ElectrIQ IQOOL-SMART15HP Bedienungsanleitung

USER MANUAL

electriQ WALL MOUNTED AIR CONDITIONER

WITH HEAT PUMP AND WIFI SMART APP

IQOOL-SMART12HP

IQOOL-SMART15HP

Thank you for choosing electriQ

Please read this user manual before using this innovative Air Conditioner and keep it safe for future

reference.

Visit our page www.electriQ.co.uk for our entire range of Intelligent Electricals

SAFETY INSTRUCTIONS

PRODUCT OVERVIEW

PRODUCT DIAGRAM

FEATURES

WHATS INCLUDED

INSTALLATION

TOOLS REQUIRED

INSTALLATION

ATTACHING THE BOTTOM COVER

OPERATION

CONTROL PANEL

REMOTE CONTROL

FUNCTIONS

WIFI SETUP AND SMART FEATURES

SETUP

CONTROLLING YOUR DEVICE THROUGH THE APP

SMART SCENES / AUTOMATION

TROUBLESHOOTING

ERROR CODES

TECHNICAL DATA

UK SUPPORT

IMPORTANT!

AIR CONDITIONERS MUST ALWAYS BE STORED AND TRANSPORTED

UPRIGHT, OTHERWISE IRREPARABLE DAMAGE MAY BE CAUSED TO

THE COMPRESSOR; IF IN DOUBT WE SUGGEST WAITING AT LEAST 24

HOURS FOLLOWING INSTALLTION BEFORE STARTING THE UNIT.

•Carefully read the instructions before installing and/or operating the unit

•This appliance is for indoor use only.

•This unit must be only connected to a 220-240 V / 50 Hz earthed outlet.

•Installation must be in accordance with regulations of the country where the unit is

used.

•If you are in any doubt about the suitability of your electrical supply have it checked

and, if necessary, modified by a qualified electrician.

•This air conditioner has been tested and is safe to use. However, as with any electrical

appliance - use it with care.

•Disconnect the power from the appliance before dismantling, assembling or cleaning.

•Avoid touching any moving parts of the appliance.

•Never insert fingers, pencils or any other objects though the guard.

•This appliance is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities. It is also not intended for use by those with a

lack of experience and knowledge, unless they have been given supervision or

instruction concerning the use of the appliance by a person responsible for their safety.

•Do not leave children unsupervised with this appliance.

•Do not clean the unit by spraying it or immersing it in water.

•Never connect the unit to an electrical outlet using an extension cord. If an outlet is not

available, one should be installed by a qualified electrician.

•Do not operate the unit unless it has been fully installed following the guidance

provided within this manual.

•Never operate this appliance if the cord or plug is damaged. Ensure the power cord is

not stretched or exposed to sharp objects/edges.

•A damaged supply cord should be replaced by the manufacturer or a qualified

electrician in order to avoid a hazard.

•Any service other than regular cleaning or filter replacement should be performed by an

authorised service representative. Failure to comply could result in a voided warranty.

•Do not use the appliance for any purpose other than its intended use.

•Avoid restarting the air conditioner unless 3 minutes have passed since being turned off.

This prevents damage to the compressor.

•Never use the mains plug as a switch to start and turn off the air conditioner. Use the

provided ON/OFF button located on the control panel.

•The appliance should not be installed in laundry or wet rooms.

•The appliance must be installed in a room without sources of ignition (for example: open

flames, an operating gas appliance or an operating electric heater).

•The unit must be installed on a solid vertical wall by a competent person. The electricity

supply must only be connected after installation is complete.

•R290 refrigerant gas complies with European environmental directives.

•R290 has a low GWP (Global Warming Potential) of 3.

•These air conditioners contains about 290 g of R290 refrigerant gas.

•Do not install or store in an unventilated space with an area smaller than 15m2per unit.

The room must be such as to prevent stagnation of possible leaks of refrigerant gas as

there could be a danger of fire or explosion hazard should the refrigerant come into

contact with electric heaters, stoves or other sources of ignition.

•If the appliance is installed, used or stored in an unventilated room, the room must be

such as to prevent stagnation of possible leaks of refrigerant gas as there could be a

danger of fire or explosion should the refrigerant come into contact with electric heaters,

stoves or other sources of ignition.

•Refrigerant gas may be odourless.

•Do not use the product and contact the retailer for advice, if damage has occurred to the

unit which may have compromised the refrigerant system.

•Any repairs or maintenance must only be carried out on the unit by a suitably qualified

engineer. Before opening and servicing the unit the authorized engineer must be in

possession of a copy of the manufacturer’s service manual and must follow the safety

information contained within it to ensure all hazards are minimized.

•The refrigerant system should not be perforated or punctured.

Energy Saving and Unit Safety Protection Tips

•Do not cover or restrict the airflow from the outlet or inlet grills.

•Keep the filters clean. Under normal conditions, filters should only need cleaning once

every three weeks (approximately). Since the filters remove airborne particles, more

frequent cleaning maybe necessary, depending on the air quality.

•For the initial start-up set the fan speed to maximum and the thermostat to 4-5 degrees

lower than the current temperature. After, set the fan switch to low and set the

thermostat to your desired setting.

•To protect the unit, we recommend not using the cool mode when the ambient

temperature is higher than 35oC.

NOTE: Some pictures and information may vary from the final product. This is due to

continual product improvement.

PRODUCT OVERVIEW

PRODUCT DIAGRAM

AIR INLET

LOUVRE

CONTROL PANEL

WALL HANGING MOUNTS

DRAINAGE PIPE

FRONT PANEL

BACK PANEL

FRONT

BACK

VENT

FEATURES

•Simple operation

•High and low installation options for added versatility

•Self-evaporative function with energy saving technology

•Sleek design that seamlessly fits into any style home

•Bright LED screen - Indicates temperature and current mode

•On/Off timer function - Allows you to choose when the unit operates

•WIFI App control providing additional functionality

•Three fan speeds

•Four modes to suit your every need including: Cooling/Heating/Fan/Dry.

•Silent running option, perfect for a restful night sleep

WHATS INCLUDED

AIR CONDITIONER

WALL TEMPLATE

SCREWS

WALL PLUGS

PLASTIC DUCTING

SHEET (X2)

REMOTE CONTROL

WIRED CONTROLLER AVAILABLE SEPERATELY FROM THE RETAILER UNDER REFERENCE:

IQOOLSMART12HP-WiredCtrl

WALL BRACKET

DIAGRAMS FOR ILLUSTRATIVE PURPOSES ONLY

VENT COVER ASSEMBLY (X2)

(CHAIN, INDOOR RING AND

OUTDOOR COVER

BRACKET AND

2 x SMALL SCREWS

BOTTOM COVER PLATE

INSTALLATION

TOOLS REQUIRED

SPIRIT LEVEL

TAPE MEASURE

DRILL

180 or 182mm CORE DRILL

8mm MASONRY DRILL BIT

PENCIL

BEFORE STARTING INSTALLATION, PLEASE ENSURE YOU HAVE ALL SUITABLE EQUIPMENT

AVAILABLE AND UNDERSTAND THE STEPS INVOLVED IN INSTALLATION. IF IN ANY DOUBT,

PROFESSIONAL ADVICE SHOULD BE SOUGHT.

THE INSTALLER MUST ENSURE THAT THE PLANNED POSITION OF THE AIR CONDITIONER IS

SUITABLE, AND THAT THERE ARE NO CABLES, PIPES OR OTHER OBSTRUCTIONS, WHICH

WOULD PRESENT A DANGER AND/OR PREVENT COMPLETION OF INSTALLATION.

25mm MASONRY DRILL BIT

SHARP KNIFE

INSTALLATION

This unit must be installed on an external wall, as it vents directly

out of its rear.

Only install the unit on a flat, solid and reliable wall. Ensure that

there are no cables, pipes, steel bars or other obstructions behind

the wall.

Leave at least 10 cm of space to the left and right of the machine.

At least 20cm of space must be left above the unit to help the air

flow smoothly.

Paste the supplied installation template paper in position on the

wall, ensuring that the reference line is level using a spirit level.

The hole for the drainage pipe must be drilled using a 25mm Drill bit.

Ensure the hole is at a downward angle (min 5 degrees) so that the water

will drain correctly

Use a 180 or 182mm core drill to drill the two holes for the units

ventillation, ensuring that both the holes are aligned with the

template.

Use the template to mark the position of the screws for the

hanging rail, using a spirit level to ensure it is straight and level.

Drill the marked holes using a suitable 8mm drill bit and insert

wall plugs. Line the hanging rail with the holes, and fix the rail

into position using the supplied screws.

Ensure that the hanging rail is securely fastened onto the wall,

and that there is no risk of the unit tipping or falling.

Roll the plastic vent sheets into a tube and

feed them from the inside into the holes

previously made. Ensure the tubes sit

flush to the interior wall.

Go outside and trim off the excess vent tube using a sharp knife,

keeping the edge as neat as possible.

Insert the indoor fixing ring from the

vent cover onto the indoor side of the

air vent. Then fold the external vent

cover in half. Attach the chains to each

side of the vent cover, before sliding

the cover outside through the vent

hole.

Expand the external cover, before tightly fixing the chains by

hooking onto the indoor fixing ring. This will hold the external

cover firmly in position. Repeat for the second vent.

Once the chains are fitted and secure, any excess chain should be

removed by cutting the chain.

We would also advise running a bead of exterior caulk or similar

around the external vent to help prevent water ingress.

Lift the unit onto the wall, align the hanging holes with the

hooks on the hanging rail and gently rest the unit into place.

At the same time, slide the drain pipe through the drainage

hole. If the wireless controller (Available separately) has

been purchased, it should then be installed, and connected.

NOTE: The end of the external water pipe must be placed in

an open space or drain. Avoid damage or constriction to the

drainage pipe to ensure the unit drains.

Place the bracket in position on the

under side of the unit and mark the

position of the screw hole on the wall.

Remove the bracket and drill a hole

using a 8mm drill bit before inserting a

wall plug.

Fix the bracket into position on the

underside of the unit using the 2 small

screws. Then attach the bracket to the

wall using a screw through the wall plug

previously inserted.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere ElectrIQ Klimaanlage Handbücher

ElectrIQ

ElectrIQ SILENT12-V2 Bedienungsanleitung

ElectrIQ

ElectrIQ P15C Bedienungsanleitung

ElectrIQ

ElectrIQ PLM12000HP Bedienungsanleitung

ElectrIQ

ElectrIQ iQool9 Bedienungsanleitung

ElectrIQ

ElectrIQ eiQ-12K12KC24KWMINV Betriebsanleitung

ElectrIQ

ElectrIQ P16HP Bedienungsanleitung

ElectrIQ

ElectrIQ PLAC12000HP Bedienungsanleitung

ElectrIQ

ElectrIQ SF12000 Bedienungsanleitung

ElectrIQ

ElectrIQ eiQ-9WMINV-V2 Betriebsanleitung

ElectrIQ

ElectrIQ P12HPW Bedienungsanleitung

ElectrIQ

ElectrIQ SILENT16-V2 Bedienungsanleitung

ElectrIQ

ElectrIQ P12HPW-V2 Bedienungsanleitung

ElectrIQ

ElectrIQ Compact V2 Bedienungsanleitung

ElectrIQ

ElectrIQ A1/CMAC10M Bedienungsanleitung

ElectrIQ

ElectrIQ P12C Bedienungsanleitung

ElectrIQ

ElectrIQ SILENT 12 Bedienungsanleitung

ElectrIQ

ElectrIQ AIRCUBE AC9000E Bedienungsanleitung

ElectrIQ

ElectrIQ AIRFLEX15 Bedienungsanleitung

ElectrIQ

ElectrIQ eIQ-9WMINV Betriebsanleitung

ElectrIQ

ElectrIQ Platinum Series Bedienungsanleitung

ElectrIQ

ElectrIQ SF8000E Bedienungsanleitung

ElectrIQ

ElectrIQ Arctic-Plus Bedienungsanleitung

ElectrIQ

ElectrIQ AIRCUBE Bedienungsanleitung

ElectrIQ

ElectrIQ CMAC12M Bedienungsanleitung

Beliebte Klimaanlage Handbücher anderer Marken

Panasonic

Panasonic CS-E12HKEW Bedienungsanleitung

nedis

nedis ACMB1WT7 Bedienungsanleitung

Daikin

Daikin FCFV50A Bedienungsanleitung

Fujitsu

Fujitsu Inverter ASBA30JFC Bedienungsanleitung

Toshiba

Toshiba RAS-M10SMUV-E Bedienungsanleitung

Daikin

Daikin FXLQ20MAVE Bedienungsanleitung

CIAT

CIAT Magister 2 Series Leitfaden

Bestron

Bestron AAC6000 Bedienungsanleitung

Frigidaire

Frigidaire FFRE0533S1E0 Bedienungsanleitung

Samsung

Samsung AS09HM3N Bedienungsanleitung

Frigidaire

Frigidaire CRA073PU11 Betriebsanleitung

Soleus Air

Soleus Air GB-PAC-08E4 Bedienungsanleitung

McQuay

McQuay MCK020A Bedienungsanleitung

Webasto

Webasto Frigo Top 25 DS Bedienungsanleitung

Frigidaire

Frigidaire FAZ12ES2A Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric MSC-GE20VB Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric PLA-M100EA Bedienungsanleitung

Daikin

Daikin Split Sensira R32 Bedienungsanleitung