Elmo CRA-2 Bedienungsanleitung
User's Guide
ELMO Wireless Pen Tablet (CRA-2)
Read this User's Guide carefully before using the CRA-2.
Store this User's Guide in a safe place in case you need it again.
2
IMPORTANT SAFETY INSTRUCTIONS
1) Read these instructions.
2) eep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings,
Install in accordance with the
manufacturer’s instructions.
8) Do not install near any heat sources
such as radiators, heat registers, stoves,
or other apparatus (including amplifiers)
that produce heat.
9) Do not defeat the safety purpose of the
polarized or grounding-type plug. A
polarized plug has two blades with one
wider than the other. A grounding type
plug has two blades and a third grounding
prong. The wide blade or the third prong
are provided for your safety.
If the provided plug does not fit into your
outlet, consult an electrician for
replacement of the obsolete outlet.
10) Protect the power cord from being
walked on or pinched particularly at
plugs, convenience receptacles, and the
point where they exit from the apparatus.
11) Only use attachments/accessories
specified by the manufacturer.
12) Use only with the cart, stand, tripod,
bracket, or table
specified by the
manufacturer, or sold
with the apparatus.
When a cart is used,
use caution when moving the
cart/apparatus combination to avoid injury
from tip-over.
13) Unplug this apparatus during lighting
storms or when unused for long periods
of time.
14) Refer all servicing to qualified service
personnel. Servicing is required when the
apparatus has been damaged in any way,
such as power-supply cord or plug is
damaged, liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or
moisture, does not operate normally, or
has been dropped.
The lightning flash with arrowhead symbol,
within an equilateral triangle, is intended to alert
the user to the presence of uninsulated
"dangerous voltage" within the product's
enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.
This marking is located at the bottom of
product.
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the product.
3
WARNIN :
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
PRODUCT TO RAIN OR MOISTURE.
WARNIN :
Handling the cord on this product or cords associated with accessories sold with this product, will expose you to
lead, a chemical known to the State of California to cause birth defects or other reproductive harm. Wash hands
after handling.
NOTICE:
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications made to this equipment not expressly approved by (manufacturer name) may
void the FCC authorization to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
4
Usage Precautions
■
■■
■ About electric waves used by the tablet
This product uses electric waves in the 2.4 GHz band. When using the product, a radio
station license is not necessary. However, please note the following precautions.
Do not use the product near the followings:
・Microwave ovens/industrial, scientific or medical equipment, such as pacemakers
・In-factory radio stations for mobile unit identification systems (radio stations that
require a license) used in production lines of factories
・Specified low power radio stations (radio stations that do not require a license)
・IEEE802.11g/b wireless LAN units
When the Tablet is used near any of the equipment mentioned above, electric wave
interference may occur, making the Tablet difficult to use.
■
■■
■ About wireless equipment used in the 2.4 Hz band
This frequency bandwidth is the same as for industrial, scientific, and medical
equipment such as microwave ovens, mobile unit identification systems (radio stations
that require a license) used in factory production lines, and specified low-power radio
stations (radio stations that do not require a license).
・Before using the product, check that there are no radio stations for mobile unit
identification systems or specified low-power radio stations nearby.
・If the product emits electric waves which interfere with in-factory radio stations for
mobile unit identification systems, cease use immediately and stop generating the
electric waves. For information on countermeasures, etc. (for example, erecting
partitions), contact one of our sales departments whose details are provided at the
end of this manual.
・If the product emits electric waves which interfere with specified low-power radio
stations used for mobile unit identification systems, or causes similar problems,
contact one of our sales departments whose details are provided at the end of this
manual.
■
■■
■ About the operating environment and storage
・This product is for indoor use only. It cannot be used outdoors.
・Do not place the product in a damp or dusty location, in a location exposed to the sea
breeze, or in an area exposed to high vibration.
The operating environment conditions are as follows.
Temperature: 0 to 40°C
Humidity: 20 to 90% (no condensation)
・Do not store in a location exposed to direct sunlight or near to heating equipment.
Discoloration, deformation or malfunctions could result.
5
■
■■
■ Cleaning
When cleaning the product, remove the connected USB cable and perform in a location
that is not subject to humidity or moisture.
・Remove any dirt from the product with a soft, dry cloth.
・To remove stubborn dirt, dilute some detergent in water, dip a soft cloth in the water,
and then wring it out before using it to wipe away the dirt. Do not use any volatile
solvents such as thinner or benzene.
■
■■
■ About the battery
The built-in lithium-ion battery has a limited life. Even within the warranty period, battery
capacity will gradually decrease over time, number of uses, usage time, and temperature.
If the time that can be used at room temperature (10 to 30 ° C) is significantly shortened,
it is considered to be the end of life.
Disposal of the battery
The rechargeable lithium-ion battery is used for the product. It can be recycled but cannot
be removed by the user. Contact the dealer from whom you purchased the product for
information about how to remove the battery.
6
Table of Contents
Before Use ........................................................................................................................ 7
Main functions ................................................................................................................ 8
Supplied items ................................................................................................................ 9
Part names ....................................................................................................................10
Preparations .................................................................................................................. 11
Charging .............................................................................................................................. 11
Installing the touchscreen electronic blackboard software “ELMO Interactive Toolbox (EIT)”
............... 12
Basic tablet operations ..................................................................................................13
Basic pen operations .......................................................................................................... 13
Basic screen layout of EIT ................................................................................................. 14
How to Use .......................................................................................................................15
1. Setting up the devices (Document camera, Computer, Projector, etc.) ....................... 15
2. Turning on the tablet ..................................................................................................... 16
3. Operating the tablet ....................................................................................................... 17
Other Functions ...............................................................................................................19
Replacing the pen tip .....................................................................................................19
Storing the pen and wireless dongle ..............................................................................19
About the Status LED ....................................................................................................20
Troubleshooting ..............................................................................................................21
Product Specifications ....................................................................................................23
Product specifications ....................................................................................................23
Disclaimer ......................................................................................................................24
About trademarks ..........................................................................................................24
7
Before Use
Thank you very much for purchasing CRA-2.
Please read this manual carefully to make suitable use of the product. Also, please be
sure to refer to any supplemental information included with this product.
Caution
・ The screen images and drawings in this manual may be different from actual
ones.
8
Main functions
■ Enhance your lessons
By wirelessly connecting the tablet to a computer after installing the application software
supplied with the tablet, you can make your lessons more effective and attractive using
the tablet.（⇒P.12）
■ Use with document camera and IWB
By connecting to the separately sold Elmo document camera (L-12iD / TT-12iD / L-12F /
TT-12F / L-12W / TT-12W / MA-1 / MO-2 ), you can use the tablet without a computer.
※Depending on the model of the document camera used, some functions may not be
available.
※Drawing on the tablet and the CRB-2 (IWB) cannot be performed at the same time.
9
Supplied items
The following items are supplied with the product. Contact your dealer if any of the
following items are not included in the package you purchased.
Tablet
USB cable
（for charging／for operation
）
Pen
Wireless dongle Extra core ×8
（※Stored inside the pen holder
）
Quick Start Guide &
IMPORTANT SAFEGUARDS
Pen holder
10
Part names
Status LED
To i
ndicate the operational status and battery
level.〈About the Status LED (⇒P.20)〉
Shortcut keys
To select the tablet operations.
〈Selecting the mode (⇒P.18)〉
Pen storage
To store the pen.
Tablet
:
Front view
Rear view
Pen
Button
USB port
To connect to a computer to charge the tablet.
〈
Charging
(⇒
P.11
)
〉
Operating area
Side view
Wireless switch
To switch between “enable wifi” and “disable
wifi” when using the wireless dongle with a
computer or the document camera.
Set this switch to ON when using wifi.
〈Turning on the tablet (⇒
P.16
)〉
Wireless dongle storage
To store the wireless dongle.
〈Storing the pen and wireless dongle (⇒
P.19
)〉
Pen tip
Andere Handbücher für CRA-2
2
Inhaltsverzeichnis
Andere Elmo Tablette Handbücher
