Universale Quick User Guide Rev.1.10 ENG Delectrais an Elettrolab Group brand 3
1. Safety Information
1.1 Fire hazards prevention
Do NOT install the equipment onto flamable surfaces.
The minimum safety distance to keep from flamable surfaces and substances is 0,1m.
If not used with phase cut dimming input, this equipment must be powered from a breaker/differential-switch-protected
mains/power line.
1.2 Electric discharges prevention
HIGH VOLTAGE: remove power and await 1 minute before opening the equipment’s protective case/lid and before
operating on or inside the equipment.
Please make sure to follow all Safety Instructions included in this manual to correctly connect to mains and power up the
equipment
Universale is a highly sophisticated electronical equipment, only authorised and trained personnel should operate on it;
please make sure to forward any technical assistance or service related query, only to delectra authorised service centers.
Please ensure that the power cable does NOT come into contact with any other cable.
Please do NOT handle the equipment with wet or sweaty hands, or on and around liquids in general.
Please do NOT install the equipment outdoors in direct exposure to rain/water or in high-humidity environments.
1.3 General Safety Notices
Do NOT install the equipment in spaces without a constant circulating air flux.
Ambient temperature must NOT be higher than 40°C or lower than -20°C.
The equipment contains electrical and electronic components that must NOT get into contact with water, oil or any other
liquid substance in general otherwise safety and reliability of the equipment may be affected or compromised.
Never install the equipment in areas where condensation may occur.
1.4 Ingress Protection Grade
This appliance conforms to any ordinary equipment with Ingress Protection grade of: IP20
2. Warranty and Regulations
2.1 Normative Regulations
This equipment complies with all essential requirements as per CE Regulations (please review technical specifications at
chapter 3.1 or the product’s conformity declaration).
2.2 Warranty Conditions
The Equipment’s warranty is valid 36 months from purchase date and it covers manufacturing processes and material
related defects.
This Warranty waives the OEM from covering any fault/breakage that is due to negligence or misuse; either derived from
any non-compliant installation or any fault/breakage that result from an installation that is non-compliant with the
environment type and/or device usage restrictions - as explicitely and clearly set out throughout this user and installation
manual -. Furthermore, the OEM will not cover any fault/breakage due to the lack of trained personnel or the lack of service
maintenance as advised or as needed. (Please make sure to carefully read this manual and thoroughly follow all the
guidance set out in it).
This Warranty is void if the appliance is modified or opened by non authorised personnel and/or in case that any safety or
warranty seal appears broken or has been tampered with.
This Warranty does not include equipment substitution.
Serial Number and Equipment type/model-number are necessary when opening technical queries or whenever technical
assistence is sought from the OEM, the vendors or any reseller.
