevertheless do not exaggerate with screwing force as there is no need for it.

By all means users must also consider that this product is intended to be used only with EK-FC970 GTX TF5 series water blocks. No other 3rd party

heat sinks or coolers are supported!

IMPORTANT DISCLOSURES

VERY IMPORTANT NOTICE: Once the installation is completed, it is a recommended practice to test the cooling circuit for leaks prior to powering up the

computer. We recommend a 24 hour leak test prior to powering up the computer. Do not test the water block using city water pressure. This will rupture the top

of the housing and render the block unusable (and will void your warranty).While all efforts have been made to provide the most comprehensive tutorial possible,

EK Water Blocks assumes no liability expressed or implied for any consequential damage(s) occurring to your equipment as a result of using EK Water Blocks

cooling products, either due to errors or omissions on our part in the above instructions, or due to failure or defect in the EK Water Blocks cooling products.

WARRANTY:

Our products are warranted against defects in materials or workmanship for a period of 24 months beginning from the date of delivery to the final user. During

this period, products will be repaired or have parts replaced at our discretion provided that: (I) the product is returned to the agent from whom it was purchased;

(II) the product has been purchased by an end user and has not used for commercial purposes; (III) the product has not been misused, handled carelessly, or

used in a manner other than in accordance with the instructions provided describing its installation and proper use. This warranty does not confer rights other

than those expressly set out above and does not cover any claims for consequential loss or damage. This warranty is offered as an extra benefit and does not

affect your statutory rights as a consumer. This warranty is voided if the product comes in contact with aggressive chemical, chemical agents or other improper

liquids or solids.

EK blocks are sealed with warranty void circular label, which proves that the block has withstood a pressure leak test. Removing it will void leak-free guarantee

and not the guarantee on the product itself. Any other RMA issues can be reported to EK Support at http://www.ekwb.com/support for further analysis.

REQUIRED TOOLS:

Philips head screwdriver scissors

M3x8 DIN 7985 screws

(4x)

M3x4 DIN 7985 screws

M3 plastic washer

M3 nut

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere ekwb Computerhardware Handbücher

ekwb

ekwb EK-FC1080 GTX Ti FTW3 Bedienungsanleitung

ekwb

ekwb EK-FC R9-290X Backplate Handbuch

ekwb

ekwb EK-FC 770 GTX DCII Handbuch

ekwb

ekwb EK-XTOP Revo D5 PWM Handbuch

ekwb

ekwb EK-Quantum Vector Trinity RTX 3080/3090 Bedienungsanleitung

ekwb

ekwb EK-FC R9-390X TF5 Series Handbuch

ekwb

ekwb EK-FC780 GTX Jetstream Handbuch

ekwb

ekwb EK-TIM Indigo Extreme Bedienungsanleitung

ekwb

ekwb ASUS Z9PE-D8 Bedienungsanleitung

ekwb

ekwb EK-FC580 GTX Leitfaden

ekwb

ekwb EK-Vector FTW3 RTX 2080 Ti Leitfaden

ekwb

ekwb EK-Classic GPU Water Block RTX 3080/3090... Bedienungsanleitung

ekwb

ekwb EK-Supreme HF Leitfaden

ekwb

ekwb EK-Nucleus AIO CR360 Vision D-RGB Bedienungsanleitung

ekwb

ekwb EK-FC460 GTX Handbuch

ekwb

ekwb EK-FC R9-290X Original CSQ Bedienungsanleitung

ekwb

ekwb EK-FB KIT ASUS R5-E10 Leitfaden

ekwb

ekwb EK-FC 780 GTX Ti DCII Handbuch

ekwb

ekwb EK-KIT HT Series Bedienungsanleitung

ekwb

ekwb EK-FC Bedienungsanleitung

ekwb

ekwb EK-FC750 GTX Series Bedienungsanleitung

ekwb

ekwb EK-FC 780 GTX Jetstream Bedienungsanleitung

ekwb

ekwb EK-Quantum Vector2 Trio RTX 3080/90 ABP Set... Bedienungsanleitung

ekwb

ekwb EK-SBAY DDC Series Leitfaden

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

Intel

Intel NUC 12 Pro Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung

Advantech

Advantech ASMB-935 Series Bedienungsanleitung

Jupiter

Jupiter RAM PACK Bedienungsanleitung

ekwb EK-FC970 GTX TF5 Handbuch

Beliebte Computerhardware Handbücher anderer Marken