3. General Guidelines.
ElektraLite eyeBall IP65 is a lighting fixture for professional use.
ElektraLite eyeBall IP65 should only be operated at between 120 to 240 volts.
ElektraLite eyeBall IP65 should not be operated 24/7 (24 hours a day; 7 days a week).
ElektraLite eyeBall IP65 needs operation breaks to ensure that it will work for a long time without
problems. Please do not shake the eyeBall IP65 and avoid using brute force when installing or
operating it.
When choosing the location to install the eyeBall IP65, please make sure that it is not exposed to
extreme heat. Make sure that the fixture has a good amount of free space around it for air flow. Do
not install it in a confined space or have insulation around the fixture. The minimum distance
between the eyeBall IP65 and the illuminated surface must be more than 3 feet.
Always mount the eyeBall IP65 with an appropriate safety cable.
Operate the eyeBall IP65 only when you are familiar with the features on the fixture. Do not permit
operation by persons not qualified.
All modifications to the eyeBall IP65 will invalidate the warranty. There are absolutely no
exceptions.
If eyeBall IP65 is operated in any way different to the one described in this manual, eyeBall IP65
maybe damaged and the guarantee will be void.
4. Installation
Please ensure that the eyeBall IP65 is hung using the appropriate "C" clamp or half cheeseboro.
A safety chain or cable should also be used as a secondary point of holding the fixture in case the
clamp comes loose. Never hang the fixture without a safety chain or cable.
If you are not qualified or have any doubts about hanging the eyeBall IP65 then do NOT hang it.
Do not clamp the cable to the U bracket or clamp. That is not a secondary safety point.
A secondary safety point is any point that will adequately hold the eyeBall IP65 if the "C" clamp or
half cheesboro fails. Then the safety cable would be the backup and stop the fixture from falling to
the ground. So do NOT fix the safety to the same place that the "C" clamp is attached.
The eyeBall IP65 is kept cool by conducting the heat away from the leds using the body's fin design.
As a result the fins and the surrounding area should be "open" all around the fixture. Do not block
the fixture into a tight location. For example,Do not try to mount the eyeBall IP65 like a "high hat" in
a soffit surrounded by insulation; the fixture would fail to operate due to overheating.
5. DMX-512 Control Connection and Power Connection
POWER:
The eyeBall IP65 comes with an Edison 120V connector to an outdoor water resistant connector
cable. Extension cables (water resistant connector to water resistant connector) are available as
accessories.
DMX 512 CONTROL:
The eyeBall IP65 come with a 5 pin XLR connector to an outdoor water resistant 3 pin connector
cable.
Extension cables (water resistant connector to water resistant connector) are available as
accessories.
