Electro-Voice EVID S Series Bedienungsanleitung

EVID Surface Mount S Series ‑ X Models

EVID‑S5.2XB | EVID‑S5.2XW

Installation Manual

english

français

EVID Surface Mount S Series - X Models | 3

Electro-Voice Installation Manual 2022-03 | 07 | F.01U.345.358

english Table of contents 4

français Table des matières 23

4en | Table of contents EVID Surface Mount S Series - X Models

2022-03 | 07 | F.01U.345.358 Installation Manual Electro-Voice

Table of contents

1Safety 5

1.1 Suspension 5

1.2 Notices 5

2Introduction 6

2.1 System features 6

2.2 Product information 6

2.3 Packing list 7

3Installation and wiring 8

3.1 Installing the speaker 8

3.2 U-Bracket installation options 9

3.3 Recommended wire gauge 11

3.4 Wiring 11

3.5 Transformer taps 13

3.6 Replacing the logo 13

4Troubleshooting 15

5Technical data (for non-UL, general use installations) 16

5.1 Dimensions 17

5.2 Frequency response and impedance 17

6Technical data for UL1480 / ULC-S541, UL1480A / CSA C22.2 NO.205 installations 18

7Technical data for EN54-24, Type B installations 20

8U-Bracket dimensions 22

EVID Surface Mount S Series - X Models Safety | en 5

Electro-Voice Installation Manual 2022-03 | 07 | F.01U.345.358

1 Safety

1.1 Suspension

Warning!

Suspending any object is potentially dangerous and should only be attempted by individuals

who have a thorough knowledge of the techniques and regulations of suspending objects

overhead. Electro-Voice strongly recommends that loudspeakers be suspended taking into

account all current national, federal, state, and local laws and regulations. It is the

responsibility of the installer to ensure all loudspeakers are safely installed in accordance

with all such requirements. When loudspeakers are suspended, Electro-Voice strongly

recommends the system be inspected at least once per year or as laws and regulations

require. If any sign of weakness or damage is detected, remedial action should be taken

immediately. The user is responsible for making sure the wall, ceiling, or structure is capable

of supporting all objects suspended overhead. Any hardware used to suspend a loudspeaker

not associated with Electro-Voice is the responsibility of others.

Safety point

As an added safety measure, it is suggested the user install an extra suspension point back to

the building structural supports. This safety point should have as little slack as possible (less

than 1-inch is preferable).

Figure1.1: Redundant safety point

1.2 Notices

Old electrical and electronic equipment

This product and/or battery must be disposed of separately from household waste.

Dispose such equipment according to local laws and regulations, to allow their reuse

and/or recycling. This will help in conserving resources, and in protecting human

health and the environment.

any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior

written permission of the publisher. For information on getting permission for reprints and

excerpts, contact Electro-Voice.

All content including specifications, data, and illustrations in this manual are subject to change

without prior notice.

6en | Introduction EVID Surface Mount S Series - X Models

2022-03 | 07 | F.01U.345.358 Installation Manual Electro-Voice

2 Introduction

The EVID-S series, from Electro-Voice, is a line of compact, high-performance, two-way, full-

range surface mount speakers, with excellent wide and uniform coverage, and outstanding

performance. Their design makes these practically invisible for use in background and

foreground music, paging, and sound reinforcement applications, making EVID-S ideal for

indoor and outdoor applications, such as restaurants, bars, patios, retail, fitness clubs,

hospitality, theme parks, leisure venues, and others. With unparalleled ease-of-installation,

sturdy weather resistance, modern and delicate look, and flexible mounting options, the EVID-

S series is the perfect solution for a wide variety of surface mount applications.

The EVID-S5.2X models are IP65 rated, designed to withstand the toughest weather

conditions. They are also UL1480 / ULC-S541, UL1480A / CSA C22.2 NO. 205 / EN54-24, type

B certified.

Read through this manual to familiarize yourself with the safety information, features, and

applications before you use these products.

2.1 System features

– Carefully engineered for the toughest weather conditions (IP65)

– Long throw 5.25" (133 mm) woofer housed in a UL 94-5VB fire rated ABS plastic for

extended LF performance down to 55 Hz

– 75 W power handling provides for 108 dB maximum SPL (114 dB Peak)

– 60 W transformer with 8 Ω pass-through

2.2 Product information

Item Description

A Grille

B Safety cable loop

C Weather input cover

D Gland nut

E U-Bracket

Table2.1: Product information

Figure2.1: Product information

EVID Surface Mount S Series - X Models Introduction | en 7

Electro-Voice Installation Manual 2022-03 | 07 | F.01U.345.358

2.3 Packing list

Item Quantity Component

A 2 Speakers

B 1 Allen wrench

C 4 Safety screws for the U-Brackets

D 2 U-bracket

E 2 Weather covers

F 8 Weather cover screws

G 2 Grille logos (spares)

H 1 Installation manual

Table2.2: Components list

A (x2) BD (x2)

C (x4)

E (x2) F (x8)G (x2) H

Figure2.2: Components list

8en | Installation and wiring EVID Surface Mount S Series - X Models

2022-03 | 07 | F.01U.345.358 Installation Manual Electro-Voice

3 Installation and wiring

3.1 Installing the speaker

For safety, ensure the mounting surface supports more than the weight of the speaker. Use

only industry-accepted fasteners and mounting methods when mounting the U-Bracket.

Consult an expert if you are unsure.

Warning!

Use a support system which has sufficient wind load strength to comply with the applicable

codes and standards.

Disregarding this warning could result in damage to the product and major injury or possibly

death may occur.

Caution!

It is the installer's responsibility to determine and use the proper mounting hardware for the

wall construction type.

Disregarding this caution could result in damage to the product and personal injuries may

occur.

Notice!

Connections shall not be made with rigid conduit but with flexible conduit or wiring only.

Installing the U-Bracket

To install the U-bracket, do the following:

1. Draw a level line.

2. Align screw holes on the level line.

3. Install two mounting screws to secure the U-Bracket to the wall.

Installing the speaker

To install the speaker, do the following:

1. Wire the speaker, as shown in the wiring section.

EVID Surface Mount S Series - X Models Installation and wiring | en 9

Electro-Voice Installation Manual 2022-03 | 07 | F.01U.345.358

2. Insert the two screws (provided) into the U-Bracket mounting points.

Loosely tighten the two screws using the Allen wrench (provided).

3. Aim the speaker.

4. Tighten the two screws to secure the U-Bracket to the speaker.

Ensure the speaker is secured to the U-Bracket.

Safety point

As an added safety measure, it is suggested the user install an extra suspension point back to

the building structural supports. This safety point should have as little slack as possible (less

than 1-inch is preferable).

Figure3.1: Redundant safety point

Refer to

– U-Bracket installation options, page 9

– Wiring, page 11

3.2 U-Bracket installation options

Using a U-Bolt

The U-Bracket can be mounted using a standard 2-inch or 4-inch U-Bolt.

10 en | Installation and wiring EVID Surface Mount S Series - X Models

2022-03 | 07 | F.01U.345.358 Installation Manual Electro-Voice

Figure3.2: U-Bolt — 2-inch

Figure3.3: U-Bolt — 4-inch

Using a threaded rod

The U-Bracket can be installed to a threaded rod.

Figure3.4: Threaded rod

Using a pole mount

The U-Bracket can be installed to a pole mount using steel band clamps.

Figure3.5: Pole mount

Using a junction box

The U-Bracket can be installed to a junction box using a 0.25” rubber grommet (not included)

for wiring.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Electro-Voice Sprecher Handbücher

Electro-Voice

Electro-Voice Xw12A Bedienungsanleitung

Electro-Voice

Electro-Voice EVID Series Bedienungsanleitung

Electro-Voice

Electro-Voice Plasma Series Bedienungsanleitung

Electro-Voice

Electro-Voice EVX-150A Bedienungsanleitung

Electro-Voice

Electro-Voice X-Array Xw12 Bedienungsanleitung

Electro-Voice

Electro-Voice EKX-12P Bedienungsanleitung

Electro-Voice

Electro-Voice SRO/18 Dimensionsleitfaden

Electro-Voice

Electro-Voice Xi Series Xi-1152A/94F Handbuch

Electro-Voice

Electro-Voice Zx1i-100 Bedienungsanleitung

Electro-Voice

Electro-Voice EVF-1122D Bedienungsanleitung

Electro-Voice

Electro-Voice TL15-1 Montageanleitung

Electro-Voice

Electro-Voice X-Array XF Bedienungsanleitung

Electro-Voice

Electro-Voice ELX200-10P-US Bedienungsanleitung

Electro-Voice

Electro-Voice CFID32-8 Bedienungsanleitung

Electro-Voice

Electro-Voice Loudspeaker Xi-Series Bedienungsanleitung

Electro-Voice

Electro-Voice ETX-35P Bedienungsanleitung

Electro-Voice

Electro-Voice Musicaster II Dimensionsleitfaden

Electro-Voice

Electro-Voice Michigan MC12A Bedienungsanleitung

Electro-Voice

Electro-Voice EVOLVE Bedienungsanleitung

Electro-Voice

Electro-Voice ZLX-12P-AX Bedienungsanleitung

Electro-Voice

Electro-Voice EVERSE 8 Bedienungsanleitung

Electro-Voice

Electro-Voice TX1152FM Bedienungsanleitung

Electro-Voice

Electro-Voice 10BX Bedienungsanleitung

Electro-Voice

Electro-Voice EVX-180A Bedienungsanleitung

Beliebte Sprecher Handbücher anderer Marken

argon audio

argon audio IE20 Bedienungsanleitung

Denon

Denon SC-N7 Bedienungsanleitung

Gemline

Gemline Ace 3952 Bedienungsanleitung

Focal

Focal ON WALL 300 Bedienungsanleitung

HEADRUSH

HEADRUSH Maximus HRSP 5024 Bedienungsanleitung

SoundLogic

SoundLogic BCCS-6/6395 Bedienungsanleitung

Peavey

Peavey DTH 218 Bedienungsanleitung

Avantree

Avantree Pluto Air Bedienungsanleitung

Morel

Morel Integra Series INTEGRA OVATION 4 Bedienungsanleitung

Oppo

Oppo SONICA Bedienungsanleitung

Bose

Bose SoundLink Wireless Music System Bedienungsanleitung

Rocksteady

Rocksteady Stadium Bedienungsanleitung

Bowers & Wilkins

Bowers & Wilkins 4 Bedienungsanleitung

Sonance

Sonance SONOS OUTDOOR Series Bedienungsanleitung

Pioneer

Pioneer XW-HTD630 Bedienungsanleitung

Onn

Onn BWA16AA002 Bedienungsanleitung

HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung

Tannoy

Tannoy SYSTEM 600a Bedienungsanleitung