the installation location is contaminated, the machine must be operated in a separate
closed test cell.
The machine may only be operated by persons who have been properly trained in the
operation, maintenance and repair of the machine, and are aware of the risks involved.
All accident prevention and safety instructions for operating the machine must be
observed. The manufacturer does not accept any liability in cases where the machine is
used for purposes other than those for which it is intended. In these cases, liability is
transferred to the user.
The machine is adjusted for the ambient temperature specified in the technical data.
The machine must not be used to test workpieces with low mechanical stability, which
may become distorted or may break when clamped.
Workpieces that are stable but do not have the required structural integrity may only be
clamped if they are secured using appropriate fixings.
The machine should not be used for workpieces which are toxic or harmful to health.
The CE mark and the EC conformity declaration certify that the machine and this
manual comply with the stipulations of the directives that apply to the product.
The WEEE symbol on your unit indicates that it is a WEEE-relevant machine
containing electrical/electronic components and must not be disposed of as general
waste. For more information about recycling this product, contact your relevant local
authority.
The warranty period for new machines is 24 months from the date of delivery by the
manufacturer with unlimited operating hours.
If a defect is detected, inform your sales partner or nearest service center of the
manufacturer immediately, providing a detailed description of the defect in written form,
over the phone or in person.
Defects that are properly reported and are covered by the manufacturer's warranty will
be corrected free of charge either by repair or replacement delivery. If requested,
defective parts are to be returned to the manufacturer at the customer's expense and
risk.
The manufacturer's warranty does not apply to defects that are caused by one or more
of the following:
▪ failure to fully comply with the operating instructions, safety and licensing
regulations or other instructions relating to the delivery, installation, startup or use of
the machine
▪ incorrect assembly or startup of the machine
▪ unauthorized, unapproved interference with or modifications to the machine by the
customer or a third party
▪ improper or inappropriate use of the machine for purposes other than those for
which it is intended
▪ normal wear and tear
▪ negligent or incorrect handling
▪ chemical, electrochemical or electrical exposure
▪ an insufficient or incorrect power supply
▪ force majeure
The cost of services not covered by warranty are to be borne by the customer.
