Methods of pasting the film:
1.Spray some water on the place that the film will be pasted on,and then use a dry
cloth to clean it;
2. Take off the back side（marked 1) of reflection film,then paste it to the window
glass.
3. After you have adjusted the location, you can use a scratch board or something
else flat to slick the film and squeeze the water inside out until there is no bubble or
water in it.
4. Take off the protection film (marked 2) of the reflection film. If the film cannot
display the whole information, please adjust the non-slip mat to move the position.
Troubleshooting
1.The screen without any display,and no power.
Start the car engine;check if the OBD cable line is tight; pull down the OBD cables
more times to ensure;check if HUD power switch turns on. If no display still,please
change another car to test, analyze whether the car OBD diagnostic interface is good,
if it is not good,please repair it and try again.
2.When HUD power on, HUD only shows the car voltage and be automatic power
off after 30 seconds driving.
HUD just available for cars with OBD2 agreement and EU-OBD agreement（European
region: after 03 years, Other region:after 07 years）
HUD Products donnot support JOBD and OBDI and recommended test for another
car.
3.Display not clear under sunlight or has double image
First check whether the HUD host surface protective film is torn,and please stick the
reflection film on the windscreen.
Second, when HUD is power on ,vertical press in the setting button for 5 seconds to
enter into menu,short press 5 times to menu 6,adjust the default value to 7,vertical
press in 5 seconds to save.
4.Inaccurate Speed
a.First check the speed unit is correct or not, the speed unit including KM/H and
MPH, set it at the correct one(refer to menu 8)
b.When HUD is power on,vertical press the setting button for 5 seconds to enter into
the menu setting,and short press in 3 times to menu 4, and the parameter shows
