Electrovaya Scribbler SC-4000 Bedienungsanleitung

SC 4000 Series

2008.02.20

Trademarks

All brand and products names are trademarks or registered trademarks of their respective

companies. For this manual is subject to change without notice

Preface

The information in this document is subject to change

without prior notice in order to improve reliability, design

and function and does not represent a commitment on

the part of the manufacturer.

In no event will the manufacturer be liable for direct,

indirect, special, incidental, or consequential damages

arising out of the use or inability to use the product or

documentation, even if advised of the possibility of such

damages.

This document contains proprietary information protected

by copyright. All rights are reserved. No part of this

manual may be reproduced by any mechanical,

electronic, or other means in any form without prior

written permission of the manufacturer.

Safety Notices

(1) Please read these safety instructions carefully.

(2) All precautions and warnings on the equipment should

be carefully noted.

(3) Please disconnect the computer from the AC outlet

before cleaning.

(4) Never pour any liquids into any openings or directly

onto the computer unit. This could result in fire or

electrical shock.

(5) Ensure the voltage range of the power outlet is between

100V and 240V before connecting the computer unit.

Exceeding the maximum rated voltage may cause

damage to the AC adapter or to the computer. This

could result in fire or electrical shock.

(6) Do not leave this equipment in a non-temperature

controlled environment; storage temperatures below

4°C (39°F) or above 35°C (95°F) may damage the unit.

To reduce the risk of an

electric shock, which could cause personal injury, please

follow all safety notices. The symbols shown are used in

your documentation and on your equipment to indicate

safety hazards.

Lithium batteries can be

dangerous. Danger of explosion if battery is incorrectly

replaced. Replace only with the same or equivalent type

recommended by the manufacturer. Dispose of used

batteries according to the manufacturer’s instructions.

Under no circumstances

should the user attempt to disassemble the power supply.

The power supply has no user-replaceable parts. Inside

the power supply are hazardous voltages that can cause

serious personal injury. A defective power supply must be

returned to your dealer.

Safety Notices for the Power Cord

This equipment has a 2 or 3-wire power cord. Replace

the power cord if it becomes damaged. Contact your

dealer for an exact replacement.

In the U.S.A. and Canada, the power cord must be a UL-

listed detachable power cord (in Canada, CSA-certified).

2-wire cord SPT-2 18AWG

3-wire cord SVT or SJT, 18 AWG, 3-conductor

Provided with a molded-on cord connector body at the

other end. The cord length must not exceed 3 meters.

iii

Outside the U.S.A. and Canada, the plug must be rated

for 250 VAC, 2.5 amp minimum, and must display an

international agency approval marking. The cord must be

suitable for use in the end-user’s country.

Consult your dealer or the local electrical authorities if

you are unsure of the type of power cord to use in your

country. Voltage changes occur automatically in the

power supply.

Notice of EMC Compliance

This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful

interference in a residential installation.

This equipment generates, uses, and can radiate radio

frequency energy and if not installed and used in

accordance with the instruction manual may cause

harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause

harmful interference to radio or television reception,

which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and

receiver.

Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

Consult the dealer or an experienced technician for

help.

Use only shielded I/O cables to connect I/O devices to

this equipment. You are cautioned the changes or

modifications not expressly approved by the party

responsible for compliance could void your authority to

use the equipment. This device complies with Part 15 of

the FCC Rules.

Operation is subject to the following two conditions: (1)

this device will not cause harmful interference, and (2)

this device must accept any interference it receive

including interference that may cause undesired

operation.

This device and its antenna(s) must not be co-located or

operating in conjunction with any other antenna or

transmitter.

FCC Radiation Exposure Statement

This Transmitter has been demonstrated co-location

compliance requirements with (Bluetooth/Model

No:BTA3130EDR). This transmitter must not be co-

located or operating in conjunction with any other

antenna or transmitter.

(1) This equipment complies with FCC RF radiation

exposure limits set forth for an uncontrolled

environment. To maintain compliance with FCC RF

exposure compliance requirements, avoid direct contact

to the transmitting antenna during transmitting.

(2) Any changes or modifications (including the antennas)

made to this device that are not expressly approved by

the manufacturer may void the user’s authority to

operate the equipment.

Canadian EMI Compliance Statement

This Class B digital apparatus meets all requirements of

the Canadian Interference - Causing Equipment

Regulations.

European Union CE Marking Declaration

This product has been tested and found to comply with

the EMC requirement subject to the EU directive for CE

marking.

CE Declaration of Conformity

For the following equipment: Tablet PC

0984

Is herewith confirmed to comply with the requirements

set out in the Council Directive on the Approximation of

the Laws of the Member States relating to

Electromagnetic Compatibility (89/336/EEC), Low-voltage

Directive (73/23/EEC) and the Amendment Directive

(93/68/EEC), the procedures given in European Council

Directive 99/5/EC and 89/3360EEC.

The equipment was passed. The test was performed

according to the following European standards:

EN 300 328 V.1.6.1 (2004)

EN 301 489-1 V.1.4.1 (2002) / EN 301 489-17

V.1.2.1 (2002)

EN 50371: 2002

EN 60950-1: 2001

(

)

European standards dictate maximum radiated transmit

power of 100mW EIRP and frequency range 2.400-

2.4835GHz; In France, the equipment must be restricted

to the 2.4465-2.4835GHz frequency range and must be

restricted to indoor use.

Inside the buildings with a power (WORSE *)

maximum of 100 MW on all the frequency band

2400-2483,5 MHz,

Outside the buildings with a power (WORSE *)

maximum of 100 MW on the part 2400-2454MHz

and with a power (WORSE *) maximum of 10 MW

on the part 2454-2483MHz

vii

Table of Content

CHAPTER 1: BEFORE YOU START ...........................................................1

WHAT TO DO BEFORE YOU WORK ON YOUR COMPUTER........................1

CHAPTER 2: INTRODUCTION ....................................................................3

INTRODUCING YOUR COMPUTER...........................................................3

GETTING TO KNOW YOUR COMPUTER ..................................................4

CHAPTER 3: GETTING STARTED ............................................................11

SETTING UP THE COMPUTER .............................................................11

INSERTING AND REMOVING THE BATTERY PACK..................................11

CONNECTING THE COMPUTER TO AN EXTERNAL POWER SOURCE........13

USING THE STAND.............................................................................15

CHAPTER 4: USING THE COMPUTER ......................................................17

ADJUSTING THE SCREEN DISPLAY......................................................17

THE BATTERY POWER SYSTEM .........................................................19

AUTOMATIC BATTERY PACK CHARGING FUNCTION..............................20

USING THE MOBILITY CENTER............................................................21

PEN CALIBRATION .............................................................................23

CHAPTER 5: USING THE DOCKING STATION (OPTIONAL).......................27

FRONT VIEW .....................................................................................27

REAR VIEW.......................................................................................28

SIDE VIEW ........................................................................................29

CONNECTING THE TABLET PC TO THE DOCKING STATION....................30

CHAPTER 6: UPGRADING YOUR SYSTEM ...............................................31

UPGRADING THE SYSTEM MEMORY....................................................31

UPGRADING THE WIRELESS MODULE .................................................32

UPGRADING YOUR HARD DISK DRIVE.................................................33

CHAPTER 7: TRUSTED PLATFORM MODULE ...........................................35

BEFORE YOU START..........................................................................35

EFS (ENCRYPT FILE SYSTEM)...........................................................39

PERSONAL SECURE DRIVE ................................................................41

TPM RECOVERY...............................................................................42

CHAPTER 8: FINGER PRINT ...................................................................49

BEFORE YOU START..........................................................................49

viii

CHAPTER 9: TROUBLESHOOTING...........................................................57

GENERAL HARDWARE PROBLEMS /POSSIBLE CAUSE AND SOLUTION ..57

APPENDIX A: SPECIFICATION ................................................................63

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Electrovaya Tablette Handbücher

Electrovaya

Electrovaya Scribbler SC300 Bedienungsanleitung

Electrovaya

Electrovaya Scribbler SC300 Bedienungsanleitung

Beliebte Tablette Handbücher anderer Marken

Laser

Laser MID-1060 Benutzerhandbuch

MUNBYN

MUNBYN IRT09J Kurzanleitung

Motorola

Motorola MC3090R - Win CE 5.0 Professional 520 MHz Bedienungsanleitung

Dell

Dell Latitude ST Betriebsanleitung

Lenovo

Lenovo IdeaTab S6000L Betriebsanleitung

Venturer

Venturer WT9L11 Bedienungsanleitung

EDUGEAR

EDUGEAR UnoBook Bedienungsanleitung

Philips

Philips PI3210G/58 Bedienungsanleitung

ADLINK Technology

ADLINK Technology IMT-BT Bedienungsanleitung

TwinMOS

TwinMOS TwinTAB-T102D1 Bedienungsanleitung

Archos

Archos 9.7 xenon Bedienungsanleitung

Getac

Getac E100 Bedienungsanleitung

HANNspree

HANNspree HANNspad SN70T3 Bedienungsanleitung

Philips

Philips PI3105W2/55 Bedienungsanleitung

LG LG-V935 Bedienungsanleitung

Zeki

Zeki TBDB763B Bedienungsanleitung

Ricoh

Ricoh eQuill Bedienungsanleitung

DT Research

DT Research DT365CT Montageanleitung