EMG EXB Service-Handbuch

0.025 LOG FREQ (kHz) 10

Dimensions:

.800

1.050

SPECIFICATIONS

Input Impedance (Ohms) 250K

Input Referred Noise -130dbV

Output Impedance (Ohms) 2K

Current @ 9V (Microamps) 750

Battery Life (Hours) 200

Maximum Supply (Volts DC) 18

INSTALLATION INFORMATION

EMG MODEL: EXB

(ACTIVE/PASSIVE PICKUP INPUTS)

Warranty

All EMG Pickups and accessories are warranted for a period of two years. This warranty does not cover failure due to improper installation, abuse or damage. If

upon examination the pickup is determined to be defective, a replacement will be made. Warranty replacement products are covered by this same warranty. This

PO BOX 4394

SANTA ROSA, CA

95402 USA

P (707) 525-9941

F (707) 575-7046

EMGPICKUPS.COM

0230-0165rC

Frequency Response:

EMG-EXB

1.325

.400 .309 (8mm P .75)

GENERAL OPERATION:

The EXB is an active EQ circuit for bass guitar that simultaneously increases both low and high frequencies while decreasing mid-range.

The graph below illustrates the effect of the EXB. The thick black line displays the effect with the control all the way up (clockwise).

The flat black line illustrates the effect with the control all the way down (counter-clockwise) in the bypass mode. The EXB is continuously

variable from flat to maximum effect. The EXB is wired in series with the signal path, so there is an input and output.

The EXB has buffered inputs and can be used with passive pickups.

Connector for EMG Active Tone controls

and accessories.

Pin 1 Input

Pin 2 Ground for Input

Pin 3 Ground for Output

Pin 4 Output

Pin 5 V+ Supply

1 2 3 4 5

INCLUDED:

1 EXB Control

1 Battery Clip with Buss Connector

1 Stereo Output Jack (Battery Switching)

2 Interconnect cables

10 dB/div

EXB

- 9V +

NECK

VOLUME

OUTPUT

OUTPUT CABLE

BRIDGE

VOLUME

NOTE REVERSED

CONNECTOR!

BATTERY

BUSS

BRIDGE PICKUP

NECK PICKUP

EXB

CONTROL

Diagram #4

Volume / Volume

EXB Control

VOLUME

B122rH

TONE

B124rH

VOLUME

B122rH

VOLUME

B122rH

VOLUME

B122rH

MASTER

TONE

Diagram #1

Like all EMG Accessory products the EXB uses the 5-pin header as a standard.

Diagram #1 to the right shows how the plug-in connectors are installed.

Be sure to reverse the input connector as shown.

Since there are a variety of installations in which the EXB can be installed it

is impossible to show every installation in this data sheet. Some of the simpler

installations have been chosen. More diagrams are available at our website

http://www.emgpickups.com.

Diagrams #2 and #3 illustrate installations that have a single pickup and

do not use a selection switch.

Keep in mind that all of the EMG Accessory controls can be substituted for one

another since they all have buffered inputs and utilize the same 5-pin connnector.

So, if you decide you would rather use the BTC instead of the EXB, simply unplug

the EXB and replace it with the BTC.

Installation Instructions:

EMG Model: EXB

EXB Page 2

Note: Reversed connector! Pins 1 and 2 are reversed.

Make sure the connectors are plugged on as shown.

All of the EMG Active controls use the same 5-pin connector

shown below.

Diagram #2

One Pickup

One Volume

One EXB

OUTPUT

FROM PICKUP

BATTERY

NEG (-)

RED

BATTERY

BUSS

OUTPUT CABLE

MASTER

VOLUME

- 9V +

EXB Control

RED

MASTER TONE

(PASSIVE)

Diagram #3

One Pickup

One Volume

One Master Tone (Passive)

One EXB

OUTPUT

FROM PICKUP

BATTERY

NEG (-)

RED

BATTERY

BUSS

OUTPUT CABLE

- 9V +

EXB Control

RED

NOTE:

REVERSED CONNECTOR

NOTE:

REVERSED CONNECTOR

MASTER

VOLUME

B122rH

Diagram #5

2 Pickups

Toggle Style Select Switch

EXB Control

Master Volume

VOLUME

B122rH

VOLUME

B122rH

BRIDGE PICKUP

NECK PICKUP

BATTERY

NEG (-)

MASTER

VOLUME T

OUTPUT CABLE

RED

GROUND

BRIDGE P/U

NECK P/U

OUTPUT

- 9V +

RED

GROUND

BRIDGE P/U

NECK P/U

OUTPUT

2 Pickup Guitars using a selection switch:

Diagrams #5 and #6 show the pickups connected to the B245 Pickup Buss.

To learn more about the B245 Pickup Buss, be sure to go to

http://www.emgpickups.com. More diagrams are available at the EMG website.

The EXB or any EMG Active Tone Control is shown following the pickup buss

and then to the output jack. A master volume could easily follow the EXB

before the output jack.

EXB Page 3

OUTPUT

NK VOLUME

NECK PICKUP

BRIDGE PICKUP

BR VOLUME

BATTERY

NEG (-)

Diagram #6

2 Pickups

Toggle Style Switch

Volume each Pickup (Volumes are independent)

EXB Control

OUTPUT CABLE

NOTE:

REVERSED CONNECTOR

- 9V +

EXB

CONTROL

NOTE:

REVERSED CONNECTOR

EXB

CONTROL

RED WIRES

FROM PICKUPS

MASTER

VOLUME OUTPUT

BATTERY

NEG (-) BLACK

B118

ACTIVE BALANCE

CONTROL ACTIVE TONE

(VLPF)

9V+ POWER BUSS

NOTE REVERSED CONNECTORS

This diagram illustrates an installation using the X Series pickups from EMG

that have an active Tone control. The controls are wired in the above order with

the master Volume control last in the circuit. If you are using

the Active Balance Control remember that a passive Tone control will not

function when it comes after the ABC Control. If you want a standard tone

control the VLPF will be required.

RED

EMG Active Neck Pickup

(Upper 3 pin header)

EMG Active Bridge Pickup

(Lower 3 pin header)

EXB

CONTROL

BOTTOM

VIEW

- 9V +

VOLUME

B122rH

VOLUME

B122rH

RED

GROUND

BRIDGE P/U

NECK P/U

OUTPUT

VOLUME

B122rH

RED

EXB Page 4

Diagram #7

2 Pickups

Toggle Style Switch

Volume each Pickup (Volumes are independent)

EXB Control

Master Active Tone (VLPF)

Diagram #8

2 Pickups

ABC Control

Active Tone (VLPF)

EXB Control

Master Volume Control

Output Jack

OUTPUT

NK VOLUME

NECK PICKUP

BRIDGE PICKUP

BR VOLUME

BATTERY

NEG (-)

OUTPUT CABLE

NOTE:

REVERSED CONNECTORS

- 9V +

ACTIVE TONE

(VLPF)

EXB

CONTROL

Beliebte Zubehör für Musikinstrumente Handbücher anderer Marken

Behringer

Behringer AIRPLAY GUITAR AG10 Bedienungsanleitung

FEURICH

FEURICH BASIC Bedienungsanleitung

thomann

thomann Harley Benton JA Bedienungsanleitung

NeoTech

NeoTech PAD-IT TUBA HARNESS Bedienungsanleitung

Duncan

Duncan SH-8n Invader Kurzanleitung

Palmer

Palmer The Junction PDI-09 Bedienungsanleitung

GuitarPCB

GuitarPCB Fuzzy Bee v2 Handbuch

Yamaha

Yamaha Tough-Terrain T-335 Bedienungsanleitung

LEWISMIDI

LEWISMIDI CZ Patch Library Bedienungsanleitung

Free The Tone

Free The Tone LB-2 Bedienungsanleitung

Duncan

Duncan Apollo Jazz Bass - neck Handbuch

dbx

dbx dB10 Bedienungsanleitung

TLA

TLA Tuning-Set CTS-32-C Bedienungsanleitung

Solo Music Gear

Solo Music Gear JEK-1 Bedienungsanleitung

Duncan

Duncan HyperSwitch Bedienungsanleitung

CNC Design

CNC Design QUAD COIL WINDER MK2 Bedienungsanleitung

FuzzDog

FuzzDog 3PDT Bedienungsanleitung

Hipshot

Hipshot Universal Mounting Plate Bedienungsanleitung