Before First Use
Remove any packaging and promotional
material from the EmberCeptor PC™
device.
Setting Up the
EmberCeptor PC™
To maximise your energy saving,
please ensure your computer’s power
management settings are active so
the computer enters sleep, standby
or hibernate modes. Normally this
function is found in a menu in a PC,
called ‘Power Options’.
In an iMac, ‘Energy Saver’ is used to
tell the computer when to go to sleep.
Other option is to send your Mac to
sleep, close the lid on your portable Mac
or press the on/o button once on your
desktop Mac.
Connect your computer power plug
into the socket marked ‘Computer Only’.
NOTE: Only one computer is to
be connected to the ‘Computer
Only’ socket.
Identify the equipment that is used with
the computer, such as monitors, printers,
speakers, external hard drives and lamps,
and plug them into the socket marked
‘Power Saver’.
NOTE: Where there is more than
one device that needs to be
connected, any power board,
powerstrip, trailing socket or surge
board may be connected to the
‘Power Saver’ socket.
Using Your EmberCeptor PC™
NOTE: Devices that are connected
to the ‘Power Saver’ socket will be
automatically switched o during
the computer’s power saving cycle.
Connect the equipment that needs to
remain turned on, such as the internet
modem / router, fax machine, to another
free socket on the wall outlet.
Plug the EmberCeptor PC™ into a
220V-230V wall socket in Europe, or into
a 120V wall socket in US, and turn the
power point on at the wall (if the wall
outlet has a switch).
NOTE: Only equipment connected
to the EmberCeptor PC™ will be
protected against surge.
NOTE: If the power management
settings are not active on the
computer, the peripherals
connected to the EmberCeptor PC™
‘Power Saver’ socket will only be
turned o when the computer is
manually shut down.
